Muji PP Series Manual

Note: Retain this manual for reference

Polypropylene Storage Rack Manual

Precautions for use

• Use the product correctly based on a thorough reading of the

manual.

• Do not use near fire or heat sources such as heaters, kitchen
ranges, electric cooking appliances, or heated pots or kettles. Doing

so may cause discolouration, deformation or deterioration.

• Use in a level, flat place without differences in level, gutters, holes,
unevenness, slopes or the like. The product may be damaged by the
shock of crossing differences in level with the casters attached.

• Do not use in direct sunlight or outdoors. Doing so may cause

discolouration, deformation or deterioration.

• Do not use the product placed on its side.

• Check the overall load capacity and load capacity for one unit before

using. Be aware that exceeding the load capacity may lead to
damage, deformation and accidents.

• It is dangerous if the product falls over, so do not lean against it or

get on it.

• Do not place in the rack valuables, fragile items or items that will
make it unstable.

• For safety, place heavy items in the bottom unit or a centre unit.

Precautions for stacking and attaching parts

• When stacking polypropylene storage rack units, be sure to attach all

the joint parts.

• Joint parts cannot be attached to the tops of Polypropylene, drawer,

wide cases.

• Joint parts are intended to support joining the main units and do not

perfectly secure them.

• When removing joint parts, be careful not to injure your nails or

fingers.

• The rack may tip over if you hang shopping bags or something from
the joint parts or S-shaped hooks.

• Do not move the rack when it still has storage items in it.

• When moving a rack consisting of stacked units, if you lift any unit

other than the bottom one, it may cause joint parts to come off, the

rack to come apart, and damage or injury. When moving a rack
consisting of stacked units, separate the units first and be careful not
to tip the rack over.

• Do not push or pull the rack on a floor that is easy to scratch, such
as flooring. When moving the rack on casters, separate the units first
and be careful not to tip the rack over.

• When cleaning the rack, wipe it with a soft cloth wet with a
water-diluted neutral detergent so as to avoid damaging it.

• When stacking units and attaching parts, be careful not to pinch your

fingers.

• Do not use a hammer or the like when stacking units and attaching

parts.

• To avoid damaging the floor when stacking units and attaching parts,

spread out a cloth or something similar and assemble the product
on a flat surface.

• A right-side-up rack unit cannot be placed atop an upside down unit,

and a drawer-type unit cannot be added to an upside-down unit

(Figs. 1 and 2).

• Do not use casters with an upside-down unit, because it may cause
deformation (Fig. 3).

Ways of combining

The following cannot be combined

Figure 1)

(

Figure 2)

(

4 joint parts

Figure 3)

(

A unit can be used

upside down.

A unit can be combined with drawer

units* of different sizes.

*Polypropylene, Drawer, Wide case series.

Units can be turned upside down

and stacked.

Retain this manual for reference.

Units can be placed right

side up or upside down.

Right side up

Upside down

The units can be stacked.

Identical items
stacked right side

up

Identical items
stacked upside

down

Identical items
stacked in both

right side up and
upside down

A combination of

different items

Compatible parts

Accessory Sold separately

Joint part

* Joint parts, nonslip parts and casters for

Polypropylene cases must be pushed all the way in.

When stacking Polypropylene Storage Rack units, firmly insert

joint parts into the holes on all four corners.

Small nonslip parts for
use with Polypropylene
cases

Casters for Polypropylene
Storage Cases

Stacking height and number of units

Maximum

stacking height

120 cm

Shallow type

13 units

Deep type

6 units

Extra deep

Load capacity (per unit)

Shallow

type

4 units

3 kg,

6.6lbs

Deep

4 kg

8.8lbs

Deep/
Large

5 kg, 11lbs

Maximum height of

120 cm

Overall maximum load capacity

39 kg, 85 lbs

when not using casters

19. 5 kg, 43 lbs when using casters
or stacking upside down

*Also use joint parts when stacking the

Polypropylene, Drawer, Wide case series.

Parts list

Material

One main unit, four joint parts, one manual *Note: Same for each size.

Main unit and joint parts: Polypropylene