
1/10 Electric FFV2 Pro Car Kit
Instruction Manual
2 0 1 6
Powered By:

Introducon:
FFV2 Pro is a professional 1:10th front wheel drive car and should be built by aged 14 years or over or that they had experience
building and operang R/C model cars before. This is not a toy intended for use by beginners or by children without any
supervision of a knowledgeable adult. Please read the instrucon manual carefully before building.
Race opt should not be liable for any loss, injury or damages, whether direct, indirect, special, incidental, consequenal, arising
from the use, misuse, abuse of this product or accessories required to operate this product.
Warnings:
◎ This product is not intended for those ages under 14 year without any adult supervision.
◎ Assemble this kit only in places away from the reach of children.
◎ Exercise car when using tools and sharp instrument and take care some parts that may have sharp edges when building.
◎ Please do not touch any electronic equipment on the model such as motor and speed controller that having higher
temperatures after the operaon. Otherwise, it may burn yourself seriously by touching them. Beer to allow 10~15
minutes to let any electronic equipment cool down.
◎ Please complete a successful pre-run check of your radio equipment and model before the run. Make sure to keep the
wheels of the model off the ground when checking the operaon of the radio equipment.
◎ When on the model, please always turn on the transmier before turn on the receiver in the car. When off the model,
please always turn off the receiver before turn off the transmier. Otherwise, the model may become uncontrollable and
cause serious damage.
◎ Disconnect the baery pack before storing your model.
◎ Do not get overcharge for the baery or leave baery unaended while charging. Never let children charge the baery
without adult supervision.
◎ Do not operate it on public places, roads or areas where its operaon can conflict with or disrupt pedestrian or vehicular
traffic.
◎ Do not use your model as shown below:
In places where children and people gather In rain, wind snow or darkness condion
In areas where loud noises can disturb others At anyme your line of sight to the model may be
obstructed or impaired in any way
1

Electrical Precautions:
∧Please do not allow any metal part to short circuit the battery or any electronic part using inside the car kit.
∧Never put batteries into fire.
∧Use the recommended charger for the transmitter battery and battery for electronic speed control. Please follow
the charging instructions carefully. Please do not over charge the battery or choose the wrong charging mode. It
becomes dangerous that causes the explosion and lead to the fire. If battery becomes extremely hot during the
charging, please seek the advice from or get replacement from the corresponding battery supplier.
∧Please unplug charger when not in use.
∧W hen not using RC model, please always disconnect and remove the battery.
∧Low battery may result in loss of control. Please stop running the car at once when you find its speed start to
slow down.
∧After use the battery, the battery remains heat and please recharges it after the battery is cool down.
∧Never use damaged wires that are dangerous and cause short circuits and may lead to the fire.
Other Equipment Needed (not included):
Radio transmitter & receiver Battery for transmitter
Electronic speed control Steering Servo
540 Type brushes or brushless motor Pinion Gear (48pitch/64pitch)
190mm body shell 7.4V Nimh or Lipo Battery
Touring Car Tire set Battery charger
Tools Needed (not included):
1.5mm, 2.0mm, 2.5mm allen wrench 5.0mm, 5.5mm, 7.0mm hex socket wrench
Modelers craft knife Turnbuckle wrench
Calipers/Ruler Camber gauge
Instant glue/Thread lock glue Shock and Diff Oil
Thrust, Diff and Joint grease Paint for body shell
Notes: All replacement parts can be found from www.race-opt.com and can be purchased from local
hobby shop. If any further information needed, please email to enquiry@rc-explorer.com.
2

090110
090110
1210 67
1631 30
0172 58
1210 67
0609 02
DETAIL
1282 02
0451 21
0502 10
090110
0435 92
Low- Tra ction
500 cs t
High -Tr action
1000 c st
+ 1.3g
1621 47
1220 06
!
LOCATI ON
Add 1.3g of oi l the diff.
0502 10
1221 27
3

1294 60
RE AR
0614 01
1250 29
0606 15
1240 19
1220 24
1240 33
1270 01
1240 01
1210 58
1240 12
1294 50
FR ON T
INC ORREC T COR RECT
Oi l
1240 16
1240 03
3~ 5
UP & DO WN
1230 31
0400 25
Move the sho ck shaft up and
down a few tim es to release t he
air bubble s trapped ben eath
the piston .
1251 06
1250 43
0193 00
1230 33
Low
Med ium
Hig h
1210 11
1240 02
Alternat e shock
rebound se tting.
1250 01
1250 01
1210 95
1252 24
125117
0173 08
1230 28
0173 06
0173 06
4
1282 32
0173 08
0173 06
125044
017314