MR EASY-GOLF serie Instructions Manual

BATTERY CHARGER INDUSTRY s.r.l.

via Pietro Nenni 17/19 Colombare di Sirmione (Brescia) Italia - Tel: [phone]

www.moriraddrizzatori.it

INTRODUCTION

Your charger is fully controlled by a microprocessor and is suitable for automatic recharging of gel batteries. For best results and
safety, the user is required to read, follow and keep these instructions carefully. This device is to be used exclusively for rechar­ging gel batteries of the voltage and capacity indicated in the paragraph entitled BATTERY. The manufacturer is not responsible
for any damage due to improper use. This device is designed for use only in environments that are protected from any atmosphe­ric disturbance.

BAT TERY

This charger should be used to charge batteries that have the following characteristics:

• battery type: gel or internal recombination batteries

• rated voltage: see rating data on rectifier (e.g. 24 Volt)

• capacity: the optimum value can be calculated on the basis of rated rectifier current In (see rating plate):

In = 8A capacity will be C = 40 ÷ 65 Ah
In = 5A capacity will be C = 25 ÷ 40 Ah

INSTALLATION

To ensure maximum safety, the installation has to be carried out as indicated by the manufacturer. Installation and any work on
the rectifier must be carried out by qualified technical personnel. Install only after disconnecting the supply cable from the mains
power supply and the output cables from the battery. After unpacking, ascertain that the device is in perfect condition. In case of
doubt, do not use the device and contact the supplier. Install the charger in a protected place; do not install it:

• outdoors or in open sheds;

• in any damp or dusty place or in presence of acids;

• in any place with temperatures below 0 and above 40°C (32 and 104° F);

• in any place that is in any way unsuitable for electronic devices.

Do not obstruct the ventilation apertures and do not cover during operation.

POWER SUPPLY

Ascertain that the rating plate values are compatible with your mains power supply (mono-phase, voltage, frequency, power).
Plug it into a tap that is equipped with protection that complies with standard regulations. If you have to use an extension cable,
contact the manufacturer for correct technical information. The supply cable must be replaced only by qualified personnel.

GENERAL RECOMMENDATIONS

Do not let the battery run down completely. If recharged when only partially discharged, the battery will last longer and the recti­fier will do a better job. Prevent oxidation of the battery contacts. Never disconnect the battery if the rectifier is supplying current
as the break-off spark could ignite the gases produced by the battery. Keep the charging area ventilated.

MAINTENANCE

The rectifier does not require any maintenance. For cleaning the outside, use a damp cloth. Use manufacturer approved spare parts.

INSTRUCTIONS FOR CHARGERS

EASY-GOLF serie

BATTERY CHARGER INDUSTRY s.r.l.

via Pietro Nenni 17/19 Colombare di Sirmione (Brescia) Italia - Tel: [phone]

www.moriraddrizzatori.it

CHARGER USE

ACTION LED NOTES

1. CONNECT THE
INPUT CABLE INTO
THE NET PLUG

IF THE LED DOES’T LIGHT, CHECK THE MAIN POWER
SUPPLY OR THE INTERNAL FUSE

2. CONNECT THE
BATTERY PLUG

ALL THE LED LIT UP FOR 1 SECOND AND START THE
CHARGING PHASE. IF DOES’T HAPPEND CHECK THE
BATTERY (POLARITY, CONNECTIONS, VOLTAGE)

3. THE BATTERY IS
CHARGING

DON’T DISCONNECT THE BATTERY IN THIS PHASE

4. AUTOMATICALLY
STOP CHARGING

FULLY RECHARGED BATTERY .
DISCONNECT THE INPUT CABLE, THE BATTERY PLUG

AND AFTER USE THE VEHICLE.
IF STAY ALL CONNECTED (ALSO FOR MANY DAYS) THE

BATTERY CHARGER HOLD THE CHARGE

ALARM SIGNAL

ANOMALOUS BATTERY VOLTAGE OR INTERNAL
OVERHEATING

ABSENCE OF MAIN
POWER SUPPLY

CHECK MAIN POWER SUPPLY OR INTERNAL FUSE

LED OFF LED ON LED FLASHING

• IF CHARGING HAS TO BE INTERRUPTED, DISCONNECT THE INPUT CABLE AND AFTER THE BATTERY PLUG

• DON’T LEAVE THE INPUT CABLE CONNECTED AFTER DISCONNECTING THE BATTERY

INSTRUCTIONS FOR CHARGERS

EASY-GOLF serie