Movie Vision MV6000, MV6000C Owner's Manual

Owner's Manual

Mobile DVD/CD Player

Models: MV6000

MV6000C

For operational or technical assistance, after reading this manual,

please call us toll free at [phone] or visit www.magnadyne.com

90.1MHz

90.5MHZ

MV6000-UM.qxp 4/5/05 16:13 Page 1

2

Features

• Compatible with PAL and NTSC Systems. This
player can play discs recorded in either PAL or
NTSC format.

• CD, DVD, CD-R, CD-RW, MP3 Compatible.

• L/R stereo analog audio outputs for
connection to existing head unit aux. inputs.
Video output is composite video.

• Supplied Remote Features: multi-language
audio-track/subtitle, multi-angle (where avail­able), plus all basic functions.

Use this Product Safely

Driving

Be aware of road and traffic conditions. Keep
the volume at a low level.

Moisture

Do not expose the product to water or exces­sive moisture. This could cause electrical
shorts, fire or other damage.

Parking

Parking in direct sunlight can produce very high
temperatures inside your vehicle. Give the car
interior a chance to cool down before starting
playback.

Proper Power Supply

This product is designed to operate with a 12 Volt
DC, negative ground battery system.

Protecting the Disc Mechanism

Avoid inserting any foreign objects into the slot of
this player. Failure to observe this precaution may
cause malfunction of this unit.

Repairs

Contact our customer service representatives.
Do not attempt to disassemble or adjust this
product yourself.

Installation

The unit should be installed in a horizontal posi­tion.

MV6000-UM.qxp 4/5/05 16:13 Page 2

3

Safety Information. . . . . . . . . . . . . . . . . . . . . . 3

Disc Notes. . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Screen and DVD/CD Functions . . . . . . . . . . 5-7

Location of Functions. . . . . . . . . . . . . . . . . . 5

Adjusting the Monitor . . . . . . . . . . . . . . . . . 6

Inserting a DVD/CD . . . . . . . . . . . . . . . . . . . 6

Changing to an Auxiliary Input Source. . . . . 6

Transmitter Frequency Selection . . . . . . . . . 7

Car Radio Interface . . . . . . . . . . . . . . . . . . . 7

Mono/Stereo Switch. . . . . . . . . . . . . . . . . . . 7

Dome Light Operation . . . . . . . . . . . . . . . . . 7

Wiring Diagram . . . . . . . . . . . . . . . . . . . . . . . 8

Wiring Instructions . . . . . . . . . . . . . . . . . . . 9

Remote Control. . . . . . . . . . . . . . . . . . . . 10-11

Remote Control Functions . . . . . . . . . . 10-11

Headphones . . . . . . . . . . . . . . . . . . . . . . 12-13

Headphone Operation. . . . . . . . . . . . . . . . . 13

Basic Operation. . . . . . . . . . . . . . . . . . . . 14-15

Turn the Unit On. . . . . . . . . . . . . . . . . . . . . 14

Loading a DVD/CD Disc . . . . . . . . . . . . . . 14

Ejecting a Disc . . . . . . . . . . . . . . . . . . . . . 14

Standby State. . . . . . . . . . . . . . . . . . . . . . . 14

Basic Play. . . . . . . . . . . . . . . . . . . . . . . 14-15

Advanced Operation . . . . . . . . . . . . . . . . 16-17

Initial DVD Setup . . . . . . . . . . . . . . . . . . 18-19

Specifications. . . . . . . . . . . . . . . . . . . . . . . . 20

Troubleshooting . . . . . . . . . . . . . . . . . . . . . . 21

Replacement Parts . . . . . . . . . . . . . . . . . 22-23

Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23

Contents

Safety Information

CAUTION:

THIS MOBILE DVD PLAYER IS A CLASS I LASER
PRODUCT. HOWEVER, THIS MOBILE DVD PLAYER
USES A VISIBLE/INVISIBLE LASER BEAM WHICH
COULD CAUSE HAZARDOUS RADIATION EXPO­SURE IF DIRECTED. BE SURE TO OPERATE THE
MOBILE DVD PLAYER CORRECTLY AS INSTRUCT­ED. USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN HAZ­ARDOUS RADIATION EXPOSURE. DO NOT OPEN
COVERS AND DO NOT REPAIR YOURSELF. REFER
SERVICING TO QUALIFIED PERSONNEL.

