MREL STRATACAM Quick Start Manual

QUICK START GUIDE

1 2 3 4

C

A

B

PUSH IN THE
PIN ON EACH
LEG AND
EXTEND THEM
DOWN FULLY
UNTIL THE PINS
POP OUT.

OPEN THE
THREE LEGS TO
THEIR MAXIMUM POSITION.

5 6

OPEN UP THE
CARABINER (A) ON THE
ENCORDER (B) AND
ATTACH THE ENCODER TO
THE HANGING BOLT (C)
UNDERNEATH THE TRIPOD.

7

A

REMOVE THE LOCKING PIN
FROM THE ENCODER.

A

C

B

A: PASS THE CONNECTION END FROM THE

STRATACAM MINI THROUGH THE ENCODER IN
THE DIRECTION SHOWN (B).

C: REINSERT THE LOCKING PIN.

ADD THE OPTIONAL WEIGHT
ON TOP OF TRIPOD.

A: UNSCREW THE CAMERA SHEATH.
B: LOCATE THE CONNECTION END AT THE END OF THE

BOOM ARM ON THE STRATACAM MINI™ AND PASS
THROUGH THE CAMERA SHEATH.

C: CONNECT THE CONNECTION END TO THE CAMERA.
D: SLIDE THE CAMERA SHEATH DOWN TO THE CAMERA

AND SCREW INTO CAMERA.

D

8 9 10 11

B

C

POSITION THE

MOUNTING OF THE

MONITOR AT THE POSITION CIRCLED.

MOUNT THE BOTTOM MOUNTING
BRACKET AND TIGHTEN AS SHOWN.

BE SURE TO NOT OVER TIGHTEN
AS THIS COULD CAUSE DAMAGE.

ATTACH THE
MOUNTING ARM AS
SHOWN, ROTATING
THE MARKED KNOB.

ATTACH THE MONITOR
MOUNT AS SHOWN,
ROTATING THE MARKED
KNOB ONCE AGAIN.

12

13 14

B

A

SLIDE OUT THE COMPONENT MARKED A. PLACE
THE MONITOR (B) AS SHOWN. BE SURE THE
MONITOR IS SECURE IN THE BRACKET.

15

CONNECT THE POWER CABLE FROM
THE MINI BATTERY (OPTIONAL) OR
FROM THE PROVIDED POWER CABLE
TO THE CONTROL BOX

16 17 18

TURN ON THE STRATACAM
MINI™ BY PRESSING THE
POWER BUTTON.

19

CONNECT THE VIDEO WIRE FROM THE
MONITOR TO THE VIDEO WIRE FROM
CONTROL BOX.

TURN ON THE MONITOR BY
PRESSING THE MONITOR
POWER BUTTON.

THE COMPLETE STRATACAM MINI™ OVER A BORE HOLE.

20

CONNECT THE ENCODER CABLE FROM
THE ENCODER ATTACHED TO THE TRIPOD
TO CONTROL BOX.

OPTIONAL: PLACE THE
MONITOR HOOD ON THE
MONITOR.

PLACE THE STRATACAM
MINI™ OVER THE HOLE
YOU WISH TO INSPECT.

21 22

A

TO LOWER THE CAMERA INTO THE
HOLE, HOLD THE REEL HANDLE (A)
AND THEN RELEASE THE BRAKE.

ROTATE THE REEL HANDLE
SLOWLY TO LOWER THE
CAMERA DOWN THE HOLE.