Steam Mop & Cleaner
Please read and keep these instructions
If you have a problem or complaint, please call our dedicated UK based helpline
before returning your product to the retailer from where it was purchased.
UK Helpline: 0844 871 0960
Replacement Parts: 0844 873 0726
Ireland Helpline: 1800 409 119
Limescale
•
•
•
Naturally occurring minerals in tap water can result in a build-up of limescale inside all water
heating appliances. This can affect performance and, with time, could result in blockages
that could stop the product working. To prevent this possibility, we strongly recommend
using distilled/de-ionised water in this steam cleaner. This is especially important in hard
water areas.
Distilled/de-ionised water should be obtainable from most large supermarkets.
If distilled/de-ionised water is not used, then after approximately each ten uses, the boiler
and steam outlet must be cleaned as described on page 7. Failure to do so may
invalidate the warranty.
Upon registration with Morphy Richards
(UK & ROI only)
Register online for your 2 year
guarantee. See back of this
instruction book for details.
(UK and Ireland customers only)
www.morphyrichards.co.uk
VC70490 MUK Rev 1
www.homeofthehouseproud.com
www.facebook.com/LoveYourHome
www.twitter.com/MRLoveYourHome
For competitions, product hints and tips and much more,
join us online at our blog, Facebook or Twitter pages.
VC70490MUK Rev1_Instruction Booklet 04/01/2011 11:54 Page 1
2
UK Helpline 0844 871 0960 Replacement Parts 0844 873 0726 Ireland Helpline 1800 409 119
FEATURES
⁄ Hanger strap
¤ Variable steam setting
‹ Control switches
(see Ù/ı/ˆ/˜)
› Power cord holder
(with quick release)
fi Water tank filler cap
fl Power cord
‡ Water tank
· Lower handle
‚ Fold-out power cord holder
„ Lock button
‰ Floor head
 2x Floor cloth grips
(set on either side)
Ê Brush sliders
Á Steam release valve
(located on rear)
Ë Floor cloth (for hard floors)
È Floor cloth (for carpets)
Í Elasticated utility cloth
Î Squeegee nozzle
Ï Utility nozzle
Ì Deflector nozzle
Ó Spot brush
(with 2x spare brushes)
Ô Nozzle cleaning pin
Boiler cleaning brush
Ò Detachable steam comb
attachment
Ú Detachable carpet glide
base attachment
Û Water filling funnel
⁄
›
fi
fl
‡
·
‚
Â
„
‰
Â
Ê
Í
ÎÏ
ÌÓ Ô
Ò
Ú
Û
Á
Ë È
‹
Ù ON/OFF switch
ı STEAM switch
ˆ Power ON light (red)
˜ Steam ready light (green)
¤
Sideways view
Ùı
ˆ˜
VC70490MUK Rev1_Instruction Booklet 04/01/2011 11:54 Page 2
3
For details of other Morphy Richards products, please see our website:
OPERATING THE APPLIANCE
Please remember that the steam cleaner
operates by emitting steam at an increased
temperature of 115oC. Never use it on objects
or surfaces which cannot resist this
temperature, or on delicate materials such as
dralon, plastic, natural fur etc.
If in doubt, check carefully on a part of the
material where minor marks will not matter.
FILLING THE WATER TANK
In hard water areas, we strongly recommend
using distilled or de-ionised water (available
from larger supermarkets). This will prevent
limescale build-up which with time will affect
the performance of the cleaner. Problems
caused by limescale are not covered by the
guarantee.
1 Remove the tank filler cap by unscrewing it
anti-clockwise and fit the funnel provided.
2 With the cleaner held at around 45°, pour the
water into the funnel. The maximum capacity is
0.8 litres of water which will give more than 30
minutes of steaming. Use less water if required.
Do not overfill.
3 Remove the funnel and refit the cap. Press the
black centre of the cap to ensure the air valve is
free. This valve prevents water escaping but
allows air into the tank. Test this valve by
pressing the centre after every filling.
ASSEMBLY
1 Depending on the task, decide on the nozzle
and prepare the nozzle as shown in later
sections (pages 4-6). To fit the nozzle to the
main body, align the hole in the nozzle with the
lock button „ on the main body. Press the lock
button in and then push the nozzle fully on until
the lock button clicks into place A.
USING THE PRODUCT
WARNING: Before switching ON, make sure
the nozzle is located in safe area and away
from persons. Steam will be emitted after
around 30 seconds.
1 Press the ON/OFF switch Ùand the red power
ON light ˆwill illuminate. The boiler will start
to heat but no steam will be emitted.
2 Press the STEAM switch ı, after about 30
seconds when the boiler is up to temperature,
the water pump will start, the green steam
ready light ˜will illuminate and steam will be
emitted.
3 The steam output
can be regulated
using the variable
steam setting
control on the side
of the handle B.
When using on hard/wooden floors, we
recommend setting to minimum steam to
prevent the floors becoming too wet.
• To stop the steam, switch either switch to the
OFF position Ù. For quick breaks, we suggest
just switching OFF the STEAM switch ıs.
After switching the cleaner to OFF, steam will
continue to be emitted for a few seconds until
the boiler is empty.
WARNING: Switch OFF and unplug before
changing nozzles. After use, nozzles will be
very hot, allow to cool before handling.
CARPET CLEANING
IMPORTANT: Carpets should be dry vacuumed
thoroughly before using the steam cleaner.
For freer movement of the steamer over larger
carpeted areas, the carpet glide base
attachment Ú can be used.
1 Detach and remove the steam comb section Ò
from the carpet glide attachment.
2 Fold the floor cloth (for carpets) È and place
inside the carpet glide base ÚC.
C
A
B
VC70490MUK Rev1_Instruction Booklet 04/01/2011 11:54 Page 3
Loading...