mothercare adjust with me highchair User Manual

‘adjust with me’ highchair

user guide

IMPORTANT! KEEP FOR FUTURE REFERENCE

introduction

The Mothercare Adjustable High Chair has been designed to comfortably seat
your baby from the time they can sit up by themselves (around 6 months) well into
their teenage years.

This product has been manufactured from wood and as such will naturally darken
with age.

This high chair conforms to BSEN14988: 2006

important notes

As all children grow differently, the height of this product can be adjusted to suit
your child’s individual needs. Before assembling the high chair please take a few
moments to select the best seat and foot rest positions for your child. The below
guide has been written to help you select the best positions for the seat and foot
rest for your child’s growth stage.

stage 1
6-9 months = Seat in slot 1, Footrest in slot 4 (safety bar and crotch
restraint must be used)

9- 12 months = Seat in slot 2, Footrest in slot 5 (safety bar and crotch
restraint must be used)

3 Years = Seat in slot 2, Footrest in slot 7 (safety bar and crotch
restraint must be used)

stage 2
6 Years = Seat in slot 3, Footrest in slot 10

stage 3
12 Years and over = The Footrest should be used as a seat and would
normally be positioned between slots 4 and 6

You can work out the number of the slot by counting downwards from the top of
the legs.

1

parts checklist

Please take a few minutes to read this user guide before attempting to assemble
your product. Unpack your product carefully onto a soft level surface, such as a
carpeted oor. Familiarise yourself with the parts by comparing them with the
parts check list. Do not discard any packaging until you are sure you have all the
parts shown in the parts check list.

g 1a

Upper seat back rest

Left and right legs

g 1d

Safety bar

g 1g g 1h

Wooden brace Metal brace x 2 Allen Key

g 1j

g 1b

Lower seat back rest

g 1c

g 1e g 1f

Seat

Foot rest

g 1i

g 1k

g 1l

Barrel nut x 6 Screws x 10

Crotch restraint

g 1m

Cushion seat section Cushion back rest section

g 1n

2

assembling the highchair for stage 1

g 2

Insert a barrel nut into the predrilled
holes at either end of the wooden brace,
using a at head screw driver to ensure
that the slot is horizontal. Then using
the Allen key and screws provided,
attach the wooden brace to the legs.

Please note: do not fully tighten any of
the screws yet.

g 3

Slide the smaller loop of the crotch
restraint over the metal brace that you
intend to use in the highest position.
Then using the screws provided,
attach both metal braces to the legs.

3

assembling the highchair for stage 1

g 4

Select the desired position and rmly
push the seat into the chair frame until
the front of the seat is level with the front
of the high chair. Please ensure that the
seat isn’t twisted by selecting slots of
a corresponding height and that the
rear of the seat extends past the legs
by at least 20mm.

g 5

Slip the seat cushion over the seat
ensuring that the crotch restraint slots
line up and both ends of the seat
are completely covered.

4

assembling the highchair for stage 1

g 6

Thread the end of the crotch restraint
though the seat and cushion from
underneath.

g 7

To t the safety bar, slide the safety bar
through the crotch restraint then insert
the safety bar into the slots at the top of
each leg, making sure the bar is curving
toward the front of the highchair.

5