CAUTION:

FCC REGULATIONS STATE THAT ANY UNAUTHO­RIZED CHANGES OR MODIFICATIONS TO THIS
EQUIPMENT MAY VOID THE USER’S AUTHORI­TY TO OPERATE IT.

WARNING:

• TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE.

• THIS DEVICE IS INTENDED FOR CONTINUOUS
OPERATION.

• TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK AND ANNOYING INTERFERENCE, USE
ONLY THE RECOMMENDED ACCESSORIES.

This product incorporates copyright protection
technology that is protected by method claims of
certain U.S. patents and other intellectual property
rights owned by Magnadyne Corporation and other
rights owners. Use of this copyright protection
technology must be authorized by Magnadyne
Corporation and is intended for home and other
limited viewing uses only unless otherwise author­ized by Magnadyne Corporation. Reverse engineer­ing or disassembly is prohibited.

Region Management Information:

This Mobile DVD Player is designed and manufac­tured to respond to the Region Management
Information that is recorded on a DVD disc. If the
Region number described on the DVD disc does
not correspond to the Region number of this
Mobile DVD Player, this Mobile DVD Player can­not play this disc.

MV6000-UM.qxp 4/5/05 16:13 Page 3

Disc Formats Supported by this Player:

Discs which cannot be played with this player:

• DVD-ROM

• DVD-R/DVD-RAM

• CDV

• CD-G

Disc Handling

• Dirt, dust, scratches and warping disc will
cause non operation.

• Do not place stickers on disc or scratch disc.

• Do not warp discs.

• A disc should always be kept in its case
when not in use to prevent damage.

•

Do not place discs in the following places:

1. Direct sunlight.

2. Dirty, dusty and damp areas.

3. Near car heaters.

4. Car seats or dashboard.

Disc Cleaning

Use a dry soft cloth to wipe the surface. If the
disc is quite dirty, use a soft cloth slightly moist
with isopropyl (rubbing) alcohol. Never use sol­vents such as benzine, thinner or conventional
record cleaners as they may mar the surface of
the disc.

Note: A disc may become somewhat scratched
(although not enough to make it unusable)
depending on handling and conditions in the
usage environment.

Preparing New Discs with Rough Spots

A new disc may have rough edges on its inside
and outside edges. If a disc with rough edges is
used, the proper setting will not be performed
and the player will not play the disc. Therefore,
remove the rough edges in advance by using a
ball point pen or pencil as shown. To do this,
press the side of the pen or pencil against the
inside and outside edges of the disc.

4

Disc Notes

V

I

D

E

O

(Single-sided disc only)

Label side up

Do not touch
the underside
of the disc

Do not bend

Wipe the disc
from center
toward the
outside edge.

Rough spots
on inside edge

Ball point pen
or pencil

Rough spots on
outside edge

MV6000-UM.qxp 4/5/05 16:13 Page 4

5

Screen and DVD/CD Functions

1. PWR / STOP Button ( ): Press this but-

ton to turn the unit On/Off. Press to stop disc
play.

2.

MODE Button ( ): Press this button to change

the play source between DVD/CD player and
an auxiliary input source.

3. PLAY/PAU Button ( ): Press this button to
display on screen monitor controls.

4. PREV Button ( ): Press this button during
playback to skip back to the previous track.

5. NEXT Button ( ): Press this button during
playback to skip forward to the next track.

6. EJECT Button ( ): Press this button to eject
the disc.

7. Infrared Remote Sensor: This is the sensor

for

the infrared remote.

8. Disc Slot: To play a DVD/CD, insert a disc into
slot with label facing up.

9. Transmitter Frequency Selection: 3 position
frequency switch to select a different frequen­cy. It transmits a signal that is received by
the MovieVision headphones. The signal can
also be received by the vehicle’s car radio.

10. Mono/Stereo Switch: Changes the unit from
Mono to Stereo

11. Dome Light: The dome lights located in the
MovieVision screen housing will illuminate
whenever the vehicle doors are open.

