MORryde STP54-011, STP54-012, STP54-010, STP214-029H, STP214-006H Pre-installation Instructions
STEP
QUICK CONNECT STEP
STEP2STEP
PRE-INSTALLATION INSTRUCTIONS
Will the Quick Connect Step work for your RV? Please review the steps below.
MOUNTING SPACE
Measure the space between
the bottom of the threshold
1
and the bottom of the skirt.
A minimum distance of 1.75"
is required to attach the steps.
1 .75"
NOTE: The steps will not work for
doors with trim under the threshold.
INTERNAL FRAMING
The brackets require
structural reinforcement
behind the skirt metal
and below the threshold.
Units that do not have
any reinforcement for
the brackets will require
modification. For questions
contact our Parts Department
at 574-293-1581.
Skirt metal
Threshold
3
STEP HEIGHT
Measure from the top of
the threshold
Refer to the Fit Chart below
for the corresponding Quick
Connect Step part number.
to the ground.
Threshold
Ground
If you have met the requirements above, use the dimensions from Step 3 to locate your
part number in the fit chart below.
PART STEP
NUMBER HEIGHT
2 STEP
3 STEP
4 STEP
STP54-011 21.5" – 27.5"
STP54-010 27.5" – 36"
STP54-012 35.5" – 44"
OPTIONAL HANDRAILFIT CHART
3 STEP
HANDRAIL
STP214-029H
4 STEP
HANDRAIL
STP214-006H
Please contact us if you have any questions:
574-293-1581 | www.MORryde.com
INSTALLATION INSTRUCTIONS
Please take a moment to review the Quick Connect Step Pre-Installation Instructions on the front side of this form before
proceeding with these Installation Instructions.
TOOLS REQUIRED: 3/8 drive socket
STEP 1
Line up the first bracket
with the outside edge
of the door. Verify the
placement of the bracket
by properly positioning
the steps; also confirm
clearance of the door. If
satisfactory, install the first
mounting bracket using
the supplied hardware.
NOTE: The two brackets are identical. For proper installation,
mount both brackets with the bar oset to the left.
Both brackets will be mounted with the bar oset to the left.
Bar
Outside
edge of
door
Bracket
STEP 2
Press in the paddle latch and
attach the step to the bar on the
bracket that was first installed;
you will use this as a guide for the
location of the second bracket.
With the steps in position, mount
the second bracket.
Paddle
latch
TO RELEASE THE STEPS:
Press in the paddle latches and pull back to remove the step from the mounting brackets.
WARNING
all responsibility of verifying the safety and viability of any installation method and mounting surface. MORryde is
not liable for property damage or injury caused by incorrect mounting, installation methods not recommended by
MORryde, hardware not provided by MORryde, or incorrect use during travel or otherwise.
Improper installation may cause property damage or personal injury. The Installer assumes
If you have any questions, please give us a call at 574-293-1581 or send an email to parts@MORryde.com.
574.293.1581 • www.MORryde.com
574.293.1581 • MORryde.com
Loading...