MSA General Monitors TL105 Instruction Manual

Installation & Maintenance Instructions

M O D E L T L105

Test Lamp For Flame Detection

Supplied by

.com

Call us on [phone] | Email [e-mail]

MODEL TL105

Test Lamp for Flame Detection

The information and technical data disclosed in
this document may be used and disseminated
only for the purposes and to the extent
specifically authorized in writing by General
Monitors.

Instruction Manual 01-18

General Monitors reserves the right to change
published specifications and designs without
prior notice.

MANTL105

Part No. MANTL105
Revision H/01-18

TL105

This page is intentionally left blank.

ii

TL105

NOTE THIS IS YELLOW PAPER

WARNING: Do NOT leave battery uncharged. It will result in permanent

battery damage.

iii

TL105

Page intentionally left blank

iv

TL105

Table of Contents

MODEL TL105 .............................................................................................................................. I

TEST LAMP FOR FLAME DETECTION ....................................................................................... I

ABOUT THIS MANUAL ............................................................................................................ VIII

Format Conventions ............................................................................................................................. viii

Notes, Cautions, and Warnings .............................................................................................. viii

Contacting Customer Support ................................................................................................. viii

1.0INTRODUCTION .................................................................................................................... 9

1.1 Notice ......................................................................................................................................... 9

1.2 Special Warnings ....................................................................................................................... 9

1.3 Description ............................................................................................................................... 10

1.4 Upon Receiving ........................................................................................................................ 10

1.5 Test Lamp Operating Principle ................................................................................................ 11

2.0QUICK START GUIDE ......................................................................................................... 12

3.0TEST LAMP COMPONENTS ............................................................................................... 13

3.1 Lamp Housing Assembly ......................................................................................................... 13

3.2 Microcontroller .......................................................................................................................... 13

3.3 Rotary Switch Setting ............................................................................................................... 13

3.4 Rechargeable Battery .............................................................................................................. 13

3.5 Power Jack ............................................................................................................................... 13

3.6 Push Button .............................................................................................................................. 13

3.7 Aluminum Case and Cap ......................................................................................................... 14

3.8 Battery Charge State Indicator ................................................................................................. 14

4.0USE AND OPERATION ....................................................................................................... 15

5.0TEST LAMP MAINTENANCE AND WARRANTY ............................................................... 18

5.1 Maintenance ............................................................................................................................. 18

5.2 Cleaning the Sapphire Window ................................................................................................ 18

5.3 Recharging the Battery ............................................................................................................ 19

5.4 Obtaining Service ..................................................................................................................... 19

5.5 Warranty ................................................................................................................................... 19

6.0TROUBLESHOOTING GUIDE ............................................................................................. 21

 CUSTOMER SUPPORT ....................................................................................................... 22

7.0 22

7.1 Other Sources for Help ............................................................................................................ 22

8.0APPENDIX ............................................................................................................................ 23

v

TL105

8.1

 Specifications ........................................................................................................................... 23

8.2 Regulatory Agency Approvals .................................................................................................. 23

8.2.1 Regulatory Agencies ................................................................................................... 23

8.2.2 Classification Area and Protection Methods ............................................................... 24

vi

TL105

Table of Figures

Figure 1: TL105 Test Lamp .................................................................................................................................... 9

Figure 2: TL105 Battery Connection ..................................................................................................................... 11

Figure 3: Approximate Distance between TL105 and a Flame Detector ............................................................. 12 

Figure 4: Reflector Mounting in Body ................................................................................................................... 15

Figure 5: Location of Functional Board under Lamp Assembly ........................................................................... 16

Table of Tables

Table 1: Charge State Indicator ............................................................................................................................ 14

Table 2: Detector Test Mode Initiation or/Detector Alarm Trigger with TL105 ..................................................... 17

Table 3: Troubleshooting Table ............................................................................................................................ 21

Table 4: Locations ................................................................................................................................................ 22

vii