Mpman CSU382 User Manual

This is to certify that the portable DVD palyer is conformity with

council directive 2004 / 108 / EC(EMC Directive)

Applicable standards

EN55013:2001+A1+A2

EN61000-3-2:2006

EN61000-3-2:2008

EN55020:2007

For more information please visit our website

www.mpmaneurope.com

.2. .3..1.

Index to the Parts and ControlsTable of Contents

Important Safety Instructions

Power Supply CD Operation

.4.

Cares of Disc

.5.

Trouble shooting

TOPVIEW

1. Using AC power

Before connecting the AC power cord, please make sure the power supply is 120V.

Insert one end of the AC power cord into the AC socket on the rear of the unit and

the other end into a standard wall socket.

2. Using batteries

Insert 6 x "C" size batteries (not included) in the battery compartment on the bottom

of the unit by matching the polarities.

The unit will not operate on battery power when the AC power cord is plugged into

the AC socket.

Replace batteries when the power indicator dims, the volume decreases or the sound

distorts.

Use batteries of high quality and check them regularly. Alkaline batteries are

recommended.

Do not mix new batteries with old or used batteries.

Use only batteries of the same brand and type.

Batteries should not be left in the unit if they are exhausted or if the unit is not to be

used for a long period of time as they may leak and damage the unit. Battery leakage

is not covered under the warranty.

You can use headphones with 3.5mm diameter stereo plug and an impedance of 32

Ohms. When the headphones are connected, the speakers are disconnected auto-

matically.

Set the VOLUME to a low level before using headphones and gradually adjust the

volume dial to the comfortable listening level.

Do not play the VOLUME too loud for extended periods of time to avoid any damage

to your hearing.

Handle

CD Door

Handle discs by their outer edges and /or the center spindle holes to prevent

fingerprints and scratches.

Do not bend or press the disc. Do not expose the disc to direct sunlight or heating

sources.

To remove stains or fingerprints from the surface of a disc, use a soft, lint-free,

and dry cloth. Wipe in straight movements from the center of the disc to the

outside. Do not use any chemical products, as they can damage the disc.

Do not write on or attach labels to the surface of the disc.

To minimize exposure to dust and dirt. Replace discs in their cases after use.

Store each disc in its case, out of direct sunlight, high temperature and humidity.

Trouble shooting

Should your player develop a problem, please check below before requesting service.

* Check if the power cord has been properly connected to

the power outlet.

* Be sure to select a sound source.

(CD, AM/FM etc.)

* Unplug the main unit, and then

reconnect it. This allows the unit to reset itself after a

power surge or power interruption.

* Increase the volume.

* Disconnect any headphones.

* No disc. Load a disc.

* Disc has been loaded upside down. Place the disc with

the label side up.

* Disc is damaged or dirty. Clean the disc or try another

one.

* Moisture may be condensed inside the player. Remove

the disc and leave the unit power on for one or two

hours.

* Disc is incorrect type for the player.

*You may be in an area of weak signal coverage.

Symptom Check and Action

System does not

function at all

No sound

CD does

not play

Radio does

not work

.The lightning flash with arrowhead symbol within an equilateral triangle is intended

to alert the user to the presence of uninsulated "dangerous voltage" within the

product's enclosure that may be of sufficient magnitude to constitute risk of electric

shock to persons.

.The exclamation point within an equilateral triangle is intended to alert the user to the

presence of important operating and maintenance (servicing) instructions in the

literature accompanying the product.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

WARNING: SHOCK HAZARD-DO NOT OPEN

AVIS: RISOUE DE CHOC ELECTRIQUE-NE PAS OUVRIR

CSU38

Portable CD Player with AM/FM Stereo Tuner

INSTRUCTION MANUAL

Please read this manual before connection and use.

&2 0

PACT

DIGITAL AU DIO

Page

IMPORTANT SAFETY INSTRUCTIONS

INDEX TO THE PARTS AND CONTROLS.................................................................................1

POWER SUPPLY/CONNECTING TO A HEADPHONE.............................................................2

RADIO OPERATION.....................................................................................................................2

CD OPERATION/USB&STOP MODE..........................................................................................3

CARES OF DISC/SPECIFICATION........................................................................................... ..4

TROUBLE SHOOTING.................................................................................................................5

WARRANTY INFORMATION.....................................................................................................6

Tuning Dial

RIGHT VIEW

BottomView

Battery

Compartment

PLAY/USB/STOP

1. Press the PLAY/USB button once to start playing (Some discs will start playback

automatically). The current playing track number appears on the LCD panel.

2. Press the PLAY/USB button twice to stop playing temporarily during playback.

The current track number is flashing while pausing.

3. Press the PLAY/USB button again to resume normal playback.

4. Press the STOP button to stop playing.

NOTE: To remove disc from CD player, always press STOP and wait for complete stop.

REPEAT mode

1. Press the MODE button once to repeat playing the current track only.

2. Press the MODE button twice to repeat all tracks.(Repeat ALBUM in MP3 mode)

TRACKING mode

1. To go back to the beginning of current track, press the button once.

2. To go back to the previous tracks, press the button repeatedly.

3. To go to the next track, press the button once or repeatedly to play your desired track.

RANDOM PLAY

1. Press the MODE button three times to start playing the disc in a random order.

(Repeat ALL in MP3 mode)

PROGRAM PLAY (IN STOP MODE)

1. Press the PROGRAM button at stop mode.

2. Press the or button to select the desired track number, and then press PROG./RPT

to confirm.

3. Repeat step 2 to set up to 18 tracks.

4. Press the PLAY/USB button to start playing the programmed tracks.

5. To cancel the program play, press the STOP button.

INTRO PLAY

Press MODE button four times for INTRO playback, in which the tracks will be played

several seconds in sequence as a introduction.

