Mulholland MOVITA CHILD User Manual

Movita

These operating instructions contain information, settings, safety precautions, which are to be considered with the
use of Movita child I and child II, as well as other important data. Movita child I and child II are n
diagonal and uneven ground.

Movita child I and child II are walking aids for children of 1-11/2 years to 8 years. Movita is directed mainly towards
walk-obstructed people who, without support, cannot keep themselves upright.

Movita can be
position and gives the user security. The pelvic support holds the child on the seat, and the handle gives a relieved
support for the arms. The thoracic s
transfer particularly easy. Movita child I and child II can be used indoors and outdoors, thanks to the large wheels.

Start-up
Movita child I and child II are assembled compl
(fig. 2).

Basic model adjustment
Height of the thoracic support and seat

For height adjustment of the thoracic support, loosen the two bottom handles (fig. 4). Once the desired height has
been reached, the handles need to be tightened whereby the same height can be adjusted on both sides with the
help of the height framework.

adapted individually to the needs of a child. The thoracic support holds the upper body in an upright

upport and the pelvic support can be opened with a simple motion, this makes the

child I - child II

User manual

etely when delivered. Under the seat a hexagonal wrench is located

ot to be used on

The seat height can be adjusted by loosening both upper handles (fig. 4). Once the desired height has been
achieved,
adjusted.

Thoracic support

The thoracic support can be opened or closed through lightly raising or pressing down on the padded pipe (

Springs

The two springs in the lower pipes can be exchanged, if a harder or softer suspension is needed (fig. 5). The springs
are available in four different levels of stiffness, which are appropriate for the following body weights 10 kg ­20 kg -25 kg. To exchange the springs, the front handle will first need to be unscrewed from the pipes on both sides
(fig. 7). Then the front handle is swiveled forward and the entire upper section is lifted from the stand (fig. 8). The
underframe is plac
upper section can be inserted again into the pipes.

Seat

The seat can be pushed backwards and forwards. Loosen the large screw under the seat attachment pipe (fig. 10).
When the desired position is found the screw needs to be tightened again. In addition, the angle of the seat can be
adjusted by loosening the two internal hexagonal screws under the seat (fig. 10). After adjusting, the screws are
tightened again

both handles need to be tightened, whereby with the help of the height framework the exact height can be

ed upside down, thus the springs can fall out (fig. 9). After the new springs are introduced, the

.

fig. 6).

15 kg

-

Manufacturer: elmi GmbH - Handwer
[e-mail] - www.movita.it

kerzone 25 - I-39052 Kaltern - Tel [phone] - FAX [phone]

-2-

Movita

Pelvic support

The pelvic support behind the seat can be lifted or pushed down, whereby an internal hexagonal screw
becomes visible. If the screw is loosened the pelvic support can be pushed back or forward (fig. 11). After
adjusting, the screw is tightened again.

Handle

The handle is fastened to both sides by an aluminum part to the framework. The height and the length of the handle
can be adjusted by opening both internal hexagonal screws.

Safety precautions

Warni

ng: Never leave the user of

CE- tested brand: Movita child I and child II are provided with a CE-marking.

Technical data

length
width
seat height
thoracic support height (side)
thora

cic support, perimeter
wheels dimension front
wheels dimension rear
load in relation to shock absorbers
frame
wheels
thoracic support and handle
seat

Movita

child I and child II without supervision.

child I

72

64.50

21
54 - 70.50 cm
70/90 cm
140x30 mm
250 x 50 mm
10kg/15kg/20kg/25kg
stainless stee
full rubber, suitable for indoor and outdoor use
covered with soft and anallergic rubber
anatomic

child l-child

User manual

cm

cm

-41.80 cm

l tubular frame, powder coated

child II

72cm

64.50cm

27-61

69.50 - 84.50

70/90 cm
140x30 mm
250 x 50 mm
10kg/15kg/20kg/25kg

cm

cm

Manufacturer: elmi GmbH - Handwer
[e-mail] - www.movita.it

kerzone 25 - I-39052 Kaltern - Tel [phone] - FAX [phone]