Mulholland MOVITA JUNIOR User Manual
Movita
User manual
These operating instructions contain information, settings, safety precautions, which are to be considered with the use of Movita
junior, as well as other important data.
Movita
junior are walking aids for children starting with age 7 and for adult body size from approx. 120 cm to 200 cm.
Movita
is directed mainly towards walk-obstructed people who, without support, cannot keep themselves upright.
Movita
can be adapted
gives the user security. The pelvic support holds the child on the seat, and the handle gives a relieved support for the arms. The
thoracic support
can be used indoors and outdoors, thanks to the large wheels.
Start-up
Movita
junior will be delivered in two parts: the underframe with wheels and brakes and the upper section with seat and thoracic
support. Under the seat a hexagonal wrench is located (fig. 2).
Assembling upper section and underframe
Upper section needs to be put on top of the underframe.
Basic model adjustment
Height of t
For height adjustment of the thoracic support, loosen the two bottom handles (fig. 3). Once the desired height has been reached, the
handles need to be tightened whereby the same height can be adjusted on both sides with the he
The seat height can be adjusted by loosening both upper handles (fig. 4). Once the desired height has been achieved both handles
need to be tightened, whereby with the help of the height framework the exact height can be adjusted.
he thoracic support and seat
individually to the needs of the user. The thoracic support holds the upper body in an upright position and
and the pelvic support can be opened with a simple motion, thus makes the transfer particularly easy.
Movita
junior are not to be used on diagonal and uneven gro
junior
und.
Movita
junior
lp of the height framework.
Thoracic support
The thoracic support can be opened or closed through lightly raising or down-pressing the padded pipe (fig. 6).
Springs
The two springs in the lower pipes can be exchanged, if a harder or softer suspension is needed (fig. 5). The spring
four different levels of stiffness, which are appropriate for the following body weights 20 kg - 40 kg -60 kg -80 kg.
Seat
The seat can be pushed back and forward. Loosen the large screw under the seat attachment pipe (fig. 6). If the desired position is
found the screw needs again to be tightened. In addition also the angle of the seat can be adjusted again by loosening the two
internal hexagonal screws under the seat (fig. 6). After adjusting, the screws are tightened again.
s are available in
Manufacturer: elmi GmbH - Handwerkerzone 25 - I-39052 Kaltern - Tel 0471 961002 - FAX 0471 96
www.movita.it
2374
elmisrl@tin.it
-
-2-
Movita
User manual
Pelvic support
The pelvic support behind the seat can be lifted or pushed down; whereby an internal hexagonal screw becomes visible. If the screw
is loosened the pelvic support can be pushed backwards or forwards (fig. 7). After adjust
Handle
The handle is fastened to both sides by an aluminum part to the framework. The height and the length of the handle can be adjusted
by opening the two internal hexagonal screws. After adjusting, the screws are tight
Safety precautions
Warning: Never leave the user of
CE- tested brand:
Technical data
length
width
seat height
thoracic support height (side)
thoracic support, per
wheels dimension front
wheels dimension rear
load in relation to shock absorbers
frame
wheels
thoracic support and handle
seat
Movita
Movita
junior without supervision.
junior is provided with a CE-marking.
Movita
86 cm
69 cm
46-
67 cm
76-97 cm
70/90/105/
140x30 mm
400 x 40 mm
20 kg / 40 kg / 60 kg / 80 kg
stainless steel
full rubber, suitable for indoor and outdoor use
covered with soft and anallergic rubber
anatomic
imeter
junior
junior
tubular frame, powder coated
ened again.
ing, the screw is tightened again.
Abb. 11
Manufacturer: elmi GmbH - Handwerkerzone 25 - I-39052 Kaltern - Tel 0471 961002 - FAX 0471 96
www.movita.it
2374
elmisrl@tin.it
-
Loading...