○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Stainless steel kStainless steel k
Stainless steel kStainless steel k
Stainless steel k
ettleettle
ettleettle
ettle
Please read and keep these instructions
getting the best from your
new kettle...
Empty the water out of the kettle after the
first boiling
T o clean away any deposits that are left in the kettle after the manufacturing
process
Descale as appropriate for the hardness of the
water in your area
It is important to descale as the performance of the kettle and auto
switch-off will be impaired
Safety first
Always pour water slowly and carefully to prevent the splashing of
scalding water
Fast boil kettles perform differently
If your kettle is a fast boil model, it may sound louder during boiling and
switch off suddenly with no after noise - this is normal
www.morphyrichards.co.uk
Important safetyImportant safety
Important safetyImportant safety
Important safety
○○○○○○○○○○○○○○○○○○○○○
instructionsinstructions
instructionsinstructions
instructions
The use of any electrical appliance
requires the following of basic common
sense safety rules.
Primarily there is danger of injury or
death and secondly the danger of
damage to the appliance. These are
indicated in the text by the following two
conventions:
WARNING: Danger to the person!
IMPORTANT: Damage to the
appliance! In addition we offer the
following safety advice.
○○○○○○○○○○○○○○○○○○○○○
LocationLocation
LocationLocation
Location
• Always locate your kettle away from
the edge of the worktop.
• Ensure that the kettle is used on a
firm, flat surface.
• Do not locate the base unit on a metal
tray or metal surface.
○○○○○○○○○○○○○○○○○○○○○
Mains leadMains lead
Mains leadMains lead
Mains lead
• The mains lead should reach from the
socket to the base unit without
straining the connections.
• Do not let the mains lead hang over
the edge of the worktop where a child
could reach it.
• Do not let the lead run across an open
space e.g. between a low socket and
table.
• Do not let the lead run across a cooker
or toaster or other hot area which
might damage the cable.
• Do not place the kettle where the
mains lead could fall into a sink.
○○○○○○○○○○○○○○○○○○○○○
Your safetyYour safety
Your safetyYour safety
Your safety
• Always pour hot water slowly and
carefully without tipping the kettle too
fast to prevent splashing and spillage.
• Extreme caution must be used when
moving a kettle containing hot water.
• Do not touch hot surfaces, use handles
or knobs.
• Always close the lid securely, other
wise the kettle may not switch off
automatically andmay spit out boiling
water.
• Avoid contact with steam from the
spout when the water is boiling or just
after it has switched off.
• Take care if opening the lid for re-filling
when the kettle is hot. Do not fill above
the MAX mark, otherwise boiling water
may be ejected.
• Do not hold the switch in the on
position or tamper with the switch to fix
it in the on position as this may cause
steam to be ejected and could damage
the switch-off mechanism.
• Unplug from the electrical outlet when
cleaning.
• Allow to cool before putting on or
taking off parts and before cleaning.
○○○○○○○○○○○○○○○○○○○○○
ChildrenChildren
ChildrenChildren
Children
• Never allow a child to operate this
appliance.
• Children are vulnerable in the kitchen
particularly when unsupervised and if
appliances are being used or cooking
is being carried out.
• Teach children to be aware of dangers
in the kitchen, warn them of the
dangers of reaching up to areas
where they cannot see properly
or should not be reaching.
○○○○○○○○○○○○○○○○○○○○○
Treating scaldsTreating scalds
Treating scaldsTreating scalds
Treating scalds
• Run cold water over the affected area
immediately. Do not stop to remove
clothing, get medical help quickly.
○○○○○○○○○○○○○○○○○○○○○
Other safety considerationsOther safety considerations
Other safety considerationsOther safety considerations
Other safety considerations
• To protect against fire, electric shock
and personal injury do not immerse
2
cord, plugs or kettle in water or other
liquid.
• Do not operate any appliance with a
damaged cord or plug or after it has
been damaged in any manner.
• Do not use accessories not
recommended by the manufacturer as
there is a danger of fire, electric shock
or personal injury.
• Do not attempt to connect any other
appliance to the base unit or this
appliance to another base unit.
• Do not tamper with the connector in
any way.
