Morphy Richards IB70240, Aztec 70240 Instructions Manual

Aztec cylinder cleaner
Please read and keep these instructions
getting the best from your new cleaner...
If your cleaner isn’t picking up as well as it should, please check
• Dustbags
• Filters
It is important that the filters are cleaned and replaced regularly to allow air through the appliance
• Blockages
Check the nozzle, tubes and hose for blockages
www .morphyrichards.co.uk
8598 Aztec ib 05/08/2003 10:23 Page 1
Important safety instructions
The use of any electrical appliance requires the following of common sense safety rules.
Primarily there is danger of personal injury and secondly danger of damage to the appliance and property. These are indicated in the instructions text by the following two conventions:
WARNING: Danger of personal injury
IMPORTANT: Damage to the appliance
In addition we offer the following essential safety advice.
Location
• Do not use or keep this product outside
when it is raining.
• Do not store the appliance near hot ovens
or heating appliances.
Mains lead
• Do not allow the mains lead to become
strained or run this appliance over it.
• If the electrical cable becomes damaged
the complete cable assembly must be
replaced. Do not attempt this task
yourself, contact Goblin using the helpline
number.
Children
• Children do not understand the dangers
associated with operating electrical
appliances. Never allow children to use
this appliance.
Other safety considerations
• Never use in the presence of explosive
liquids or vapours.
• Never pick up inflammable or poisonous
liquids such as petrol, copier toner, or
other volatile substances. Never pick up
acids, asbestos or asbestos dust.
• Always disconnect the appliance from the
mains supply after use or prior to cleaning
or replacing dust bags.
• The appliance should never be left running unsupervised.
• Repairs to electrical appliances are only to be undertaken by trained personnel. Unprofessional repairs can be dangerous for users.
• Use only genuine Goblin spare parts and accessories
Product safety
• Never use the appliance without the filter installed.
• Never use the appliance to vacuum hot ashes, broken glass, sharp objects or liquids.
• Never modify the cleaner in any way.
Electrical requirements
Check that the voltage on the rating plate
of your appliance corresponds with your house electricity supply which must be A.C. (Alternating Current).
If the socket outlets in your home are not
suitable for the plug supplied with this appliance, the plug should be removed and the appropriate one fitted.
If you cut off the plug and let go of the
cable it will rewind into the machine. Therefore you must pull out a length of cable and secure it before cutting off the plug and refitting a new one.
WARNING: The plug removed from
the mains lead, if severed, must be destroyed as a plug with bared flexible cord is hazardous if engaged into a live socket outlet.
Should the fuse in the 13 amp plug
require replacement, a BS1362 13 amp fuse must be fitted.
2
8598 Aztec ib 05/08/2003 10:23 Page 2
Components
The models described in these instructions are similar in most respects but some of the features described apply to specific models only.
Carrying handle ¤ Dustbag compartment lid releaseHose inletDustbag condition indicatorAccessory storage Crevice toolUpholstery tool
· Auto cable rewind foot pedalOn/off power foot pedalElectronic power control (certain models)Stair-lock bracket  Dustbag securing tab Ê Motor protection filter Á Filter safety catch Ë Exhaust filter È Hose and handle Í Extension tubes (varies by model) Î Floor nozzle Ï Slider release button (shown on page 4) Ì Air flow regulator
3
¤
·
Â
Ê
Ë
Á
A
fl ‡
or
Î
Í
ÌÈ
8598 Aztec ib 05/08/2003 10:23 Page 3
Using your Aztec
Assembly
To fit the hose to the cleaner, insert the hose end into the hose inlet until it clips securely into position.
Extension tubes
The type of extension tubes provided varies depending on the model you have purchased. Please see carton box or contact the retailer for further details of your specific model.
Plastic tubes (certain models only)
Attach the extension tubes to the handle end of the hose.
Metal telescopic tube (certain models only)
Attach the telescopic tube to the handle end of the hose. Extend to the required length by pressing down the slider release button Ï and pulling out the tube B.
The hose handle features an air flow regulator Ì which allows the suction to be reduced as required.
Attaching the accessories
Fit the floor nozzle onto the end of the extension tube.
Other accessories are stored in the back of the cleaner and include:
• upholstery nozzle for stairs, furniture;
•crevice tool for awkward places, behind
radiators etc.
Automatic cable rewind
Reel out the cable fully. After use, unplug and press the foot pedal ·, holding the plug until fully rewound.
WARNING: When using the cable rewind, always hold the plug as the cable will rewind quickly.
On/off
The on/off control is operated by the foot pedal ‚.
Electronic power control (certain models)
This is a rotating knob which allows the suction power of the cleaner to be set at the precise level required. For example:
• turn fully clockwise for maximum suction
for carpets, hard floors etc.
• turn anti-clockwise for reduced suction
for upholstery and curtains.
Stair Lock
This unique device assists with stair cleaning. The special bracket , found underneath, is lifted out as shown C and locked onto the stairs. In addition, the rear wheels are locked in position as further security. After use, simply push firmly back into position.
Please note
When cleaning on stairs, for convenience and safety, work from the bottom to the top with the upholstery nozzle or crevice tool connected directly onto the hose handle. It is recom­mended that the extension tubes are not used.
