Motorola 89FT4872 Users manual
6881098C61-B
*6881098C61*
Printed in Korea. 03/06. All Rights Reserved.
1301 E. Algonquin Rd., Schaumburg, IL 60196
© Motorola, Inc. 2005, 2006
All other products and service names are the property of their own respective owners.
Mag One™ by Motorola is registered in the U.S. Patent and Trademark Office.
site which lists approved accessories: http://www.motorola.com/governmentandenterprise
For a list of Motorola-approved antennas, batteries, and other accessories, visit the following web
Publication part number 6881095C98) to ensure compliance with RF energy exposure limits.
instructions in the Product Safety and RF Exposure booklet enclosed with your radio (Motorola
requirements. Before using this product, read the RF energy awareness information and operating
This radio is restricted to occupational use only to satisfy FCC RF energy exposure
ATTENTION!
Product Safety and RF Exposure booklet enclosed with your radio.
Before using this product, read the operating instructions for safe usage contained in the
PRODUCT SAFETY AND RF EXPOSURE COMPLIANCE
Attaching and Removing the Antenna
Antenna
Threaded End
of Antenna
To Attach Antenna
1. Fasten the antenna to the radio by placing
the threaded end of the antenna into the
Antenna Connector.
2. Rotate the antenna clockwise until tight.
To Remove Antenna
1. Turn the antenna in a counter-clockwise
direction until it disengages from the radio.
Connector
Attaching and Removing the Battery
To Attach Battery
1. Align and fit the battery tongue into the
groove of the chassis of the radio.
2. Secure the latch at the bottom of the radio.
To Remove Battery
1. Unlatch the battery clasp at the bottom of
the radio.
2. Gently lift the hilt of the battery nearest to
the battery latch away from the housing.
3. Slide battery downwards to remove.
Attaching and Removing the Belt Clip
Release Tab
To Attach Belt Clip
1. Align mounting rails of the radio with the
grooves of the belt clip.
2. Slide the belt clip downwards until it clicks
into place.
To Remove Belt Clip
1. Lift the release tab.
2. Slide the belt clip upwards.
Charging your Radio
Charger Pocket
1. Turn off your radio and the A/C power supply to your charger (if they are turned on).
2. Place your radio in the charger pocket.
3. Turn on the charger’s A/C power supply.
4. While charging your radio, the charger’s
LED shows a steady red light. The radio
should be charged at least 16 hours initially
before decreasing charging time to 12 hours.
5. Turn off the charger’s A/C power supply,
and remove the radio from the charger
pocket.
6. For more details, refer to the Charger
Manual (6881013Y27).
LED Indicator
• Colors indicate various states
of the radio
On/Off and Volume Knob
• Turn clockwise to turn radio ON
and increase volume.
• Turn counter-clockwise to decrease
volume and turn radio OFF.
Push-to-Talk (PTT) button
• Press to transmit and release
to receive messages.
Programmable Buttons
• Frequently used features can
be programmed here.
Accessories
Types Part No. Description
PMAD4050_R Mag One 136-150MHz Antenna
Antenna PMAD4051_R Mag One 150-174MHz Antenna
PMAE4019_R Mag One 403-425MHz Antenna
PMAE4020_R Mag One 450-470MHz Antenna
Audio Accessory PMMN4008_ Remote Speaker Microphone
PMLN4442_ Earbud with in-line mic and PTT/VOX
PMLN4443_ Ear Receiver with in-line mic and PTT/VOX* Switch
PMLN4445_ Ultra Lightweight Headset with In-line PTT/VOX
PMLN4294_ Earbud with Microphone & PTT Combined
PMLN4605_ Clear Acoustic Kit
PMLN4606_ 2-Wire Surveillance Kit with Clear Acoustic Tube
PMLN4658 _ D-shell Earset with Boom Mic with PTT/VOX
Battery PMNN4071_R Mag One NiMH batt 1200mAH
Carry Accessory
Charger PMLN4685_R Mag One Mid-rate Charger Base Only
*Caution: Your radio does not support the VOX feature. Please set the accessory switch to ‘PTT’. If the accessory switch
is set to ‘VOX’, your radio transmits constantly and never receives.
PMLN4743_ Mag One Spring Belt Clip
PMLN4691_R Mag One Belt Clip
PMLN4741_ Mag One Soft Leather Carry Case
PMLN4742_ Mag One Hard Leather Carry Case
PMLN4738_R Mag One Mid-rate Charger Kit, 120 V
PMLN4682_R Mag One Slow Charger Base Only
PMLN4683_R Mag One Slow Charger Kit, 120 V
PMLN4829_R Mag One Mid-rate Transformer, 120 V
PMLN4822_R Mag One Slow Transformer, 120 V
Channel Knob
• Turn knob to change channel.
Accessory Connector
• To connect compatible accessories to radio.
Programming Port
• To program the radio.
Speaker
• Where received messages are
heard.
Microphone
• Speak into microphone when sending message.
* Switch
* Switch
* Switch
LED Indicators
Colour State Indication
Red Illuminated Radio is transmitting.
Blinking Battery voltage is low.
Green Illuminated Radio is receiving with PL/DPL disabled.
Blinking Radio is in active scanning mode.
Orange Illuminated Radio is receiving with PL/DPL enabled.
Blinking An error has occured.
Audio Alert Tones
Tone Name Tone Cadence Description
In Chirp Tone Programmable buttons are pressed.
Out Chirp Tone
Bad Key Chirp
Ton e
Talk Prohibit
Ton e
Low Battery
Alert Tone
Priority
Channel Alert
Ton e
Low Tone High Tone
Programmable buttons are pressed.
Invalid programmable button function (i.e. pressing
programmable button while button lock is activated.)
Continuous tone is heard if PTT is pressed when transmit is
not allowed.
Repeating tone heard if battery level is low.
Received priority channel in Priority Scan mode.
Programmable Buttons
• The following functions can be assigned as short press (press and release) or long press (press and hold
for 1 second) in the programmable buttons.
Button Function
†
High/Low Power
Volume Set Allows you to check the audio and alert tone volume level.
Monitor Allows you to monitor the current channel for activity; disables squelch.
Sticky Monitor
Scan
Nuisance Channel Delete
Repeater/Talkaround
PL/DPL
Button Lock
Battery Save Mode
Squelch
No Operation No function is programmed to this button.
† In Chirp Tone
* Out Chirp Tone
*
Selects desired power level to High
The radio monitors continually until you press this button again.
Starts* or Stops† channel scan.
†
Removes unwanted channel(s) temporarily from scan list during scan.
Toggles radio between functioning in Repeater mode† or Talkaround mode*.
†
/Disables* radio from requiring matching PL/DPL to receive messages.
Enables
Locks* or unlocks† all buttons except PTT, Channel Knob and On/Off/Volume Knob.
Toggles between functioning with Battery Saver ON
Selects desired squelch level: Normal† or Tight*.
• Your radio’s default functions are described below. If re-programmed, enter the new functions .
Press Type Programmable Button 1 Programmable Button 2
Default Re-programmed Default Re-programmed
Short Press Monitor Scan
Long Press Sticky Monitor Nuisance Channel Delete
or Low
*
.
*
or Battery Saver OFF†.
Loading...