Published in Sydney by: Mine Site Technologies Pty Ltd
ABN: 93 002 961 953 ACN: 002 961 953
Global Head Office: Level 5, 113 Wicks Road, North Ryde, NSW 2141 Australia
Telephone: +61 (0)2 9491 6500
This publication is Copyright. Other than for the purposes of and subject to the conditions
prescribed under the Copyright Act 1968 (as amended), no part of it may in any form or by any
means be reproduced, stored in a retrieval system or transmitted without prior written
permission of the copyright owner. Enquiries should be addressed to Mine Site Technologies
Pty Ltd.
Warning
Unauthorised reproduction of, alteration of contents, or distribution to third parties, in whole or in
part is an infringement of copyright. Mine Site Technologies Pty Ltd will actively pursue any
breach of its copyright.
Disclaimer
Information contained in this document has been developed by Mine Site Technologies Pty Ltd
(MST). Every care has been taken by the staff of MST to ensure the content of this manual is
relevant and up to date at the time of publication. Content is subject to change without notice.
Technical updates as associated with this manual will be supplied to the customer at MST’s
earliest convenience.
This manual is published and distributed on the basis that the publisher is not responsible for
the results of any actions taken by users of the information contained in this manual. MST does
not accept responsibility for errors or damages resulting from misrepresentation,
misinterpretation or deviation from instructions by any person regarding the information
contained in this manual. The information is supplied on the condition that the recipient will
make their own determination as to the suitability of the information for their purposes prior to
use.
No user replaceable parts. Products need to be installed and used by professionals,
disassembly only by professionals. Attempting to open the unit without the proper tools will
damage the ingression seal.
Warning:Exposure to Radio Frequency Energy.
The radiated power output of the radio module is below the RF exposure limits for uncontrolled
exposure. This device should be operated with a minimum distance of at least 20 cm between
the antenna and a person’s body.
Caution: Battery replacement.
RISK OF EXPLOSION IF BATTERY IS REPACED BY AN INCORRECT TYPE
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
Please take attention that changes or modification not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
This equipment should be installed and operated with minimum distance 20cm between the
radiator & your body.
ISEDC Compliance
This device complies with Innovation, Science, and Economic Development 7 Canada licenceexempt RSS standard(s). Operation is subject to the following two conditions: (1) This device
may not cause interference, and (2) This device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d' Innovation, Science et Développement
economique Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
The antenna(s) used for this transmitter must be installed to provide a separation distance of at
least 20cm from all persons and must not be collocated or operating in conjunction with any
other antenna or transmitter, End-Users must be provided with transmitter operation conditions
for satisfying RF exposure compliance.
Cet émetteur ne doit pas tre Co-placé ou ne fonctionnant en même temps qu'aucune autre
antenne ou émetteur. Cet équipement devrait être installé et actionné avec une distance
minimum de 20 centimètres entre le radiateur et votre corps.
Authorized CE representative in the EU for EMC compliance
HASO S.C. ul. Towarowa 20, 43-100 Tychy, Poland
Loading...
+ 19 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.