MRC AC, AC-120H, AC-80H, AC-160H, AC-250H User Manual

FEATURES

Normal and soft power control to resolve the cleaning blind spot.

Stainless steel housing, tank and lid, nice looking.

Stamp tank without welding gap for better waterproof.

Cooling fan.

Moisture-proofed PCB.

Industrial grade IC & ultrasonic transducer.

Thank you for purchasing ultrasonic cleaner. Please take the time to read these

operating instructions before using and retain them for future reference.

Failure to follow these instructions may lead to serious personal injury

and damage to property.

Blinking LED light bar display for timer and temperature.

AC-SERIES ULTRASONIC CLEANER

USER MANUAL

INTRODUCTION

Ultrasonic cleaning is based on the cavitation effect
caused by high frequency ultrasonic wave vibration

signal in the fluid. Microscopic bubbles are formed,
and they implode violently causing the cavitation

which create an intense scrubbing action on the

small enough to penetrate microscopic crevices,cleaning

them thoroughly and consistently.Ultrasonic cleaning is

extremely effective at removing dirt and grime which

would normally require tedious manual cleaning by hand.

It has been used to clean a wide variety of instruments and
mechanical parts such as carburetors,returning them

to almost “like new” condition without damage to delicate parts.

surface of the item being cleaned. The bubbles are

PREPARATION:

1、Carefully unpack the cleaner and remove all traces of packing materials

from it. Visually inspect the cleaner for any parts that may have become loose

or damaged during transit.

Contents:

a: Main machine b: Lid c: Power cord

d: Outlet filter e: User manual f: Mesh basket

2、Place the cleaner on a flat, clean surface where the cooling fans will receive

adequate ventilation and ensure all controls are set to off. Also ensure the

drain tap is in the closed position.

3、 Ensure the power lead is securely plugged into the cleaner and that no part

part of the lead is likely to come into contact with moisture.

4、Carefully fill at least 1/2 of the tank with a solvent solution. For demanding

cleaning we recommend a small amount of washing up liquid, this will help

increase the cleaning performance. The cleaner is now ready for use.

1

Attention

While the machine is working normally, ultrasonic and tank syntony

gives a well-proportioned sound, and no shudder on the surface of the

water, yet there is spray made by the tiny bubbles. If there are discontinuous

surges, please add or release a little of washing solution in the tank,

stopping the surges is better for the objects cleaning.

Please read the following very carefully as failure to comply may
invalidate your guarantee.

1) DO NOT run the cleaner continuously for more than 30 minutes at a time, as
doing so can damage the internal components.

2) DO NOT operate the unit without fluid in the tank. Always ensure the fluid is no
higher than the max mark, Always ensure there is a minimum depth of 7cm.

3) DO NOT drop any item into the tank as this may cause damage to the
transducer. Always place the items gently into the tank and use the basket.

4) The more items that you place in your cleaning bath the less efficient it

will clean.It is not advised to overlap items. Always allow plenty of clear

space between the items.

5) Do keep the lid on during use. This will prevent splashes and reduce
evaporation of the fluid.

2

SAFETY PRECAUTIONS

Keep it away from children!

This device is not intended to use by individuals with restricted physical

sensory or metal capacities or those with lack of experience or knowledge,

include children, unless they are supervised by an individual who is responsible

for their safety or have received training in operating the device.