(Random playback in MP3 mode)

Radio Operation

Specification

Power Supply: 230V~50Hz

Applicable disc: CD/CD-R MP3 CD+RW

Power Consumption: 9 W

Output Power: 1W x2

Speaker: 8 OHM

Dimensions:

Weight:

RADIO

Frequency Range: AM: 530KHz - 1600KHz

FM: 88MHz - 108MHz

CD Player

Laser Wavelength: 760 ~ 800 nm

Tracking Method: 3-spot error detection/3.86 mm lens

Design and specifications are subject to change without notice.

Connecting to a Headphone

Slide the Function Selector to the USB/CD position and insert a CD disc.

4.To fast backward/fast forward through the disc, press and hold the button.

Program

AC Socket

Volume Dial

LCD Display

Play/USB

Antenna

Band Switch

Stop

Mode

Headphone Jack

Function Selector

USB Port

1. Slide the Function Selector (USB/CD OFF RADIO) switch to radio.

2. Select AM, FM by sliding the Band Selector switch to corresponding position.

3. Tune the desired station by turning the Tuning Control.

4. Adjust the volume with Volume dial as desired.

6. Set the Function Switch to the CD/OFF position to stop radio.

1. Press and hold PLAY/USB for usb playback, the audio tracks stored in USB stick will be

played in sequence automatically.

2. Press and hold PLAY/USB again for CD playback. The LCD will display CD/MP3 playback

screen.

Slide the Function Selector to USB/CD position and insert a USB drive.

3. Press STOP to stop playback. LCD will display total number of tracks and total playback time.

(In MP3 mode, LCD show total number of tracks only)

USB&STOP MODE

FCC NOTICE: This equipment has been tested and found to comply with the limits for a Class B

digital device. Pursuant with the FCC Rules, Part15. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation.

This equipment generates, uses and can radiate radio frequency energy. And if

not installed and used in accordance with the instruction may cause harmful

interference to radio communication.

1 2

(1) Read these instructions:All the safety and operating instructions should be read before

the product is operated.

(2) Keep these instructions: The safety and operating instructions should be retained for

future reference.

(3) Heed all warnings: All warnings on the product and in the operating instructions should

be adhered to.

(4) Follow all instructions: All operating and usage instructions should be followed.

(5) Do not use this apparatus near water: (e.g., near a bath tub, washbowl, kitchen sink,

laundry tub, in wet basements, or near a swimming pool and the like).

(6) Clean only with dry cloth.

(7) Do not block any ventilation openings.Install in accordance with the manufacturer’s

instructions: Slots and openings in the cabinet are provided for ventilation to ensure

reliable operation of the product and to protect it from overheating. These openings should

never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This

product should not be placed in a built-in installation such as a bookcase or rack unless

proper ventilation is provided or the manufacturer instructions have been adhered to

(8) Do not install near any heat sources such as radiators,heat registers,stoves,or other

apparatus (including amplifiers) that produce heat.

(9) Do not defeat the safety purpose of the polarized o rgrounding-type plug. A polarized

plug has two blades with one wider than the other. A grounding type plug has two blades

and a third grounding prong. The wide blade or the third prong are provided you’re your

safety .If the provided plug does not fit you’re your outlet,consult an electrician for

replacement of the obsolete outlet.

(10) Protect the power cord from being walked on or pinched particularly at plugs ,

convenience receptacles, and the point where they exit from the apparatus.

(11) Only use attachments/accessories specified by the manufacturer.

(12) Use only with the cart,stand,tripod,bracket,or table specified by the manufacturer, or

sold with the apparatus .When a cart is used, use caution when moving the cart/apparatus

combination to avoid injury from tip-over.

(13) Unplug this apparatus during lightning storms or when unused for long periods of time.

(14) Refer all servicing to qualified service personnel. Servicing is required when the

apparatus has been damaged in any way, such as power-supply cord or plug is damaged,

liquid has been spilled or objects have fallen into the apparatus,the apparatus has been

exposed to rain or moisture, does not operate normally, or has been dropped.

(15) WARNING：To reduce the risk of fire or electric shock, do not expose this apparatus

to rain or moisture. The apparatus shall not be exposed to dripping or splashing and that

no objects filled with liquids, such as vases, shall be placed on apparatus.

(16) WARNING: The mains plug is used as disconnect device, the disconnect device shall

remain readily operable.

(17) Battery shall not be exposed to excessive heat such as the sunshine, fire or the like.

Danger of explosion if battery is incorrectly replaced. Replace only with the same or

equivalent type.

(18) WARNING: Excessive sound pressure from earphones and headphones can cause

hearing loss.

(19 ) The marking is located on the bottom enclosure.

(21) Do not install this equipment in a confined or building-in space such as a book case or

similar unit, and remain a well ventilation conditions at open site. The ventilation should not

be impeded by covering the ventilation openings with items such as newspaper,

table-cloths, curtains etc.

(21)

Double insulation

This is class II apparatus

ATTENTION

The CD mechanism and the sensitive circuitry may cause interference to a radio tuner

nearby. Do not operate this unit while operationg other radio devices.

This product utilizes invisible laser radiation. Avoid

direct exposure to the beam.

Use of controls, adjustments or procedures not

listed in this manual may result in hazardous

radiation exposure.

Only compact discs identified with this mark can be played by

this player.

CONCERNING COMPACT DISC

This sign indicates that this product may not be disposed of with your

regular household waste. The recycling and separate collection of such

products is your responsibility. Please drop off the above-mentioned

waste at a designated place for recycling waste electronic equipment.

If you do not know where to drop off your waste equipment for recycling.

Please contact your local city office or household waste collection service.