Mosmatic FL-CR 750 Installation Manual

TD - 80772 A

© MOSMATIC AG 08.03.2007 Subject to change without notice

FL-CR 750

No. 80.772

Assembly instructions

Commercial Surface Cleaner

For your own safety

- Read all instructions before the initial operation. Check their
proper condition and that they operate safely.

- Always use protection gear when using products connected to
high pressure.

- Before any maintenance or nozzle-change, turn off the high
pressure water supply, e.g.: turn of f and secure the

power switch.

- After turning off the system, allow all self propelled equipment
to come to a complete stop before handling.

- Safety regulations and guidelines (Accident Prevention Rules)
from the manufacturer of your high pressure cleaner are
applicable.

- Nozzle installation according to nozzle manufacturer.

- Do not move the unit over objects or uneven surfaces.

- Do not lift up the unit while operating.

- Do not run the unit if spray-arm is out of balance or bent,
damage to the swivel will result.

- No modifications to the unit are permitted.

1. Slide the upper fork (a) over the lower fork (b). Secure the two
forks with the bolt (c) and the safety nut ( d).

Note: the handle (e) and the ring (f ) point in the same direction.

2. Connect the HP-gun (g) with the preinstalled adapter (h) to the
quick connect (i).

3. Install the assembled fork (a+ b) with the two bolt s (k) and the
two safet y nuts (l) onto the fork holder (j). Works best if handle
is in vertical position.

4. Connect the HP hose (m) with the quick connect (n) to the
swivel (o).

o

n

c

h

i

g

e

a

d

m

b

l

j

k

e

f

( This instruction is valid for the base model as well as for
the resulting versions)

FL-CR 750

No. 80.772

TD - 80772 A

© MOSMATIC AG 08.03.2007 Subject to change without notice

Commercial Surface Cleaner

Spare parts List

Pos. Part No. Description

1 55.253 Swivel DYC
2 36.906 Carbide seal-kit
3 50.155 Quick-connect M22-F - G1/4"F
4 50.903 Quick-connect M22-F - G1/4"M
5 51.278 Adapter M22-M - 1/4"NPT-M
6 29.081 HP-gun 4000 psi
7 901.953 HP-hose G1/4"M - G1/4"M
8 82.943 Turbo-rotor-arm Dia. 27.5"
9 901.662 Brush ring
10 1503 HP-nozzle 1503
11 80.912 Stainless steel castor

2

3

4

5

6

9

10

7

8

11

1