Motorola T6CT1 Users manual

MOTOROLA INC FCC ID: IHDT6CT1

MOTOROLA BLUETOOTH MODULE BT04 USER MANUAL

[Model# BT0406AJ08]

1. GENERAL:

The Bluetooth Module BT04 facilitates a wireless Bluetooth interface between a
wireless handset and another Bluetooth-enabled device located in a Telematics control
unit. The Bluetooth Module BT04 is internal to a Motorola Bluetooth handset should be
considered a product level module.

2. ANTENNA AND MODULE INSTALLATION:

The module utilizes an internal, pc board mounted, chip antenna. The unit is
designed for installation within the Bluetooth handset and located in an automobile,
usually in the center console area. The device is mounted within a plastic housing of the
handset and is located to minimize shadowing of the internal antenna. Due to the low
power at which the unit transmits (35uW radiated measurement.), placement from an
SAR perspective is not critical.
No end-user installation is involved of the Bluetooth module and is only
performed by Motorola or approved contractor. Any unauthorized changes or
modifications not expressly approved by Motorola could void the user’s authority to
operate this equipment.

3. I/O CONNECTION:

A board mounted, 16-pin flex cable is utilized to provide power and vehicle bus
communications to the module. This connector will only mate with a corresponding
connector in the Bluetooth wireless handset.

4. SPECIFICATIONS:

• Frequency range: 2402 MHz – 2480 MHz

• Operating current: 1.5A nominal

• Operating voltage: 13.2V nominal

• Operating temp. range: -30°C to +70°C

• Storage temp. range: -40°C to +85°C

• Output power: 35uW (Radiated Measurement)

5. Other

This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
This device must accept any interference received, including interference that may
cause undesired operation.