MTN ELECTRONICS MTO WN820NM User Manual

300M Wireless-N USB Adaptor

User Manual

REV: V1.0

RECYCLABLE

Certification

FCC CE

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part

15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

To assure continued compliance, any changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate this equipment. (Example- use only shielded interface cables

when connecting to computer or peripheral devices)

FCC Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This

transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.

Caution!

The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this

equipment. Such modifications could void the user authority to operate the equipment.

Package Contents

The following items should be found in your package:

 ► 300M USB Wireless Adapter

 ► Quick Installation Guide

 ► CD-Rom

Make sure that the package contains above items. If any of the above items is missing or damaged, please contact

the store you bought this product from.

FCC ID: ZBXMTO-WN820NM

1. Antennas must be installed to provide 20 cm separation distance from the transmitting antenna to the body of

user during normal operating condition. This device must not be co-located or operating in conjunction with any

other antenna or transmitter.

2. Only those antennas filed under FCC ID:ZBXMTO-WN820NM can be used with this device.

3. When the Minicard is installed in a system where the antenna location is less than 20 cm separation distance to

the body of the user, additional equipment authorization is required.

4. The regulatory label on the final system must include the statement:“Contains FCC ID:ZBXMTO-WN820NM

“.

5. The final system integrator must ensure there is no instruction provided in the user manual or customer

documentation indicating how to install or remove the transmitter module.

6. ZBXMTO-WN820NM must be installed and used in strict accordance with the manufacturer’s instructions as

described in the user documentation that comes with the product. Thisdevice complies with the following radio

frequency and safety standards.