Motion Pro 08-0431 User Manual

until
all of the holes have been cut.
SNOWMOBILE TRACK CUTTING TOOL & STUD INSTALLATION TOOL
P/N 08-0430 & 08-0431
Thank you for purchasing the Motion Pro Track Cutting Tool, P/N 08-0430 and Stud Installation Tool, P/N 08-
0431. These tools will allow you to cut clean and precise holes in your snowmobile track and install studs with a head diameter up to 1-1/4” and stud length up to 1-7/8”.
Using the Track Cutting Tool P/N 08-0430
3-Slide the Track Cutting Tool P/N 08-0430 over
2-Using a paint pen, mark the track all the way around with the template supplied by the stud manufacturer.
4-As you cut, the handle of the tool will capture and store up to 150 track plugs. Remove the cap from the handle of the tool to remove the plugs. Compressed air can be used to remove any stuck plugs. Remember to wear eye protection to protect yourself from plug-projectiles!
I08-0430 1 of 2 09/2010
the edge of the track and cut holes in the track by rotating the handle of the tool clockwise. Rotate the track to a new area and repeat the procedure
Using the Stud Installation Tool P/N 08-0431
tool apart until the head of the stud is pushed flush
stud manufacturer’s specifications.
1-Push the studs into the holes in the track by hand until the tip protrudes and there is enough tension to hold the stud in place while you position the Stud Installation Tool P/N 08-0431.
2-Position the Stud Installation Tool over the stud so that the borehole of the tool is over the tip of the stud and the round platform is under the head of the stud (underside of track).
3-Using both hands, spread the handles of the
with the underside of the track. Rotate the track to a new area and repeat the procedure until all of the studs have been pushed into place.
I08-0430 2 of 2 09/2010
4-Install the stud plate and nut onto each stud, and tighten each nut down according to the
Loading...