Moticon INSOLE1 User Manual

Instructions

OPENGO

SENSOR INSOLE

WARNING

See the detailed product information

!

and tutorial videos in the support

section of the moticon homepage

www.moticon.com/support

Do not use a sharp object to remove

!

user-replaceable coin cells.

Contact your local waste disposal

!

department to properly recycle the coin

cells. Perchlorate material, special

handling my apply.

1

Warnings

Warnings

WARNING

Remove the coin cells when you have

!

finished your measurements.

Store the sensor insole only without

coin cells.

The coin cell compartment must face

!

down when inserting a sensor insole

into a shoe.

!

The sensor insole does not need

maintenance and must only be cleaned

as described here

www.moticon.com/support

2

NOTICE ON RISKS ON HEALTH

The OpenGo sensor insole is no

!

orthotic. In case an orthotic is used,

consult your doctor if it can be replaced

by a OpenGo sensor insole.

Only wear a left and a right sensor

!

insole in order to avoid asymetric gait.

Only wear OpenGo sensor insoles with

!

socks to avoid skin irritation.

Only wear OpenGo sensor insoles in

!

the right size and in closed footwear.

3

Warnings

Warnings

NOTICE ON RISKS ON HEALTH

Immediately stop using OpenGo sensor

!

insoles if skin irritation or pain appears.

Do not wear OpenGo sensor insoles
with open foot ulcers or wounds.

Do not wear OpenGo sensor insoles for

!

driving cars or climbing ladders.

Do not wear OpenGo sensor insoles if

!

strong foot sweat appears and do not

expose sensor insoles to humidity.

4

The OpenGo sensor insole is a fully integrated
sensor insole. It is completely wireless

and hence does not interfere the wearer‘s

motion.

The sensor insole measures the plantar

pressure distribution, total loads and the
acceleration of the foot.

5

OpenGo sensor insole overview

wireless

precise

ultra flat
& robust

Specifications

Coin cell type User-replaceable PD2032 (rechargeable),

3.7 volts

Coin cell life Up to 29 hours, depending on operation

mode

Operating From 10°C to 40°C
temperature
range

Radio frequency/ 2.4 GHz ANT wireless
protocol communications protocol

Water resistance No, cleaning with liquid sanitizer

6

Coin cell charger

Power supply

Coin cells

Coin cell Coin cell charger

Model PD2032
Type rechargeable

Voltage 3.7 V

Capacity 75 mAh
Cycles 400 (70 %)

7

Model wall adapter
or other

Type CC / CV

Charge voltage

4.2 V

OpenGo sensor insoles should exclusively

be operated with rechargeable coin cells !

Primary coin cells (batteries) may cause mal-

function due to a much faster voltage drop !

You need 1 coin cell model PD2032 for each

sensor insole.