MS Sedco MICRO, WALK Users Manual

MicroStar blue Motion and Presence Sensor Installation Instructions

FCC Compliance

This device complies with part 15 of the FCC Rules Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.

FCC Warning Statement

Changes or modifications not expressly approved by MS Sedco could void the user's
authority to operate the equipment.

Product Description

The microStar blue is the combination motion and presence sensor that provides superior
activation and safety for automatic sliding doors in a single device. The microStar blue
uses patented microwave technology to create two seamless zones within its detection
pattern. The activation zone provides selectable unidirectional or bidirectional motion
detection. The safety zone provides contiguous presence detection at the threshold and
through it when the door is open. The microStar blue’s proprietary software will learn the
movement of the door and then ignore it when opening and closing thus allowing the
safety zone to provide protection through the threshold area of the door. Two relay
outputs are standard. Relay output #1 is for the activation (motion) zone and Relay
output #2 is for the threshold safety (presence) zone.

Insert sensor component pictures here

Installation Preparation

Prior to installing this sensor verify you have the correct version microStar for the
type of door it is being installed on. Match the color-coded microStar logo on the
sensor cover to Chart A below.

(A) microStar Applications Chart

Sliding Folding Swinging Revolving
Doors Doors Doors Doors
microStar red X-safety
microStar white X-approach X-approach
microStar blue X-approach/safety
microStar green X-approach/safety

Warning w/symbol: Remember to follow these safety precautions:

• Shut off power to the automatic door before wiring sensor.

• Always ensure wiring is located clear of any moving door parts to avoid

damage.

• Always be aware of pedestrian traffic. Keep p eople clear of the work area
when setting up or testing the door.

• Comply with all applicable building codes and safety standards (ANSI
A156.10).

Sensor Mounting:

1. Remove the cover of the microStar by placing the blade of a small screwdriver in
the notch in the right side of the cover as shown (B). Once the sensor is attached
to the header always remove the cover in this same manner.

(B) Cover Removal Diagram

2. Attach the mounting template as shown (C) flush with the bottom edge of the
header. Drill 3 holes noted on template (1 wire passage hole, 2 screw pilot holes)

(C) Mounting Template Diagram

3. Insert mounting screws partially into holes. Route the wire harness along sensor
backplate as shown (D). Feed the stripped end of the wire harness through the
wire passage hole. Install the microStar onto the mounting screws and tighten.

(D) Wire Harness Diagram

Sensor Wiring:

With power OFF, connect sensor wiring to the operator control as shown (E). Two

wiring options are available. The activation relay output and safety relay output wires
of the microStar can be connected to the activation input of the operator control
(safety will be on at all times) OR the microStar’s activation relay output can be
connected to the activation input of the operator control and the microStar’s safety
relay output can connect to the safety input of the operator control (safety will be off
when door is closed).

(E) Wiring Diagrams

Wiring to operator control’s activation input only:

Wiring to operator control’s activation and safety inputs:

Warning w/symbol: DO NOT APPLY POWER TO THE SENSOR!

Sensor Settings and Adjustments:

All settings and adjustments can be made via the microStar main circuit board so there is
no need for costly or confusing proprietary set up devices.