• Do not use the kettle for any use other
than to boil water.
• Do not use outdoors.
• Do not place on or near a hot gas
electric burner or in a heated oven.
• The kettle must not be on the base unit
when being filled with water.
• The mains lead of the cordless base
cannot be repaired. If the mains lead is
damaged, the cordless base should be
discarded and replaced. Unplug from
the electrical outlet when not in use.
○○○○○○○○○○○○○○○○○○○○○
Electrical requirementsElectrical requirements
Electrical requirementsElectrical requirements
Electrical requirements
Check that the voltage on the rating
plate of your appliance corresponds with
your house electricity supply which must
be A.C. (Alternating Current).
If the socket outlets in your home are
not suitable for the plug supplied with this
appliance, the plug should be removed
and the appropriate one fitted.
WARNING: The plug removed from
the mains lead, if severed, must be
destroyed as a plug with bared flexible
cord is hazardous if engaged into a
live socket outlet.
WARNING: This appliance must be
earthed.
Should the fuse in the 13amp plug
require changing, a 13amp BS1362 fuse
must be fitted.
3
○○○○○○○○○○○○○○○○○○○○○
FeaturesFeatures
FeaturesFeatures
Features
Lid
Lid knob
Lid release button / lever
Spout
Spout filter
Concealed element
360o connector
Cordless base unit
Cord storage
On/off switch
Power on neon
Cool touch handle
Integrated twin water level indicators
Integrated water level indicator
Essentials traditional
Cool steel jug
Essentials jug
○○○○○○○○○○○○○○○○○○○○○
Using
1 Lift up the lid and fill the kettle.
The integrated water level gauge/
viewing lid (on certain models) allows
you to easily see the amount of water
in your kettle.
• Always put enough water to cover the
bottom of the kettle, minimum 1 cup
200cc.
• Boil only as much water as you need
as this saves electricity.
2 Place the kettle on the base unit,
ensuring the kettle locates on to the
360o connector.
• The 360o connector allows the kettle
to be located at any position - ideal for
left and right handed users and
convenient positioning on your
worktop.
3 Plug in and switch on at the wall
socket.
4 Switch the kettle on. The ‘power on’
indicator neon will light up.
5 When lifting the kettle from the base
unit by the handle ensure you hold
the kettle level.
• To reboil, switch to ON again. If the
kettle has just switched off wait
several seconds or so before
switching it back on again.
• If you do not put in enough water, or
switch on the kettle when it is empty,
the safety cut-out will switch off the
power automatically. If this happens,
wait a few minutes for the element to
cool, then refill and use as normal.
○○○○○○○○○○○○○○○○○○○○○
Filter removal
1 Open the lid.
2 Lift the filter upwards from its location
using the tab provided.
3 To refit the filter, slot into the side wall
guides and press down firmly. Ensure
the filter is correctly located into the
central guide.
Cool Steel kettle
1 Open and support the lid.
2 Pull the filter downwards from its
location.
3 To refit the filter locate the filter into
thegrooves and click into place.
Note: Which way you have removed
the filter and replace the same way
after cleaning.
Warning : Unless the filter is fitted
correctly, the kettle lid may not
close and lock securely.
○○○○○○○○○○○○○○○○○○○○○
Cleaning the filter
1 To clean the filter run warm water over
the mesh and scrub lightly to remove
the soft deposits with a suitable brush.
A toothbrush would be ideal.
2 If the soft lime deposits have become
hard, the filter will need descaling, see
descaling page 5.
4
5 Wipe the outside of the kettle
thoroughly with a damp cloth to
remove all traces of acid which may
damage the finish.
IMPORTANT: Ensure that the
electrical connections are completely
dry before using the kettle.
6 Never operate the kettle with the citric
acid crystals in the water.
○○○○○○○○○○○○○○○○○○○○○
Cleaning
WARNING: Always disconnect the
plug from the mains and allow the kettle
to cool down before cleaning.
Wipe the outside of the kettle with a
damp cloth.
IMPORTANT: Do not use abrasive
cleaners on the outside of the kettle which
may scratch the surface.
○○○○○○○○○○○○○○○○○○○○○
Helpline
If you have any difficulty with your
appliance, do not hesitate to call us.