12. Dome Light Switch: To activate the dome
lights while the vehicle is in motion, press
the dome light switch.

13. Viewing Screen Release: To release the
screen, push inward on the tab and pull
downward. Place the screen to the desired
viewing position. To lock the viewing screen
in the closed position, press upward on the
edge of the screen housing until the screen
locks into place (you will hear a snap sound).

90.1MHz

90.5MHZ

1

2

3

6

7

8

12

9

13

4

11

5

10

MV6000-UM.qxp 4/5/05 16:13 Page 5

Adjusting the Monitor:

Press the Menu button to activate the monitor
adjustment menu. The following will be dis­played on the screen:

1. Use the MENU button on the remote to
activate the menu screen.

2. Press the MENU button again to select the
desired monitor adjustment item.

3. Once an item has been selected for adjust­ment, press the VOLUME buttons (- or +)
to make the desired adjustment to the
monitor.

4. Press the MENU button again until the
monitor adjustment menu disappears.

Inserting a DVD/CD

To play a DVD/CD, insert a disc into slot with
label facing up.

Changing to an Auxiliary Input Source

Press the MODE button to change

the play
source between DVD player and an auxiliary
input source.

Screen and DVD/CD Functions

6

Label

Facing Up

MV6000-UM.qxp 4/5/05 16:13 Page 6

Transmitter Frequency Selection:

The MovieVision viewing screen transmits a
signal that is received by the MovieVision head­phones and can also be received by the vehi­cle’s car radio. There are 3 frequencies available
for use but only one can be used at a time.
When you are listening to a movie using the
wireless MovieVision headphones, it is possible
that you could travel through an area where
interference between the screen transmitter and
the headphone receiver is at an unacceptable
level. If this occurs, you can use the 3 position
frequency switch located in the roof housing to
select a different frequency that may have less
or no interference. Each time you change the
transmitting frequency, the headphone/car
radio receiver will have to be retuned to the new
frequency. The 3 frequencies available for use
are 89.7MHz, 90.1MHz or 90.5MHz.

Car Radio Interface:

The signal transmitted from the MovieVision
screen can be received by the existing FM car
radio. This listening mode provides a much
higher quality of sound for all. To listen to the
MovieVision signal through the vehicle stereo
system, use the following procedure:

A.

Turn “ON” the MovieVision system and insert
a DVD/CD or attach an auxiliary signal
source to view on the screen.

B. Turn “ON” the FM radio in your vehicle and

tune the radio to one of the 3 frequencies
transmitted by the MovieVision system.
(89.7MHz - 90.1MHz - 90.5MHz)

C. Adjust the volume and tonal qualities to

suit your listening taste.

Mono/Stereo Switch:

Use the Stereo setting for enhanced sound
effect when environment is noisy or tends to
have interference use Mono setting.

Dome Light Operation:

The dome lights located in the MovieVision
screen housing will illuminate whenever the
vehicle doors are open just as the original
dome light did.
To activate the dome lights manually, press
the dome light switch next to the desired
dome light.

Note: Most American made vehicles (Ford,
Chevrolet, Dodge) have a dashboard light dim­mer switch that can be rotated to the maximum
position and the dome lights will illuminate.
Most Japanese or Korean made vehicles do
not have this switch and the lights will have to
be turned on manually as mentioned above.

Warning! In some cases, the dome light may
be hot, proceed with caution. Only replace the
bulb with the recommended size and wattage.
Altering the size, shape or wattage will result
in a damaged housing (melting). Use only
Sylvania or GE model DE3021 for replace­ments.

Screen and DVD/CD Functions

90.1MHz

90.5MHZ

90.5MHz

90.1MHz

89.7MHz

MONO ST

Frequency

Switch

7

Dome Light Switch

Mono/ Stereo

Switch

MV6000-UM.qxp 4/5/05 16:13 Page 7

Wiring Diagram

8

Video Output

Yellow RCA Connector
with Gray Wire

Yellow RCA Connector
with Black Wire

Red RCA Connector
with Black Wire

White RCA Connector
with Black Wire

Video Input

Audio Input (Right)

Audio Input (Left)

Yellow Wire 12 V Memory

Black Wire Ground

Red Wire Ignition

Green Wire See Dome Light Section for Connection

White Wire See Dome Light Section for Connection

Orange Wire See Dome Light Section for Connection

3A

3A

MV6000-UM.qxp 4/5/05 16:13 Page 8