Mpman RPS 800 INSTRUCTION MANUAL

INSTRUCTION MANUAL
DESCRIPTION

1. ANTENNA

2. BAND/OFF SWITCH

3. PHONE JACK

4. TUNING KNOB

5. VOLUME KNOB

6. BATTERY COMPARTMENT

7. POWER OUTLET

8. AUX-IN JACK

9. POWER LIGHT

CONNECTING THE RADIO

THE UNIT CAN USE AC POWER BY PLUGING THE AC CORD INTO THE
POWER OUTLET (7). THE UNIT CAN ALSO USE DC POWER BY USING 4PCS

1.5-VOLT AA SIZE UM3 LR6 BATTERIES INTO THE BATTERY
COMPARTMENT (6).

RADIO OPERATION

SLIDE THE BAND/OFF SWITCH (2) TO AM OR FM POSITION TO TURN ON
THE RADIO AND THE POWER LIGHT (9). SLIDE THE BAND/OFF SWITCH (2)
TO OFF POSITION TO TURN OFF THE RADIO AND LIGHT (9).
SLIDE THE BAND/OFF SWITCH (2) TO AM POSITION TO SELECT AM BAND
(540-1600KHZ) AND ADJUST TUNING KNOB (4) AND VOLUME KNOB (5)
FOR THE DESIRED STATION AND LISTENING LEVEL.
SLIDE THE BAND/OFF SWITH (2) TO FM POSITION TO SELECT FM BAND
(88-108MHZ), PULL OUT THE ANTENNA (1) IN THE LEFT UP CORNER AND
ADJUST TUNING KNOB (4) AND VOLUME KNOB (5) FOR THE DESIRED
STATION AND LISTENING LEVEL.

PHONE JACK

PLUG AN EARPHONE INTO THE PHONE JACK (3) TO CUT OFF TRUMP
SOUND AND ACHIEVE EARPHONE LISTENING .

AUX-IN JACK

THE OUTER PUT-IN CAN BE INSERT ED INTO THE AUX-IN JACK (8) BY
USING AN AUX-IN LINE (NOT INCLUDED) TO CUT OFF THE RADIO
PLA YING AND AMPLIFY THE OUTER SOUND SOURCE FOR PLA YING CD,
MP3 ETC.

NOTED
WHERE THE MAINS PLUG OR AN APPLIANCE COUPLER IS USED AS THE
DISCONNECT DEVICE, THE DISCONNECT DEVICE SHALL REMAIN
READILY OPERABLE.

BACK

FRONT