MotorScrubber MS2000M User Manual

MotorScrubber MS2000S/M/L Instruction Manual

PLEASE READ ALL INSTRUCTIONS

When using electric products, basic safety precautions
should always be followed to reduce the risk of electric
shock and personal injury, including the following:

Consider your work area environment. When using
the MotorScrubber be aware of overhead electrical
wires. MOTOR SCRUBBER IS POWERED BY DC

CURRENT ONLY. DO NOT ATTEMPT TO OPERATE
MOTORSCRUBBER WITH AC CURRENT.

• Never pull the MotorScrubber by its cord or yank
it to disconnect it from the battery.

• Keep the cord away from heat, oil and sharp
edges.

• Keep your MotorScrubber clean. For safer
operation follow instructions for attaching accessories. Keep the upper handle switch
area dry, clean and free from oil, grease and water.

• Disconnect the MotorScrubber when not in use AND WHEN ATTACHING

ACCESSORIES.

• Inspect for damage before using MotorScrubber.

• When servicing, use only genuine parts and accessories.

• MOTORSCRUBBER IS A POWER TOOL. AS WITH ANY POWER TOOL, ALWAYS USE

BOTH HANDS TO ENSURE SAFE OPERATION.

ASSEMBLING YOUR MOTORSCRUBBER

If you have purchased a MotorScrubber MS2000S or MS2000M
model please skip to point 3, page 4. Points 1 and 2 only apply to
the MS2000L model which comes non assembled.

1. Remove the motor housing and yoke from carton. Connect the electrical plug from the
yoke to the electrical plug from the end of handle. Push together FIRMLY, see Fig. 1
(Page 4), be certain the electrical plugs are fully locked together. Then insert the yoke
into the handle aligning the screw holes in the yoke with the two holes in the handle,
see Fig. 2 (Page 4). Insert the thumb screws and finger tighten.

2. Attach the hub to the motor assembly using the flat washer, lock washer, and bolt
provided. Assemble in the order shown in Fig.3 (Page 4).

3

3. IMPORTANT INFORMATION.
Before use, the battery coiled cord
needs connecting to the battery
terminals. It is vitally important to
connect the cable with the correct
polarity. If the cable is connected
incorrectly it could cause fire
when plugged into the charger.

Connect the red wire from the
battery coiled cord to the red
battery terminal and connect the
black wire from the battery coiled
cord to the black battery terminal.

4. To operate the MotorScrubber using the rechargeable battery, connect the electrical
plug from the battery to the electrical plug attached to the handle (See Fig. 4).

5. To operate the MotorScrubber using the 25’ cord (MS-1025), connect the electrical
plug from the MS-1025 to the electrical plug attached to the handle, then connect the
other end of the MS-1025 to either the MS-1020 12VDC vehicle battery post adapter,
the MS-1022 cigarette lighter adapter, or the battery pack.

FIG. 1

Electrical Connector from Yoke

Electrical Connector
from Handle

FIG. 2

Screws

FIG. 4FIG. 3

4