Motorola T6HF1 Users manual

BEFORE YOU BEGIN

DRAFT

Before using this product, read the Important Safety and Legal Information pamphlet and follow its instructions.

Take a moment before you get started to familiarize yourself with your new MOTOROKR™ T3 Bluetooth® Wireless Music and Handsfree Car Speaker.

Volume Up Button

Visor Clip

Speaker

Front View

Microphone

Call Button

Main Indicator Light

Bezel

Indicator Light

Play/Pause

Button

Volume Down Button

Rear View

Radio Button

Charging Port

START HERE >

Power

Button

To get started, your MOTOROKR T3 must be set up with initial configuration settings.

Press and hold Power button to enter

setup mode. You hear a voice prompt to select appropriate language for remaining voice prompts.

Select language for voice prompts as

follows:

Press Volume buttons to change current selection.

Press Play/Pause button to make

selection. You hear a confirmation tone.

SET UP

Your MOTOROKR T3

Select whether to enable/disable the

auto caller ID feature:

Press Volume buttons to select enable

or disable.

Press Play/Pause button to confirm

selection. You hear a confirmation tone.

Press Play/Pause button again to complete

setup. You hear a confirmation tone.

When setup is complete, you hear the voice prompt “Setup is complete. Device is ready.”

After a few moments, your MOTOROKR T3 enters Bluetooth pairing mode.

Before you can use your MOTOROKR T3, you must pair (link) it with your phone and/or music device.

Step A - ENSURE MOTOROKR T3 IS IN PAIRING MODE

When setup is complete (step 1), your MOTOROKR T3 is automatically placed in Bluetooth pairing mode. The main indicator light will be steadily lit in blue to indicate handsfree speaker is in pairing mode.

If the handsfree speaker is not pairing mode, see TROUBLESHOOTING for help.

Your MOTOROKR T3 and

PAIR

Bluetooth Device

Main Indicator Light (steadily blue for pairing mode)

Step B - TURN ON BLUETOOTH FEATURE ON YOUR DEVICE

To use your MOTOROKR T3, you must turn on the Bluetooth feature in your phone or music device.

For most Motorola phones:

Press (

Bluetooth Link > Setup.

Scroll to Power.

Select Change.

Scroll to On.

Press Select to turn on the Bluetooth

feature. The Bluetooth feature remains on until you turn the feature off.

Note: These steps are for most Motorola phones. For other phones, see your phone's user's guide.

Menu) > Settings > Connection >

Motorola, Inc. Consumer Advocacy Office 1307 East Algonquin Road Schaumburg, IL 60196

www.hellomoto.com 1-877-MOTOBLU 1-888-390-6456 (TTY/TDD United States for hearing impaired)

Guide Number: 6809503A46-O

Bluetooth ID: xxxxxx

MOTOROLA and the Stylized M Logo are registered in the US Patent & Trademark Office. The use of wireless devices and their accessories may be prohibited or restricted in certain areas. Always obey the laws and regulations on the use of these products. The Bluetooth trademarks are owned by their proprietor and used by Motorola, Inc. under license. All other product or service names are the property of their respective owners.

Step C - SET YOUR DEVICE TO LOOK FOR YOUR MOTOROKR T3

While the MOTOROKR T3 is in pairing mode, use your phone or music device to perform a device discovery. Refer to your device’s manual for detailed instructions on accessing Bluetooth and putting it in device discovery mode.

For most Motorola phones:

Press (

Bluetooth Link > Handsfree > Look for Devices.

The phone lists Bluetooth devices it finds.

Select Motorola T3.

Select OK or Yes to pair your MOTOROKR

T3 with your phone. Enter the passkey: 0000

Select OK.

Note: These steps are for most Motorola phones. For other phones, see your phone's user's guide.

When your MOTOROKR T3 successfully pairs and connects with your phone or music device, the main indicator light flashes purple and blue.

