RPV100
AM/FM Radio
Instruction Manual
www.mpmaneurope.co m
Unwind the FM Antenna wire and extend it to its full length.
SPECIFICATION
Frequency Range
Power S ource
Power C onsumption
Antennas
Speaker
:
AM 530 - 1600 KHz
FM 88 - 108 MHz
AC 230V, 50Hz
:
10W
:
Built-in Ferrite Bar of AM
:
External Antenna for FM
3" Dynami c t ype
:
2
AC Plug
AC Outlet
10.) PVC Handle
11.) Battery Compartment
12.) AC socket
13.) Power Button
3
FM Dial Scale
Volume Control
AM Dial Scale
Tuning Control
AM Button
FM Button
5.)
7.)
8.)
FM Antenna
PHONES Jack
4.)
6.)
9
Speaker
9.)
1
2
3
4
5
6
7
8
10
11
12
13
10.) PVC Handle
11.) Battery Compartment
12.) AC socket
13.) Power Button
3
FM Dial Scale
Volume Control
AM Dial Scale
Tuning Control
AM Button
FM Button
5.)
7.)
8.)
FM Antenna
PHONES Jack
4.)
6.)
9
Speaker
9.)
1
2
3
4
5
6
7
8
10
11
12
13
To turn on the system ‘on’, press the POWER button at back side of the
unit and set the volume to a low level, the tuning dial light comes ‘on’.
Press the function buttons(AM/FM) for desired band, AM or FM.
Rotate the T UNING control to the desired radio station.
Adjust the VOLUME control as desired.
When you have finished listening, press the POWER button again. The
tuning dial light goes ‘off’.
FM - The FM antenna is the rod at the top of the cabinet. If FM receptio n is
unsatisfactory, try adjusting the rod at any direction till the reception is good.
AM - The AM bar antenna is inside the cabinet. If AM reception is
unsatisfactory try repositioning the cabinet slightly unti l t he internal antenna
is pickin g up the strongest signal .
4
Battery Operation
The unit can be operated by DC, you may put 6pcs batteries(UM-2 “C” R14 2#
DC1.5V, not include.) into the battery compartment on the bottom of the cabinet.
The function is the same as that of AC power.
Battery C ompartment
Note: The DC/VOLUME button
can control the DC power turn on or turn off
PHONE J ACK
For private listening connect a n h eadphone (not included) with a 3.5mm plug
to the Phones Jack. The built-in speaker will be automatically disconnected.
You can help protect the environment!
Please remember to respect the local regulations ha nd in the non-working
electrical equipments to an appropriate waste disposal center.
This is certify that RPV100 is in conformity with
Coun cil directive 89/336/EE C(EMC direction)
Applicable standards:
EN55013:2001+A1:2003+A2:2206
EN61000-3-2:2006
EN61000-3-3:2008
EN55020:2007
Coun cil directive 2006/95/E C(LVD-direction)
Applicable standards:
EN6005:2002+A1:2006+A11:2008
For more information ple ase visit our website
Www.mpmaneurope.com
Made in PRC
Loading...