MSpa Camaro User Manual [fr]

FEF

Power off the spa and turn on the spa again to enter into Standby mode (No display at

control panel). When yellow

lights on:

Press “up+ On/Off ” key to

enter into service mode

Error Code

FEF0

Filter system short circuit. Replace the Power Board

FEF1

Filter system open circuit.Check if the filter cable is connected well.

YES

Test if the transformer output is 12V DC Replace the transformer

YES

Test if the filter pump resistance is between 0.5-2 ohm

YES

Replace the filter pump

Replace the power board

Exit Repair Mode, back to “

Standby Mode.”

FEF2

Disassemble the filter pump to see if the impeller is stuck by dirts or other .objects

YES

Clean the filter pump and remove the objects

FEF3

Water pressure switch disconnected. Check if there is enough water in the pool (to reach the min. water line)

YES

Check if water inlet is clean without substance blocking up and outlet cap is installed properly.

YES

Check if the water pressure switch cable is well connected to the power board

YES

Replace the power board

System overcurrent. Replace the filter pump

Fill the pool with enough water between max. & min. water line

Clean the inlet/outlet and tightly screw the outlet cap.

Re-connect the cable fitting

Water Pressure Switch Connection Point

Filter cable connection Point

12VAC

1 2

Filter Pump uninstallation order

12VAC