IMPORTANT INFORMATION ON SAFE AND EFFICIENT OPERATION
READ THIS INFORMATION BEFORE USING YOUR RADIO.
The information provided in this document supersedes the general safety
information contained in user guides published prior to July 2000. For information
regarding radio use in a hazardous atmosphere please refer to the Factory
Mutual (FM) Approval Manual Supplement or Instruction Card, which is included
with radio models that offer this capability.
RF Operational Characteristics
Your radio contains a transmitter and a receiver. When it is ON, it receives and
transmits radio frequency (RF) energy. The radio operates in the frequency range of
462 MHz to 467 MHz. The output power level typically may vary over a range from
0.5 watts to 1.0 watt.
Exposure To Radio Frequency Energy
Your Motorola radio is designed to comply with the following national and
international standards and guidelines regarding exposure of human beings to
radio frequency electromagnetic energy:
•United States Federal Communications Commission, Code of Federal
Regulations; 47 CFR part 2 sub-part J
•American National Standards Institute (ANSI) / Institute of Electrical and
Electronic Engineers (IEEE) C95. 1-1992
•Institute of Electrical and Electronic Engineers (IEEE) C95.1-1999 Edition
•National Council on Radiation Protection and Measurements (NCRP) of the
United States, Report 86, 1986
•International Commission on Non-Ionizing Radiation Protection (ICNIRP) 1998
SAFETY AND GENERAL INFORMATION
i
•Ministry of Health (Canada) Safety Code 6. Limits of Human Exposure
to Radio frequency Electromagnetic Fields in the Frequency Range from
3 kHz to 300 GHz, 1999
•Australian Communications Authority Radio communications
(Electromagnetic Radiation - Human Exposure) Standard 1999
(applicable to wireless phones only)
To assure optimal radio performance and make sure human exposure to radio
frequency electromagnetic energy is within the guidelines set forth in the above
standards, always adhere to the following procedures:
PORTABLE RADIO OPERATION AND EME EXPOSURE
Antenna Care
Use only the supplied or an approved replacement antenna. Unauthorized
antennas, modifications, or attachments could damage the radio and may
violate FCC regulations.
DO NOT hold the antenna when the radiois “IN USE.” Holding the antenna
affects call quality and may cause the radio to operate at a higher power level
than needed.
Two-way Radio Operation
When using your radio as a traditional two-way radio, hold the radio in a
vertical position with the microphone one to two inches (2.5 to 5 cm) away
from the lips.
SAFETY AND GENERAL INFORMATION
ii
Body-worn Operation
To maintain compliance with FCC/Health Canada RF exposure guidelines, if you
wear a radio on your body when transmitting, always place the radio in a
Motorola supplied or approved clip, holder, holster, case, or body harness
for this product. Use of non-Motorola-approved accessories may exceed FCC/Health Canada RF exposure guidelines. If you do not use a body-worn
accessory, and are not using the radio held in the normal use position at the ear,
ensure the radio and its antenna are at least one inch (2.5 cm) from your
body when transmitting.
Data operation
When using any data feature of the radio, with or without an accessory cable,
position the radio and its antenna at least one inch (2.5 cm) from the body.
Approved Accessories
For a list of approved Motorola accessories visit our website at www.motorola.com.
ELECTROMAGNETIC INTERFERENCE/COMPATIBILITY
Note: Nearly every electronic device is susceptible to electromagnetic
interference (EMI) if inadequately shielded, designed or otherwise
configured for electromagnetic compatibility.
FACILITIES
To avoid electromagnetic interference and/or compatibility conflicts, turn off
your radio in any facility where posted notices instruct you to do so. Hospitals
or health care facilities may be using equipment that is sensitive to external
RF energy.
SAFETY AND GENERAL INFORMATION
iii
AIRCRAFT
When instructed to do so, turn off your radio when on board an aircraft. Any
use of a radio must be in accordance with applicable regulations per airline
crew instructions.
MEDICAL DEVICES
Pacemakers
The Advanced Medical Technology Association recommends that a minimum
separation of 6 inches (15 centimeters) be maintained between a handheld
wireless radio and a pacemaker. These recommendations are consistent with
the independent research by, and recommendations of, the United States
Food and Drug Administration.
Persons with pacemakers should:
•ALWAYS keep the radio more than six inches (15 centimeters) from their
pacemaker when the radio is turned ON.
•not carry the radio in the breast pocket.
•use the ear opposite the pacemaker to minimize the potential for
interference.
•turn the radio OFF immediately if you have any reason to suspect that
interference is taking place.
Hearing Aids
Some analogue wireless radios may interfere with some hearing aids. In the
event of such interference, you may want to consult your hearing aid
manufacturer to discuss alternatives.
