Motorola SBV5222 User Manual

Software License, Warranty, Safety, and Regulatory Information — SBV5222 SURFboard® Digital Voice Modem

SAFETY AND REGULATORY INFORMATION

IMPORTANT SAFETY INSTRUCTIONS — when using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire,
electric shock, and injury to persons, including the following:

• Read all of the instructions listed here and/or in the user manual before you operate this device. Give particular attention to all safety precautions. Retain the

instructions for future reference.

• This device must be installed and used in strict accordance with manufacturer’s instructions as described in the user documentation that is included with the

device.

• Comply with all warning and caution statements in the instructions. Observe all warning and caution symbols that are affixed to this device.

• To prevent fire or shock hazard, do not expose this device to rain or moisture. The device must not be exposed to dripping or splashing. Do not place objects

filled with liquids, such as vases, on the device.

• This device was qualified under test conditions that included the use of the supplied cables between systems components. To ensure regulatory and safety

compliance, use only the provided power and interface cables and install them properly.

• Different types of cord sets may be used for connections to the main supply circuit. Use only a main line cord that complies with all applicable device safety

requirements of the country of use.

• Installation of this device must be in accordance with national wiring codes and conform to local regulations.

• Operate this device only from the type of power source indicated on the device’s marking label. If you are not sure of the type of power supplied to your

home, consult your dealer or local power company.

• Do not overload outlets or extension cords, as this can result in a risk of fire or electric shock. Overloaded AC outlets, extension cords, frayed power cords,

damaged or cracked wire insulation, and broken plugs are dangerous. They may result in a shock or fire hazard.

• Route power supply cords so that they are not likely to be walked on or pinched by items placed upon or against them. Pay particular attention to cords

where they are attached to plugs and convenience receptacles, and examine the point where they exit from the device.

• Place this device in a location that is close enough to an electrical outlet to accommodate the length of the power cord.

• Place device to allow for easy access when disconnecting the power cord of the device from the AC wall outlet.

• Do not connect the plug into an extension cord, receptacle, or other outlet unless the plug can be fully inserted with no part of the blades exposed.

• Place this device on a stable surface.

• Avoid damaging the cable modem with static by touching the coaxial cable when it is attached to the earth-grounded coaxial cable-TV wall outlet.

• Always first touch the coaxial cable connector on the cable modem when disconnecting or re-connecting USB or Ethernet cable from the cable modem or

user’s PC.

• It is recommended that the customer install an AC surge protector in the AC outlet to which this device is connected. This is to avoid damaging the device by

local lightning strikes and other electrical surges.

• Postpone installation until there is no risk of thunderstorm or lightning activity in the area.

• Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning. For added

protection for this device during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and
disconnect the cable system. This will prevent damage to the product due to lightning and power surges.

• Do not use this product near water for example, near a bathtub, washbowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool.

• Use only the power cord and batteries indicated in this manual. Do not dispose of batteries in a fire. They may explode. Check with local codes for possible

special disposal instructions.

• Disconnect the TNV circuit connector before removing the cover.

Disconnect TNV circuit connector(s) before disconnecting power.

•

• Do not use the telephone to report a gas leak in the vicinity of the leak.

• CAUTION: To reduce the risk of fire, use only No. 26 AWG or larger UL listed or CSA certified telecommunication line cord, or national equivalent.

• Do not cover the device, or block the airflow to the device with any other objects. Keep the device away from excessive heat and humidity and keep the

device free from vibration and dust.

• Wipe the device with a clean, dry cloth. Never use cleaning fluid or similar chemicals. Do not spray cleaners directly on the device or use forced air to

remove dust.

• Upon completion of any service or repairs to this device, ask the service technician to perform safety checks to determine that the device is in safe operating

condition.

• Do not open the device. Do not perform any servicing other than that contained in the installation and troubleshooting instructions. Refer all servicing to

qualified service personnel.

SAVE THESE INSTRUCTIONS

Note to CATV System Installer - This reminder is provided to call the CATV system installer’s attention to Section 820-93 of the National Electric Code, which

provides guidelines for proper grounding and, in particular, specifies that the Coaxial cable shield shall be connected to the grounding system of the building, as
close to the point of cable entry as practical.

Software License, Warranty, Safety, and Regulatory Information — SBV5222 SURFboard® Digital Voice Modem

Caring for the Environment by Recycling

Safety Requirements for the SBV5222 Lithium-Ion Battery

You must properly handle the SBV5222 lithium-ion rechargeable battery to ensure your safety. Improper handling can cause leakage, heat, smoke, explosion, or
fire resulting in damage to the equipment or the user.

• Use the SBV5222 battery only in the SBV5222 VoIP cable modem.

• CAUTION: Risk of explosion if battery is replaced by the incorrect type. Use only Motorola approved batteries, Motorola part number 515757-001 and

538043-001. Dispose of used batteries according to the instructions.

• Do not use the battery where static electricity is generated.

• Do not heat the battery or discard into a fire. Keep the battery away from high-temperature locations.

• Properly discard the battery if it exhibits an abnormal condition, such as heat, odor, color, or a change in shape. When discarding, place insulated tape over

the battery terminals.

• The battery should be stored out of the reach of children.

• Do not store the battery close to metal objects.

• If the battery leaks fluid and you touch it, immediately wash your hands. If the fluid gets into your eye, do not rub the eye. Rinse with water and immediately

seek medical care. Left untreated, the battery fluid could cause damage to the eye.

• Ensure that the battery does not receive any strong impacts, such as dropping or striking with a hard object.

• At the end of battery life, the SBV5222 battery must be disposed of properly and may need to be recycled. Contact your local recycling center for proper

disposal methods.

• Do not expose the battery to ultrasonic energy.

• Do not disassemble, modify, or attempt to repair the battery.

• Before installation, the battery should not be subjected to temperatures below –10ºC or above +60ºC (14º F to 140º F). After initial customer usage (initially

charged above shipping charge state), the battery should not be subjected to temperatures outside the operating temperature range:
Battery Pack External Exposure Operating Temperature Range:
Charging: 0.0°C to +45.0°C (0º F to 113º F)
Discharging: –10.0°C to +60.0°C (14º F to 140º F)

When you see this symbol on a Motorola product, do not dispose of the product with
residential or commercial waste.

Recycling your Motorola Equipment

Please do not dispose of this product with your residential or commercial waste. Some
countries or regions, such as the European Union, have set up systems to collect and
recycle electrical and electronic waste items. Contact your local authorities for information
about practices established for your region. If collection systems are not available, call
Motorola Customer Service for assistance.