Menu) > Settings > Connection >

Your MOTOROKR T3 and phone or music device are now paired and connected. Do the following to verify proper operation:

●

To verify handsfree calling operation, dial the number you want to call on the phone and press SEND key on your phone. If your phone and MOTOROKR T3 are successfully paired, you will hear ringing on your T3.

●

To verify streaming audio listening operation, play music on your streaming

music device. If your music source and MOTOROKR T3 are successfully paired and connected for streaming music, you hear music on your T3.

TEST AND USE

YOU’RE FINISHED!

After you have successfully set up your MOTOROKR T3, you don't need to repeat these steps.

For daily use, ensure that your T3 is turned ON and your phone and/or music device’s Bluetooth feature is ON.

To modify T3 configuration settings, you can reenter setup mode by pressing and holding the Power and Call buttons when powering up.

To use the T3 with your FM car radio, see “Using With Your FM Car Radio” on the reverse side.

CHECKING BATTERY LEVEL

To check your T3’s battery charge level while turned on and not on a call, you can by pressing and holding both Volume buttons until you hear a beep (about 5 seconds) The main indicator light displays charge status for a few seconds (see “Indicator Light” on reverse side for details).

To charge your T3, see “Charging Battery” on the reverse side for details.

USING YOUR

MOTOROKR

See

Features and

Functions Guide

on the reverse side

for information on

using your T3

TROUBLESHOOTING

My MOTOROKR T3 will not enter pairing mode.

Make sure that any devices previously paired with the T3 are turned off. If the main indicator light is pulsing in blue, first turn off the other device, then turn your T3 off and on. The main indicator light becomes steadily lit in blue indicating the T3 is now in pairing mode.

My phone/music device doesn't find my MOTOROKR T3.

Make sure the indicator light on your T3 is on (lit in blue) and steady when your phone/music device is searching for devices (see step 2a).

My MOTOROKR T3 worked before but now it's not working.

Make sure your phone/music device is on and the Bluetooth feature is turned on in your device (see step 2b). If the Bluetooth feature was turned off or was turned on only temporarily, you may need to restart the Bluetooth feature (see step 2b) and pair your device and T3 again (see step 2c).

Support. If you need more help, contact us at 1-877-MOTOBLU or visit us at www.hellomoto.com/Bluetoothsupport

Features and

DRAFT

Functions Guide

IMPORTANT:

Be sure to first follow the

Quick Start Guide

on the reverse side

of this guide to complete initial setup of your MOTOROKR T3.

TURNING MOTOROKR T3

ON AND OFF

To turn your T3 on, press and hold the

Power button until you hear the voice prompt “Device is ready”, and the main indicator light flash blue three times.

To turn your T3 off, press and hold the Power button until you hear the voice prompt “Powering off”, and the main indicator light flash blue three times.

Power

Button

When idle (not connected to a Bluetooth device) or not active for 30 minutes, the T3 powers down automatically.

INSTALLING IN CAR SETTING FM CAR

To install the T3 in your car, first slide metal visor clip onto T3, then secure T3 to the sun visor in your car as shown below.

USING WITH YOUR FM

CAR RADIO

When your MOTOROKR T3 is connected and operating with your phone and/or music device, you can route call and music audio to your car’s FM radio.

To hear calls and streaming music over your FM car radio:

Press Radio button on rear of your

MOTOROKR T3. After a few moments, the bezel indicator light is lit and voice prompt states the currently set frequency (default is “88.1MHz”).

Turn on your car’s FM radio and tune to

broadcast frequency. Call and streaming music audio is broadcast on your FM

To turn off FM transmitter, press and hold Radio button until the bezel indicator turns off.

RADIO FREQUENCY

You can set the frequency used by the T3 to broadcast calls and streaming music to your FM car radio.

To do this, tap the Radio button. The T3 searches for another clear frequency. When found, the voice prompts states the new frequency. (For example, if the new frequency is 96.1MHz, the voice prompt states “96.1MHz”.)

[How do you save/confirm the new frequency?]