SAFETY AND GENERAL INFORMATION
iv
Other Medical Devices
If you use any other personal medical device, consult the manufacturer of your
device to determine if it is adequately shielded from RF energy. Your physician
may be able to assist you in obtaining this information.
SAFETY AND GENERAL USE WHILE DRIVING
Check the laws and regulations on the use of radio in the area where you drive.
Always obey them.
When using your radio while driving, please:
•Give full attention to driving and to the road.
•Use hands-free operation, if available.
•Pull off the road and park before making or answering a call if driving
conditions so require.
OPERATIONAL WARNINGS
FOR VEHICLES WITH AN AIR BAG
Do not place a portable radio in the area over an air bag or in the air bag
deployment area. Air bags inflate with great force. If a portable radio is placed
in the air bag deployment area and the air bag inflates, the radio may be
propelled with great force and cause serious injury to occupants of the vehicle.
POTENTIALLY EXPLOSIVE ATMOSPHERES
Turn off your radio prior to entering any area with a potentially explosive
atmosphere, unless it is a radio type especially qualified for use in such areas
as "Intrinsically Safe." Do not remove, install, or charge batteries in such areas.
Sparks in a potentially explosive atmosphere can cause an explosion or fire
resulting in bodily injury or even death.
SAFETY AND GENERAL INFORMATION
v
Note: The areas with potentially explosive atmospheres referred to above
include fueling areas such as below decks on boats, fuel or chemical
transfer or storage facilities, areas where the air contains chemicals or
particles, such as grain, dust or metal powders, and any other area where
you would normally be advised to turn off your vehicle engine. Areas with
potentially explosive atmospheres are often but not always posted.
BLASTING CAPS AND AREAS
To avoid possible interference with blasting operations, turn off your radio
when you are near electrical blasting caps, in a blasting area, or in areas
posted: “Turn off two-way radio.” Obey all signs and instructions.
OPERATIONAL CAUTIONS
ANTENNAS
Do not use any portable radio that has a damaged antenna. If a damaged
antenna comes into contact with your skin, a minor burn can result.
BATTERIES
All batteries can cause property damage and/or bodily injury such as burns if a
conductive material such as jewelry, keys, or beaded chains touch exposed
terminals. The conductive material may complete an electrical circuit (short
circuit) and become quite hot. Exercise care in handling any charged battery,
particularly when placing it inside a pocket, purse, or other container with
metal objects.
SAFETY AND GENERAL INFORMATION
vi
DCharging Safety Instructions
Before using the battery charger, read all instructions and cautionary markings
on the:
1. battery
2. battery charger, and
3. radio using the battery.
Caution:To reduce the risk of injury, charge only the rechargeable batteries listed.
Other types of batteries may burst, causing personal injury and damage.
Single-Unit Charger
Kit NumberDescription
NTN9393110V - NiMH Charging Adapter
Batteries
Kit Number
Capacity in
milliampere-hour mAH
DescriptionComposition
NTN9395550 mAHT6000-SeriesNiMH
Save these Instructions
1. Do not expose the charger to rain or snow.
2. Do not operate the charger if it has received a sharp blow, or has been dropped
or damaged in any way.
SAFETY AND GENERAL INFORMATION
vii
3. Do not disassemble the charger if it has received a sharp blow, or has been
dropped or damaged in any way.
4. Never alter the AC cord or plug provided with the unit. If plug will not fit the
outlet, have proper outlet installed by a qualified electrician. An improper
condition can result in a risk of electric shock.
5. To reduce risk of damage to cord or plug, pull the plug rather than the cord when
disconnecting charger from AC receptacle.
6. To reduce the risk of electric shock, unplug the charger from the outlet before
attempting any maintenance or cleaning.
7. Use of an attachment not recommended or sold by Motorola may result in a risk
of fire, electric shock, or personal injury.
8. Make sure that the cord is located so that it will not be stepped on, tripped over,
or subjected to damage or stress.
9. An extension cord should not be used unless absolutely necessary. Use of
an improper extension cord could result in a risk of fire and/or electric shock.
If an extension cord must be used, make sure:
• That the pins on the plug of the extension cord are the same number, size
and shape as those on the plug of the charger.
• That the extension cord is properly wired and in good electrical condition,
and
• That the cord size is18 AWG for lengths up to 100 feet, and 16 AWG for
lengths up to 150 feet.
10. The supply cord of this charger cannot be replaced. If the cord is damaged,
the charger should be discarded or returned to the point of purchase if within
SAFETY AND GENERAL INFORMATION
90 days of purchase.
viii
FCC Licensing Information
Your Motorola radio operates on General Mobile Radio Service (GMRS)
frequencies and is subject to the Rules and Regulations of the Federal
Communications Commission (FCC). The FCC requires that all operators using
General Mobile Radio Service (GMRS) frequencies obtain a radio license before
operating their equipment.
