MotorVac CarClean System User Manual

User’s guide
Professional In-Car CarClean System Includes set-up,
operation, maintenance and troubleshooting information.
CarClean System
Warranty
MotorVac® warrants the CarClean System™ machine to be free of defects in materials and workmanship for a period of 1 Year, except the piezo ultrasonic transducer, which is warranted for 90 days. MotorVac
®
Technologies, at its sole
discretion, will replace or repair any defective item within the Warranty period. MotorVac MotorVac
®
Technologies must be contacted in the event of a warranty claim and
®
Technologies, at its sole discretion, will decide if the item needs to be returned for inspection. If the item is to be returned for inspection, a Returned Goods Authorization Number (RGA) and shipping instructions will be provided. All returns must be clearly marked with the RGA number provided. MotorVac
®
Technologies products can normally be serviced “in field” and will not require return. A replacement part can be sent from the Factory for such repair. The warranty does not cover the repair or exchange resulting from misuse, modification or improper operation by allowing the machine to run dry.
Customer Service Department: 1-905-270-0555 or Toll Free: 1-800-841-8810 or email at info@motorvac.com
Important Safety Information
NOTE: After every service, drain out any fluid and replace rubber caps. Drain machine by tilting it forward, NEVER BACKWARDS! Certain Cabin Air Filters need to be removed during operation, see “Identify the Vehicle’s Cabin Air Filter”. NEVER fill machine from the exhaust vent. Only use recommended MotorVac Ultrasonic MiST
Cleaning Solution designed for this machine to prevent any damage or void warranty. Machine should be levelled during service. NOTE: Use the positioning level on the machine. Allow proper ventilation when operating a vehicle indoors.
®
Getting Started
Congratulations on your purchase of this revolutionary equipment to Improve the In-Car air quality for the well-being of drivers and their passengers. Your MotorVac CarClean System
machine is designed so that you can set it up quickly and easily. By following the steps on the next few pages, you will have your CarClean System machine up and started in no time.
Identify the Vehicle’s CabinAir Filter
REMOVE CABIN AIR FILTERS that are operational during recirculation mode. These lters are normally located inside the vehicle’s passenger compartment. (See Vehicle’s Owner Manual)
˚F/˚C
For optimum results, set cabin temperature 72˚F / 22˚C.
DO NOT NEED TO REMOVE CABIN AIR FILTERS located at the outside fresh air intake. These lters are normally found under the hood.
X
1
®
Getting to know your MotorVac® CarClean System™ machine
9
8
7
6
1. 12V DC Power Cord
2. Fill Port Dust Cover
3. Cleaning Solution Fill Port
4. Positioning Level
5. Exhaust Dust Cap
6. Start Button
7. Treatment in Progress (green LED)
8. Treatment Complete (green LED)
9. LOW Fluid Level (red LED)
2 3
4
5
1
Prepare Machine
Before you begin, see the important safety information on page 1. Remove cap from MotorVac fill port snugly. (Photo A). Empty total bottle contents by pushing container down then remove container and discard into regular trash.
®
MiST™ Cleaning Solution and screw on to the
A
2
CarClean System
Loading...
+ 5 hidden pages