Page 1
C1500EX-07 Installation Guide
Chevrolet/GMC 1500/2500 Extended Cab 2007 - UP
(Loaded/Amplied)
STEP 1: STEP 2:
Flip up the driver side rear seat and place the enclosure on
the oor as shown above. The enclosure should be inside
the seat trim when the seat is in the lowered position.
STEP 3:
From the passerger side, attach the second bracket to the
enclosure as shown. Use the same screws from Step 2.
Attach the mounting bracket to the enclosure as shown
using (2) 2" screws to attach the bracket to the oor, and (1)
M6 bolt to attach the bracket to the enclosure.
STEP 4:
Make all nal wire connections (See Page 2) and fold the
seat down. Your installation is complete. Enjoy your new
bass in a small space.
Page 2
C1500EX-07 Installation Guide
Chevrolet/GMC 1500/2500 Extended Cab 2007 - UP
(Loaded/Amplied)
20 Amp Fuse
Red Power Wire
Optional EBC
(Electronic Bass Control)
Black Ground Wire
Attach Ground Wire Directly to
Vehicle Frame After Clearing
Area of Debris and Paint
Speaker Level Wiring
+
_
PWRGNDREM
20A
Source Unit without
RCA Outputs
INPUT
GAINX-OVER
RIGHTLEFT
EBC
STATUS
Right Channel* (+)
Right Channel* (-)
Left Channel* (-)
Left Channel* (+)
*
• Check with your vehicle manufacturer to determine
• wire color for appropriate connection.
• Front or rear speaker channels will work.
• If connecting to a system with an integrated factory
• amplifier, connect to signal BEFORE amplifier.
20 Amp Fuse
Red Power Wire
Black Ground Wire
RCA Interconnect Wiring
+
Optional EBC
(Electronic Bass Control)
Attach Ground Wire Directly to
Vehicle Frame After Clearing
Area of Debris and Paint
_
INPUT
PWRGNDREM
20A
EBC
Source Unit with
RCA Outputs
RCA Interconnects
GAINX-OVER
RIGHTLEFT
STATUS
Blue Turn On Lead
Buy quality subwoofers and boxes in our online store.
Loading...