To have the FCC forms faxed to you, contact the Fax-On-Demand
1-202-418-0177 from your fax machine and request document 000605 for all forms
and instructions.
To have the forms mailed to you, call the FCC forms hotline at:
1-800-418-FORM (1-800-418-3676)
For questions about the license application, contact the FCC at:
1-888-CALL-FCC (1-888-225-5322)
Or: http://www.fcc.gov
Before filling out your application, you must decide which frequency(ies) you can
operate on. See on page 34. For questions on determining your radio frequency,
please call Motorola Product Services at: 1-800-448-6686
system at:
FCC Licensing Information
1
Changes or modifications not expressly approved by Motorola may void the user’s
authority granted by the FCC to operate this radio and should not be made. To
comply with FCC requirements, transmitter adjustments should be made only by or
under the supervision of a person certified as technically qualified to perform
transmitter maintenance and repairs in the private land mobile and fixed services as
certified by an organization representative of the user of those services.
Replacement of any transmitter component (crystal, semiconductor, etc.) not
authorized by the FCC equipment authorization for this radio could violate
FCC rules.
Note: Use of this radio outside the country where it was intended to be
distributed is subject to government regulations and may be prohibited.
FCC Licensing Information
2
Getting Started
Hi, I’m QuickStart and I’m going to help you get started!
The Motorola
way radio that allows you to stay connected to family,
friends, and companions. The T6400 operates on Family
Radio Service (FRS) frequencies and General Mobile Radio Service (GMRS) frequencies; FRS requires no
service fee or license, and can be used anywhere in the
United States and other areas as listed by the FCC, but
GMRS are subject to FCC licensing requirements.
These radios offer more than just a way of keeping in
touch. They also help you and your group stay on
schedule because a clock, alarm, and stopwatch are built
into each model.
Talkabout® T6400 radio is a durable two-
A detachable Quick Reference Card is included.
Please read this manual to aid in understanding how your radio works.
Getting Started
3
Installing Batteries
Your radio uses three AA batteries or a rechargeable Nickel-Metal Hydride
(NiMH) battery.
Latch
• Turn off the radio
Getting Started
(see page 13).
• Push latch up until
it clicks.
• Lift back cover off.
Note: The radio keeps the clock settings if battery changes are made in less than
20 seconds. Try replacing one battery at a time.
• Remove and replace
batteries so the + and markings match the ones
in the compartment or the
NiMH charge contacts are
facing out.
• Hook back cover on
the hinges.
• Align tabs.
• Close battery door,
pressing lightly until
latch clicks.
4
The battery meter on the top-left corner of the display shows how
much battery power you have. It shows d (full), b (two-thirds
full), c(one-third full) and a (almost empty). When it’s c, the
radio beeps every ten minutes. So, change or charge those batteries!
Charging the NiMH battery (Optional Accessory, part number 56319)
Charge the NiMH overnight (12 to 16 hours) before using it for the first time, it will
need up to four hours of charging thereafter.
Getting Started
5
•Turn off the radio (see page 13) or place the NiMH battery in the charger
adapter cover.
•Plug in the charger.
•At the contacts on the back of the radio, or if charging just the battery, at the
battery contacts:
•Position the charger with the hook on the LED end of the charger placed over
the larger slot.
•Snap the hook on the cord end into the smaller slot.
Note: If you notice the LED flashing red for more than a minute while clamping
the charger onto the charger adapter cover, the battery is faulty and must
be replaced.
•When the LED turns solid green, the battery is fully charged.
Note: When charging the battery by itself, remove the charger from the charger
adapter cover before removing the battery.
Getting Started
6
CommPort™ Charging Dock
(Included with Optional Accessory, part number 56319)
The CommPort™ charging dock provides drop-in charging convenience. The
charging dock can be mounted or placed on any flat surface (such as a wall or
workbench) and turns your radio into a stationary intercom while keeping it charged
and ready for any adventure.
• To mount the charging dock:
• Wrap the power cord under the charging dock.
Use the cutouts to hold the cord in place.
• Attach using two #6 x ¾” screws appropriate for
the mounting surface.
Cutouts
Getting Started
7
•
• Position the charger with the hook on the
LED end over the left slot.
• Snap the hook on the cord end into the
right slot, clamping the charger onto the
charging dock contacts
• Plug in the charger.
• Place the radio, or the NiMH battery in the
charger adapter cover, into the CommPort
Getting Started
charging dock.
• When the LED turns solid green, the
battery is fully charged.
8
Loading...
+ 45 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.