MTD TracPac OEM-190-604 Operator's Manual

Page 1
Operator’s Manual
TracPac
For FastAttach™Compatible Lawn Tractors & Garden Tractors
Model OEM-190-604
MTD PRODUCTS INC. P.O. BOX 368022 CLEVELAND , OHIO 44136-9722
PRINTED IN U.S.A.
FORM NO. 770-10206
(2/98)
Page 2
SECTION 1: TO THE OWNER
The Model 604 TracPac™is designed for use on FastAttach™Compatible Lawn Tractors and Garden Tractors only.
NOTE: References to LEFT and RIGHT indicate the left and right sides of the tractor when facing forward in
the operator’s position. Reference to the FRONT indicates the grille end; to the REAR the drawbar end.
SECTION 2: CONTENTS OF CARTON
Before beginning installation, remove all parts from the carton to make sure everything is present. Carton contents are listed below and shown in Figure 1. Hardware part number are shown in parentheses.
One Plastic Tool Box One Bracket Assembly One hardware pack containing the following:
A: Two Shoulder Bolts (738-1020)
Bracket Assembly
SECTION 3: ASSEMBLY
Warning: Before beginning installation, place the tractor on a firm and level surface. Place the
PTO in the disengaged (OFF) position, stop the tractor engine and set the parking brake.
Plastic Tool Box
Figure 1
B: Two Bell Washers (736-0407) C: Two Flange Lock Nuts (712-0459) D: One Clevis Pin (711-0309) E: One Hairpin Clip (714-0117)
Hardware Pack Contents
A B
C
D E
MOUNTING THE BRACKET ASSEMBLY & TOOL BOX
1. Pivot the seat of the tractor seat forward.
2. Disconnect the battery and remove the battery and battery tray as instructed in your tractor’s Operator’s Manual.
3. Attach the shoulder bolt, bell washer and hex flange nut to the left side of hitch plate as show in Figure 2. Repeat on the right side of the hitch plate.
NOTE: Your tractor may already be equipped with the shoulder bolts installed at the factory.
4. Position the hooked ends of the bracket assembly to the outside of the hitch plate and over the shoulder bolts. Refer to Figure 2.
5. Insert the clevis pin through the aligned holes provided in both the bracket assembly and the hitch plate. Affix with the hairpin clip. Refer to Figure 2.
6. Slide the plastic tool box down onto the bracket assembly.
2
Page 3
Bell Washer
Hex Flange Nut
Bracket Assembly
Shoulder
Bolt
Hitch Plate
SECTION 4: PARTS LIST
Hairpin Clip
Figure 2
15
Clevis Pin
8
2
5
12
11
13
5
6
10
9
4
3
14
1
REF.
NO. PART NO. DESCRIPTION
1 710-3008 Hex Cap Screw, 5/16-18 x .75 2 710-0751 Hex Cap Screw, 1/4-20 x .62 3 711-0309 Clevis Pin 4 712-3004A Hex Flange Lock Nut, 5/16-18 5 712-3027 Hex Flange Lock Nut, 1/4-20 6 712-0459 Hex Flange Lock Nut, 7/16-20 7 714-0117 Internal Cotter Pin, .148 x 3 8 731-2110 Plastic Tool Box
9 735-0271 Bumper, .62 Dia. x .3 10 736-0407 Bell Washer, .45 x 1.0 x .062 11 738-1020 Shoulder Screw, .625 x .5, 7/16-20 12 783-0673 RH Support Bracket 13 783-0764 LH Support Bracket 14 783-0765 Cross Support Bracket 15 783-0777 Tool Box Suppor t Bracket
7
3
Page 4
MANUFACTURER’S
LIMITED
WARRANTY
For TWO YEARS from the date of retail purchase within the United States of America, its possessions and territories, the manufacturer will, at its option, repair or replace, for the original purchaser, free of charge, any part or parts found to be defective in material or workmanship. This warranty covers units which have been operated and maintained in accordance with the operating instructions furnished with the unit, and which have not been subject to misuse, abuse, commercial use, neglect, accident, improper maintenance or alteration.
Normal wear parts or components thereof are subject to separate terms as noted below in the “No Fault Ninety Day Consumer Warranty” clause.
All normal wear part failures will be covered on this product for a period of 90 days regardless of cause. After 90 days, but within the two year period, normal wear parts failures will be covered ONLY IF caused by defects in material or workmanship of OTHER component parts. Normal wear parts are defined as batteries*, belts, blades, blade adapters, grass bags, rider deck wheels, seats, snow thrower skid shoes, shave plates and tires.
How to obtain service: Warranty service is available, with proof of purchase, through your local authorized service dealer. To locate the dealer in your area, please check the yellow pages or contact the Customer Support Department of the manufacturer, P. O. Box 368022, Cleveland, Ohio 44136-9722. Phone 1-330-273-4683. The return of a complete unit will not be accepted by the factory unless prior written permission has been extended by the service department of the manufacturer.
Transportation charges: Transportation charges for the movement of any power equipment unit or attachment are the responsibility of the purchaser.
Units exported out of the United States: The manufacturer does not extend any warranty for products sold or exported outside of the United
States of America, its possessions and territories, except those sold through the manufacturer’s authorized channels of export distribution.
Other Warranties:
1. The engine or component parts thereof carry separate warranties from their manufacturers. Please refer to the applicable manufacturer’s warranty on these items.
2. *Batteries are covered by a 90-day replacement warranty.
3. Log splitter pumps, valves and cylinders or component parts thereof are covered by a one year warranty.
4. All other warranties, express or implied, including any implied warranty of merchantability or fitness for a particular purpose, are hereby expressly disclaimed in their entirety.
5. The provisions as set forth in this warranty provide the sole and exclusive remedy of the manufacturer’s obligations arising from the sales of its products. The manufacturer will not be liable for incidental or consequential loss or damage.
How state law relates to this warranty: This limited warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Certain disclaimers are not allowed in some states and therefore they may not apply to you under all circumstances.
NOTE: This warranty does not cover routine maintenance items such as lubricants, filters, blade sharpening and tune-ups, or adjustments such as brake adjustments, clutch adjustments or deck adjustments. Nor does this warranty cover normal deterioration of the exterior finish due to use or exposure.
Loading...