4
B C
Ï
8598 Aztec ib 05/08/2003 10:23 Page 4
Replacing/emptying the dustbag
To obtain the best results from your cleaner be sure to change the dustbag when necessary, otherwise the airflow and cleaning power will be reduced.
When the dustbag condition indicator shows fully red and performance deteriorates, first check if there are any blockages in the accessories or tubes. If these are clear, it is necessary to replace/empty the dustbag.
Paper dustbags
1 Remove the hose end from the hose inlet. 2 Slide the dustbag compartment lid release
¤, lift and remove the cover.
3 Pull the cardboard seal up, to close the
opening to prevent dust spillage D.
4 Remove the dustbag from its location by
pulling the dustbag securing tab  as shown E.
5 Insert the new dustbag into position
ensuring the cardboard collar is firmly secured at the base as shown F.
6 Pull forward as shown G so it locks under
the plastic securing tab at the top.
7 The folds of the dustbag should be
opened out.
8 Relocate the lid at the front (carrying
handle ) end first and then close the cover securely.
Note: The securing tab  prevents the cover being closed unless a dustbag is fitted correctly.
Purchasing dust bags and replacement parts
For replacement dustbags, filters and replacement parts call our dedicated helpline 0870 167 6635.
5
F
G
D
E
8598 Aztec ib 05/08/2003 10:23 Page 5
Cleaning and replacing the filters
Motor protection filter
Ê
This is in the dustbag compartment. Clean it everytime you change/empty the dustbag and replace it after approximately 5 dustbag changes. 1 Lift out the red filter as shown H and
clean by tapping.
2 Replace the filter by locating it into the slot
and clipping it back I.
Note: The filter safety catch Á prevents the cover being closed unless a motor protection filter is fitted.
Exhaust filter
Ë
This is located on top of the motor housing J. Clean it everytime you change/empty the dustbag and replace it after approximately 5 dustbag changes. To remove, lift it from its location and shake to clean or replace.
Care and maintenance
ALWAYS DISCONNECT FROM THE MAINS BEFORE WORKING ON OR CLEANING YOUR CLEANER.
Your cleaner is manufactured to withstand normal day-to-day use, but an occasional wipe over with a damp cloth will help maintain its good looks.
Abrasive cleaners should not be used.
6
H
I
J
Á
Ë
8598 Aztec ib 05/08/2003 10:23 Page 6
Helpline
If you have any difficulty with your appliance, do not hesitate to call us. We’re more likely able to help than the store from where you bought it.
Please have the following information ready to enable our staff to deal with your query quickly:
• Name of the product;
• Model number as shown on the
underside of the appliance;
• Serial number.
Your two-year guarantee
It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference.
Please quote the following information if the product develops a fault. These numbers can be found on the base of the product.
Model no. Serial no.
All Goblin products are individually tested before leaving the factory. In the unlikely event of any appliance proving to be faulty within 28 days of purchase it should be returned to the place of purchase for it to be replaced.
If the fault develops after 28 days and within 24 months of original purchase, you should contact the Helpline number quoting Model number and Serial number on the product, or write to Goblin at the address shown. You will be asked to return the product (in secure, adequate packaging) to the address below along with a copy of proof of purchase. Subject to the exclusions set out below (1-5) the faulty appliance will then be repaired or replaced and dispatched usually within 7 working days of receipt.
If you suspect a fault, follow the simple checks detailed below before returning the appliance or calling the helpline.
• Check the filters for blockages.
• Check the tools / tubes for blockages.
• Check the plug is firmly in the socket and
the supply is switched on.
• Make sure the socket is working by trying
another appliance.
• Check the fuse in the plug.
If for any reason this item is replaced during the 2 year guarantee period, the guarantee on the new item will be calculated from original purchase date. Therefore it is vital to retain your original till receipt or invoice to indicate the date of initial purchase.
To qualify for the 2 year guarantee the appliance must have been used according to
7
8598 Aztec ib 05/08/2003 10:23 Page 7
VC70240M Rev 1 07/03
The After Sales Division, Goblin, Mexborough, South Yorkshire, England, S64 8AJ
Helpline (office hours) UK (local rate) 08450 777700 Republic of Ireland 1800 409119
Goblin products are intended for household use only
Goblin has a policy of continuous improvement in product quality and design. The Company, therefore, reserves the right to change the specification of its models at any time.
the manufacturers instructions. For example, the dust bags and filters must have been changed as required.
EXCLUSIONS Goblin shall not be liable to replace or repair the goods under the terms of the guarantee where: 1 The fault has been caused or is
attributable to accidental use, misuse,
negligent use or used contrary to the
manufacturers recommendations or where
the fault has been caused by power
surges or damage caused in transit. 2 The appliance has been used on a
voltage supply other than that stamped
on the products.
3 Repairs have been attempted by persons
other than our service staff (or authorised dealer).
4 Where the appliance has been used for
hire purposes or non domestic use.
5 The guarantee excludes consumables
such as dust bags and filters.
This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer.
• This guarantee is valid in the UK and
Ireland only.
8598 Aztec ib 05/08/2003 10:23 Page 8
Loading...