CHARGING BATTERY

Plug the Motorola charger into the charging

port on the rear of the T3.

The main indicator light turns red or yellow when the battery is charging. It may take up to 1 minute for the indicator light to turn on. When the T3's battery is fully charged (about [x] hours), the indicator light turns green.

Disconnect the charger.

Note: T3 is not functional while charging.

LISTENING TO MUSIC

Function Action

Play/Pause music Tap Play/Pause button

Skip to next track Tap Volume Up button

Skip to previous track Tap Volume Down button

Fast-forward track Press and hold Volume Up button

Rewind track Press and hold Volume Down button

Stop music player Press and hold the Play/Pause button until you hear a beep

European Union Directives

Conformance Statement

Hereby, Motorola declares that this product is in compliance with:

• The essential requirements and other relevant provisions of Directive 1999/5/EC.

• All other relevant EU Directives.

The above gives an example of a typical Product Approval Number.

You can view your product’s Declaration of Conformity (DoC) to Directive 1999/5/EC (to R&TTE Directive) at www.motorola.com/rtte. To find your DoC, enter the product Approval Number from your product’s label in the “Search” bar on the web site.

Product

Approval

Number

MAKING CALLS

Function Action

Make a voice dial call Tap the Call button and speak the name after the tone

End a call Tap the Call button

Answer a call Tap the Call button

Ignore a call Tap either Volume button

Reject a call Press and hold either Volume button until incoming call stops ringing

Redial last call Press and hold the Call button for at least 2 seconds until you hear a beep

Note: Some features are phone/network dependent.

Note: Your T3 supports both Handsfree and Headset Profiles. Accessing call functions depends upon which profile your phone supports. See your phone's user's guide for more information.

MAKING CALLS

Function Action

Mute or unmute a call Tap Play/Pause button

Answer a second Tap the Call button incoming call

End an active call and Tap the Call button resume a call on hold

Ignore a second Tap either Volume incoming call button

Note: Some features are phone/network dependent.

CONTINUED

MAIN INDICATOR LIGHT

With the Charger Plugged In

Indicator Status

Red Charging (battery level less than 80%

charge) Yellow Charging (battery

level more than 80% charge)

Blue Charging complete

When Checking Battery Level

Indicator Status

Red Battery at less than 10% charge

Yellow Battery at between 10% and 80% charge

Green Battery at more than 80% charge

MAIN INDICATOR LIGHT

With No Charger Plugged In

Indicator Status

Off Power off Three blue flashes Powering on/off Steady blue Pairing mode Rapid blue/purple flashes Pairing successful Quick blue flash Incoming/outgoing call Slow blue pulse Connected (on a call)/

Standby (not on a call) Slow red pulse Idle (not connected

to Bluetooth device) Slow purple pulse Connected call muted Quick red flash Low battery Slow green pulse Music streaming

Note: After [xx] minutes on a call or of inactivity, the light stops flashing to conserve power, but the headset remains on.

BEZEL INDICATOR LIGHT

With No Charger Plugged In

Indicator Status

Off FM transmitter off On FM transmitter on

Note: After [xx] minutes on a call or of inactivity, the light stops flashing to conserve power, but the headset remains on.

AUDIO TONES

Audio Tone Status

Ascending tone Powering on Two descending tones Powering off Four ascending tones Charger connected Four descending tones Charger disconnected Three ascending tones Connected call Three descending tones Disconnected call Two short tones when Volume at minimum

pressing Volume button or maximum

AUDIO TONES

Audio Tone Status

Series of ascending tones Volume increasing Series of descending Volume decreasing

tones Two rapid ascending Mute enabled

tones Two rapid descending Mute disabled

tones Two short tones when Track forward

pressing Volume Up button when music playing

Two short tones when Track backward pressing Volume Down button when music playing

High/low tones Low battery repeated every 60 sec.

No audio indications; Out of range deteriorating quality

(CONTINUED)

+ 3 hidden pages