Mullen S-10, D-10, S-11, D-11, S-12 Owner's Manual

Mullen Guitar Co., Inc.

Owner’s Manual

G2 &

Royal Precision

Pre-Royal
Discovery

Covers Models

S-10, D-10, S-11, D-11, S-12, D-12

Mullen Guitar Co., Inc.

11906 County Rd. MM

Flagler, CO 80815

Ph. 970-664-2518
Fax. [phone]

www.mullenguitars.com

E-mail [e-mail]

2

Assembly & Setup 4-6

Tuning your Guitar

· Tuning Open Strings

· Tuning Tunable Splits

· Tuning the Half Stop

7-11
7
8-10
11

Adjusting Your Guitar

· Pedal Stop

· Pedal Height

· Knee Lever Travel

· Knee Lever Tilt

· Changer Return Springs

13-14
13

13
14
14

Care and Maintenance

· Lubrication

· Notes

12
15
16

Changing Strings

· Winding Strings

· Factory String Gauges

18

19

Personalized Tuning chart
Wiring Diagram

17

3

Your Name

Guitar Model

Address

Special Notes

4

First, start by screwing legs into leg holes. You may

want to develop your own method for marking

which legs you put where, and installing them the

same each time. Screw legs in tight, do not use any

tools for installing legs.

Then, secure the pedal bar to the front legs. Slide
retaining bracket over leg, then tighten wing nut.

5

Insert Pedal Rod through hole in pedal linkage.
Pedal rods are numbered for your convenience.

Slide Disconnect outer sleeve down and attach to ball

joint, then release the outer sleeve.

6

Removing Guitar from case.

Hold guitar firmly with left hand on the rear changer end leg,

and the right hand on the front key head end leg. Make sure
properly position yourself as not to cause any strain on your

back. Then pull the guitar upward and bring guitar towards

you and rotate legs forward to the upright position.

Reverse operation for setting guitar into case.