Motion Pro 11-0088 User Manual

Process Black

White

Motion Pro, Inc.

867 American Street
Tel [phone]
Fax [phone]
www.motionpro.com

INSTRUCTIONS

MOTION PRO HELMET LOCKS P/N 11-0087 & PN 11-0088

1. Tools needed to install the

helmet lock.

4. Remove the paper backing
and attach the rubber protector
to the back of the helmet lock.

7. Place in desired location
holding the top of clamp in place
and pushing the open end of the
clamp into the threaded end.
Tighten the hose clamp using a
#2 straight slot screw driver.

I11-0087 012014

2. Place the rubber protector
around the tube to determine
the correct length required.

5. Install the hose clamp as
shown in the photo.

8. Attach the plastic cover using
the two small Phillips screws.

NOTE: If your desired location requires a larger clamp the helmet
lock will accept standard 1/2 in (12.7 mm) hose clamps.

3. Trim the end of the rubber
protector to the correct length
with scissors.

6. Attach the rubber protector to
the underside of the hose clamp.

Installation is complete.