Motion Pro 11-0008 User Manual

MOTION PRO PEDAL ANCHOR KIT 11-0008

DIRECTIONS TO INSTALL

1 - Drill 1/16” hole in front, outside, part of brake pedal or shift lever.
2 - Thread cable up through hole in pedal until soldered end pulls up against pedal.
3 - Slide tubing over cable.
4 - Slide special crimp fitting onto cable.
5 - Find suitable location forward of the pedal on frame tube, motor mount, or pipe

bracket for other end of cable. Loop cable around mount (you may have to drill
additional 1/8” hole) and back through crimp fitting.

6 - Move pedal throughout complete travel making sure that cable does not impede
movement. Use vise grips or suitable pliers and squeeze crimp fitting onto cable.

I11-0008 09/2010