mothercare Denim Brights User Manual

denim brights
bouncing cradle

user guide

WARNING - Important
Keep for future reference

1

introduction

This bouncing cradle is designed for babies who cannot sit up by
themselves (up to 9 months / 9kg approximately).
The cradle features hanging toys for your child’s entertainment,
and a soothing vibration unit.

Warning! - Do not use once baby starts to sit up unaided, and never
pick the cradle up by the toybar.

2

parts checklist

diagram description

Base frame with vibration unit

Backrest frame

Seat cover

Head support cushion

1

Toybar and toys

3

Note: If you wish to use the vibration feature right away, please install the
batteries in accordance with section 6 prior to assembly.

1

2

preparation for use

Pull bar (A) right around until it locks into place
against the hinges.

Next, lower the footrest frame.

When fully open, the frame will look as shown
in diagram 2 below.

Place the frame on the floor with the open
tubes pointing upwards.

Insert the ends of the backrest frame into
these open tubes.
The retaining buttons will 'click' through holes
in the lower tubes when properly located.

Lift the footrest frame to the upright position.

3

The seat cover has two ‘sleeves’.
Slide the larger of these over the backrest
frame bar and the smaller sleeve over the
footrest frame.

4

Press the footrest down towards the floor
until it locks into place, holding the seat
cover taut.

2

3

preparation for use

attaching the toybar

5

head support cushion

6

When attaching the toybar to the cradle,
ensure the toybar frame points upwards
(not forwards), and fit the clips to the frame
just above the plastic
hinges.

The head cushion is provided to give support
to your child's head while using the bouncing
cradle. Position so it fits snugly behind your
child's head.

3