MotorVac S-Tool User Manual

Gas Service Decarbonizing S-Tool with Canister
For professional use only. Will not harm engine components. Safe for use with all gasoline engines. For Use With MotorVac, CarbonClean and other Professional Cleaning Systems Pressure Sprayer is Reusable Part No. 200-0002 Made in the USA
DANGER! COMBUSTIBLE. HARMFUL IF SWALLOWED. VAPOR HARMFUL. EYE AND SKIN IRRITANT. KEEP OUT OF REACH OF CHILDREN.
Caution: Keep away from heat, sparks and open flame. Avoid skin contact with solution. Avoid breathing vapor. Do not take internally or splash in eyes. If splashed in eyes, flush with water. If swallowed, do not induce vomiting. In any of these events call a physician immediately. Use only with adequate ventilation. Directions:
1. Warm up vehicle to operating temperature.
2. Shut off vehicle’s engine and remove the air hose boot at the throttle plate.
3. Insert ‘S’ nozzle into throttle plate opening, and reinstall air hose boot. ‘S’ tool must be as close to the throttle plate as possible.
4. Prior to starting engine, pour entire contents of detergent into sprayer pressure canister and tighten.
5. Start engine.
6. Close ball valve on sprayer and connect shop air to regulator on sprayer.
7. Adjust sprayer regulator to minimum of 80 psi. Open ball valve slowly. Increase idle to open throttle plate.
8. After cleaning is complete and canister is empty stop engine.
9. Remove air hose boot and remove ‘S’ nozzle from throttle plate.
10. Reinstall air boot, start engine and test-drive for 3 to 5 miles to clear system.
11. Service takes approximately 8 minutes for fill of 24 ounces.
MotorVac notifies the users that hereby disclaim any and all consequential damages resulting from the use of the intake cleaning pressure sprayer.
Loading...