MTD Troy-Bilt TB 360 Fast Start Manual

READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.

PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.

A. Remove the wing nuts and carriage bolts

1

B. Remove T-bolts from

the handle brackets.

securing the upper handle to the lower
handle.

A

2

Pivot the upper
handle upward.

A. Insert the T-bolts removed in Step 1B

through the handle brackets to secure
the handle in place.

B. Secure upper handle

A

B

Premium Drive Control

to lower handle with
wing nuts (on outside)
and carriage bolts
removed Step 1A.

4

B

B

Blade Control Handle

A

5

Starter

Rope Handle

Wing Nuts

A

3

Pull upward
on the handle
until the
holes in lower
handle line up
with the holes
in the handle
bracket.

T-Bolt

Note: Refer to your Operator’s Manual

Note: Refer to your Operator’s Manual

Note: Refer to your Operator’s Manual

for instructions on attaching the grass collector.

for instructions on attaching the grass collector.

for instructions on attaching the grass collector.

IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .

D

B

C

A. Hold the blade control handle against

the premium drive control.

B. Slowly pull starter rope handle from engine and

slip starter rope into the rope guide.

C. Tighten rope guide wing knob.

D. Use clips to secure cables to lower handle.

77 8-132 38B© 2015 12ABD3B

Need Help? Call 1-888-TO-HELP-U

READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.

PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.

6

Pour the entire contents of the oil bottle (supplied)
into the oil fill. Check the oil level using the
dipstick. (Refer to the Operator’s Manual)

7

Oil Fill /

Dipstick

8

Gas Fill

Make sure the spark plug boot is connected to
the spark plug before attempting to start.

9

Fill fuel tank with clean, fresh gasoline. Do not
fill above the base of fuel tank neck.

IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .

Spark Plug Boot

While standing behind the machine, pivot the Blade
Control Handle against the premium drive control.

Grasp the starter rope handle and pull with quick,
full-arm stroke. If the engine does not start after three
pulls, wait a few minutes and repeat.

77 8-132 38B© 2015 12ABD3B

Need Help? Call 1-888-TO-HELP-U