MUKii TransImp TIP-PU301 User Manual

User’s Manual

/

使用手冊

www.mukii.com.tw

Model : TIP-PU301

All Registered Trademarks Belong To Their Respective Companies

Copyright © 2010 MUKii Technology INC. All Rights Reserved.

2 Ports US B 3.0 PCI-e Host Card

PACKAGE INCLUDES ...............................................................................................1

SPECIFICATIONS ......................................................................................................1

INSTALLATION ...........................................................................................................2

DRIVER INSTALLATION ............................................................................................4

WARRANTY ...............................................................................................................7

包裝內附 .....................................................................................................................8

產品規格 .....................................................................................................................8

硬體安裝 .....................................................................................................................9

軟體安裝 .....................................................................................................................11

保固說明事項 ..............................................................................................................14

TABLE OF CONTENTS

目錄

2 Ports USB 3.0 PCI-e Host Card

1

PACKAGE INCLUDES

SPECIFICATIONS

TransImp 2-Port PCI-E

Host Card x 1

CD-Rom Driver x 1

Low Profile Bracket x 1 User’s Manual x 1

2 Ports USB 3.0 PCI-e Host Card

■ Model : TIP-PU301

■ USB Port : 2 x USB 3.0 Type A

(Backward Compatible With USB 2.0 & 1.1)

■ Transfer Rate : Ultra-Fast Transfer Rates-up to 5 Gbps/USB 3.0

Transfer Rates-up to 480 Mbps /USB 2.0

■ Power Source : 4 Pin Power Connector

■ Output : +5V / 900mA (each port)

■ Dimensions : 120 x 81 x 19mm

■ System Support : Microsoft Windows XP / Vista(32/64bit) / 7(32/64bit)

USB 3.0 Port 1

USB 3.0 Port 2

®

2

INSTALLATION

1. Turn off your computer and disconnect all external
peripheral devices and cables, i.e. power cord,
network cable, monitor, etc.

2. Remove your computer’s cover. For most standard
PC’s, there are screws that will need to be
unseated before you can remove the computer’s
cover, and these screws are usually located at the
rear of the computer, along the edge of the cover.
However, placement of these screws and cover
attachment may vary by manufacturer, so please
refer to your computer system’s manual for
specific details.

3. Once you have removed the cover, you will need
to locate the PCIe slots on the motherboard. The
PCIe slots are generally located in the back of the
computer, with the slots built into the side-wall of
the computer ( please refer to your computer
system’s manual for the exact location of your
PCIe slots or refer to the diagram in this page. If
necessary, you may need to remove the expansion
slot cover, and you may also need to remove any
add-in boards which may block the access to the
PCIe slots. (2-Port PCI-e SuperSpeed USB 3.0
Host Card will fit and work with any PCI Express
slot whether it be a x1, x4, x8, x16 slot.
Performance may vary with each slot.)

2 Ports USB 3.0 PCI-e Host Card

3

INSTALLATION

4. Take the TransImp 2 Ports USB 3.0 PCI-E Host
Card out of its anti-static bag and push the card
into the empty PCIe card slot. The card should be
mounted with the circuitry facing down. This is the
only way to mount the card, so if you are having
problems inserting the card into the PCIe slot,
make sure that it is oriented correctly. Be sure that
the gold contact pins of the PCIe card are seated
completely inside your computer’s PCIe slot. Be
aware that it may take some force to get the card
fully seated in the slot.

5. Once the PCI card is seated correctly, tighten
with a screw.

6. Connect 4-pin power to the power connector

7. Now you are ready to put the computer’s cover
back on and reconnect all of your external
peripheral devices and cables.

2 Ports USB 3.0 PCI-e Host Card