We’re more likely able to help than the
store from where you bought it.
Please have the following information
ready to enable our staff to deal with your
query quickly.
• Name of the product
• Model number as shown on the
underside of the appliance.
○○○○○○○○○○○○○○○○○○○○○
Descaling
IMPORTANT: As this kettle is fitted
with a concealed element it must be
descaled as and when appropriate. This
depends on usage and the hardness of
the water in your area.
Scale can cause the kettle to
malfunction and may damage the
element invalidating the warranty.
It is essential that regular descaling
takes place.
Remove hard scale using either a
proprietary descaling product suitable for
plastic kettles (following the instructions
carefully), or citric acid crystals.
We recommend using citric acid
crystals (available from most pharmacies)
as follows,
1 Fill the kettle to the 1 litre mark, boil,
then unplug the kettle (remove the
cordless kettle from the base unit) and
stand it in an empty sink or bowl.
2 Remove the filter and drop it into
the water. This will allow the filter to
be descaled at the same time.
3 Add 50gm of citric acid crystals to the
water gradually, then leave the kettle
to stand. Do not use a more
concentrated solution.
4 As soon as the effervescence
subsides, empty the kettle and rinse it
thoroughly with cold water.
Take care to wash the filter thoroughly,
then replace back into its location slot
(see filter removal page 4).
IMPORTANT - never operate or boil
the kettle with the filter in the base of
the kettle, the hot element plate will
melt and damage the filter.
5
Your two year
○○○○○○○○○○○○○○○○○○○○○○
guarantee
• It is important to retain the retailers
receipt as proof of purchase. Staple your
receipt to this back cover for future reference.
Please quote the following information if the
product develops a fault. These numbers can
be found on the base of the product.
Model No. Serial No.
All Morphy Richards products are individually
tested before leaving the factory . In the unlikely
event of any appliance proving to be faulty within
28 days of purchase it should be returned to the
place of purchase for it to be replaced.
If the fault develops after 28 days and within
24 months of original purchase, you should
contact the Helpline number quoting Model
number and Serial number on the product, or
write to Morphy Richards at the address shown.
Y ou will be asked to return the product (in
secure, adequate packaging) to the address
below along with a copy of proof of purchase.
Subject to the exclusions set out below (see
‘Exclusions’) the faulty appliance will then be
repaired or replaced and dispatched usually
within 7 working days of receipt.
If for any reason this item is replaced during
the 2 year guarantee period, the guarantee on
the new item will be calculated from original
purchase date. Therefore it is vital to retain your
original till receipt or invoice to indicate the date
of initial purchase.
T o qualify for the 2 year guarantee the appliance
must have been used according to the manufacturers instructions. For example kettles
should have been regularly descaled.
EXCLUSIONS
Morphy Richards shall not be liable to replace
or repair the goods under the terms of the
Guarantee where:
1 The fault has been caused or is attributable
to accidental use, misuse, negligent use or
used contrary to the manufacturers
recommendations or where the fault has
been caused by power surges or damage
caused in transit.
2 The appliance has been used on a voltage
supply other than that stamped on the
products.
3 Repairs have been attempted by persons
other than our service staff (or authorised
dealer).
4 Where the appliance has been used for hire
purposes or non-domestic use.
5 Morphy Richards are not liable to carry out
an y type of servicing work, under the
guarantee.
6 Plastic filters for all Morphy Richards kettles
and coffee makers are not covered by the
guarantee.
This guarantee does not confer any rights
other than those expressly set out above and
does not cover any claims for consequential
loss or damage. This guarantee is offered as an
additional benefit and does not affect your
statutory rights as a consumer.
• This guarantee is valid in the UK and Ireland
only .
The After Sales Division,
Morphy Richards Ltd, Mexborough,
South Yorkshire, England, S64 8AJ
Helpline (office hours)
UK (local rate) 08450 777700,
Republic of Ireland 1800 409119
Morphy Richards products are
intended for household use only.
Morphy Richards has a policy of
continuous improvement in product
quality and design.
The Company, therefore, reserves
the right to change the
specification of its models at any time.
440/8053/13 Rev 1
Loading...