MovinCool 30HU User Manual

Fig. 3

Fig. 2

Fig. 1

Sub Control Box

Compressor Relay

Sub Control Box

Manual P/N: 484007-3700 First Issue: May 2012

Compressor Relay (1)

Screw (2)

M4 × 0.7, L=10

Screws (6)

Screws (2)

Left Rear Panel

Left Front Panel

Screws (4)

Compressor Relay (Part No. 484530-0660)

in the unit immediately after the power is disconnected.

Screws (2)

Power Cord Conduit

1. Inventory

After unpacking, please check to make sure you have the following items. If any of these items were not included in the box or appear damaged, please contact your MovinCool reseller for replacement (See Fig.1).

INSTALLATION MANUAL

For 30HU (Classic 40) - Serial Number: 0401XXXX to 0807XXXX

WARNING: Disconnect power supply from the 30HU (Classic 40) unit before

performing any service. Beware that some residual voltages may remain

2-1. Remove six (6) screws and take off the left rear panel. Loosen two (2) screws fixing the

2-2. Remove all compressor wires (black) and two (2) screws from the compressor relay

in the sub control box. Then take off the compressor relay.

power cord conduit. Then remove four (4) screws and take off the left front panel.

2. Removal of Old Compressor Relay

3-1. Cut out the screen sheet on the last page of this manual (See Fig. 4). Confirm the reference

hole on the sub control box to be matched with the reference hole on the screen sheet.

3-2. Match the screen sheet’s reference hole to the sub control box’s reference hole and position

the screen sheet as shown in Fig.5. Use adhesive to temporarily hold the screen sheet. Mark a center hole position on the sub control box, then remove the screen sheet. Make a center hole (recommended size: Ф 3.1 (Ф 3.2 max.)). Remove all metal dust.

3- 3. Match the compressor relay’s reference hole to the sub control box’s reference hole in the

3- 4. Install the left front panel and left rear panel in the reverse order of the removal steps.

direction shown below (See Fig. 6). Attach the compressor relay with two supplied screws at the torque of 1.3 ± 0.1 ft.lbf (1.8 ± 0.2 N•m). Connect the compressor wires to the compressor relay connectors as shown in the table.

Fig. 4

Fig. 5

Fig. 6

Last page of this manual

Screen Sheet

Reference Hole

Center Hole

Screen Sheet

Compressor Relay

Reference Hole

Center Hole

Top

Reference Hole

Sub Control Box

3. Installation of New Compressor Relay

29.5 mm

29 mm

TOP

Cut

Compressor Wire No. Relay Connector Code

U2 2

TOP

34 mm

52 mm

Screen Sheet

TOP

Cut

Make a center hole.

Ф 3.1 (Ф 3.2 max.)

Reference Hole