MSTRONIC PSE-SW5G2TB0HM, PSE-SW5G2280HM User Manual

USER’S MANUAL

MSTRONIC CO., LTD.

PSE-SW5G2TB0HM

5 Port PoE Switch

Combo 56V+24V output

User’s Manual PSE-SW5G2TB0HM

MSTRONIC CO., LTD.

2

1. General Information

The 24VDC input PoE (Power Over Ethernet) Switch provide five 10M/100M/1000M TX ports,

two with standard 802.3at PSE function, one with 56V 60W passive PoE function and two with

24V 24W PoE PSE function, the model deliver both of Ethernet data and DC power through the

traditional UTP or STP cable.

2. Hardware Description

*LED Indicator

There are 12 LEDs on the PoE switch to indicate the status of power and signal. The following

section describes the functions of each LED indicator.

Front panel detail

*POWER LED

LED STATUS Description

Power

Green LED ON when DC power input has valid power

supplied.

Red LED ON when the following warning happens.

*24V power output under voltage (Vout<16V)

*24V power output over voltage (Vout>33V)

*24V PoE over current (1.25A/per port)

*56V passive PoE output alarm

Off No power supplied.

User’s Manual PSE-SW5G2TB0HM

MSTRONIC CO., LTD.

3

*SWITCH LED (the right indicator on RJ45)

LED STATUS Description

P1~P5

Link/Act

Green

A network device is detected (1000Mbps), but no

communication activity is detected.

Green

Blinking

This port is transmitting to, or receiving package from

another device at 1000Mbps.

Yellow A network device is detected (10Mbps or 100Mbps),

but no communication activity is detected.

Yellow

Blinking

This port is transmitting to, or receiving

package from another device at 10Mbps or 100Mbps.

Off No device is detected.

*PoE LED (the left indicator on RJ45)

P1~P2

802.3at PoE

Yellow A valid Powered Device (PD) is detected and

delivering power on this port.

Off No PD is detected on this port.

P3

56V PoE

Yellow 56V power output

Off No power output

P4~P5

24V PoE

Yellow 24V power output

Off No power output

*Power wiring

For PoE operation, make sure your power supply may offer at least 200W for PoE port.

Total power of PoE is 35W x2 (802.3at), 60W x1 (56V/1.07A) and 24W x2 (24V/1A).

Please note green connector is capable of 12A max. If more current is required, use 4 pin DIN

connector for up to 15A.