Motorline MR17 User's And Installer's Manual

MR17

USER’S AND INSTALLER’S MANUAL

Button

Led

Antenna

Single-wire
antenna
Ø1,5mm

7 8

The MR17 receiver can operate
electrical and electronic equipment
remotely, with one or more commands
(by radio).

• CHARACTERISTICS FRAME

• Operation Frequency 433,92 MHz

• Power Supply 12-24Vac/dc

• Maximum Consumption 40mA to 24V

• Code type 12 Bit or Rolling Code

• Tx Codes memorization (CH1 + CH2) 500 Máx.

• Relay 30Vdc 1A

• Temperature -25°C to +55°C

• Range in open space 50-100m

• Protection Grade IP 42

1 2 3 4

12/

NO0V

24

Power Supply

/V

Start

NO

LEGEND OF THE CONECTORS

01 • Power supply 12-24Vac/dc
02 • Power supply 0V
03 • Contact output CH1 - NO
04 • Contact output CH1 - NO

TYPE OF CHANNEL OPERATION

The receiver has the ability to operate in monostable and bistable mode.
In the default settings, the receiver is set to operate in monostable mode.

To change to bistable:

01 • Unplug the receiver.
02 • Press the programming button continuously.
03 • Holding down the button, plug again the receiver.
04 • The LED will flash once, confirming the change of mode.
NOTE • To return to monostable, repeat the previous operation.

EN

PROGRAMMINGRECEIVER INSTALLATION

It is very important to choose the place of installation
carefully in order for the transmitter and the receiver to
function well. Capacity is not only conditioned by the
technical features of the device, but also varies depending
on the radio-electric conditions of the place.
The receiver is provided with a local antenna. If you choose

03

02

an external antenna, it should be positioned on the outside,
in highly visible spots and away from metal structures.
You can not install two receivers if not respected a minimum
distance of 5 meters between them.

Installation:
01 • Fix the support on the wall.
02 • Place the board on the suport, sliding it between the

existing support ledges.
03 • Place the cover to close.

01

PROGRAMMING

• COMMAND PROGRAMMING

Programming of the radio controls must be carried out with the antenna disconnected, up to a
maximum number of 500 codes.

• ACTIVATE THE OUTPUT

When you press the key of a command recorded in the receiver, the output will be activated for 1

second in the monostable mode, and it will change state in the bistable mode.

• RESET THE RECEIVER

To delete all commands in memory, press the button for 10 seconds. The output will be activated

for one second and the led will flash 5 times.

01 • Press the
programming button
once.

Led stays on: programming is complete.
Led blinks rapidly (32 times): Memory is full.

02 • The LED will start
flashing.

03 • Send the code with
the radio control to be
programmed.

EN