Morphy Richards IB42270 User Manual

Your two year guarantee
It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference.
Please quote the following information if the product develops a fault. These numbers can be found on the base of the product.
All Morphy Richards products are individually tested before leaving the factory. In the unlikely event of any appliance proving to be faulty within 28 days of purchase it should be returned to the place of purchase for it to be replaced.
If the fault develops after 28 days and within 24 months of original purchase, you should contact the Helpline number quoting Model number and Serial number on the product, or write to Morphy Richards at the address shown. You will be asked to return the product (in secure, adequate packaging) to the address below along with a copy of proof of purchase.
Subject to the exclusions set out below (see Exclusions) the faulty appliance will then be repaired or replaced and dispatched usually within 7 working days of receipt.
If for any reason this item is replaced during the 2 year guarantee period, the guarantee on the new item will be calculated from original purchase date. Therefore it is vital to retain your original till receipt or invoice to indicate the date of initial purchase.
To qualify for the 2 year guarantee the appliance must have been used according to the manufacturers instructions. For example kettles should have been regularly descaled.
EXCLUSIONS
Morphy Richards shall not be liable to replace or repair the goods under the terms of the guarantee where:
1 The fault has been caused or is
attributable to accidental use, misuse,
negligent use or used contrary to the
manufacturers recommendations or where
the fault has been caused by power
surges or damage caused in transit. 2 The appliance has been used on a voltage
supply other than that stamped on the
products. 3 Repairs have been attempted by persons
other than our service staff (or authorised
dealer). 4 Where the appliance has been used for
hire purposes or non domestic use. 5 Morphy Richards are not liable to carry
out any type of servicing work, under the
guarantee. 6 Plastic filters for all Morphy Richards
kettles and coffee makers are not covered
by the guarantee.
This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer.
This guarantee is valid in the UK and Ireland only.
Morphy Richards products are intended for household use only.
Morphy Richards has a policy of continuous improvement in product quality and design. The company, therefore reserves the right to change the specification of its models at any time.
The After Sales Division Morphy Richards Ltd, Mexborough South Yorkshire, England, S64 8AJ
Helpline (office hours) UK 0870 060 2615 Republic of Ireland 1800 409119
RN 42270M Rev 1
St gen rn42270M rev 1 10/12/02 11:37 am Page 1
Steam generator
Ironing system
Please read and keep these instructions
www.morphyrichards.co.uk
getting the best from your new steam generator...
Safety first
Caution must be used when handling this appliance as it does get very hot. Always switch off the unit and allow to cool before cleaning or storing.
Water tank
The water tank can be removed and re-filled at any time during ironing.
Performance
To extend the performance and life of your jet stream generator ensure that you replace the anti-scale cartridges regularly.
St gen rn42270M rev 1 10/12/02 11:37 am Page 2
Important safety instructions
The use of any electrical appliance requires the following common sense safety rules.
Primarily there is danger of injury or death and secondly the danger of damage to the appliance. These are indicated in the text by the following two conventions:
WARNING: Danger to the person!
IMPORTANT: Damage to the appliance! In addition we offer the following safety advice.
Location
Do not use outdoors.
Children
Children do not understand the dangers
associated with operating electrical
appliances. Never allow children to use
this appliance.
Close supervision is necessary when any
appliance is used near children.
Personal safety
Burns can occur from touching hot metal
parts, hot water or steam. Use caution
when using your steam generator. If your
iron is placed for a few moments on the
iron rest plate, this plate may reach very
high temperatures. In this instance, do
not touch the iron soleplate or the iron
rest plate until the iron and the iron rest
have cooled down.
Do not use the vertical steam feature on
clothes that are being worn.
Do not leave the steam generator
unattended whilst plugged in or on an
ironing board. Never allow the mains
lead to over hang the work surface.
The socket should always be off before
plugging or unplugging from the socket. Never yank the cord to disconnect from the socket, instead, grasp plug and pull to disconnect.
Do not allow the cord to touch hot
surfaces. Let the steam generator cool completely before putting away.
Other safety considerations
Use the steam generator only for its
intended use.
Never hold the generator base set under
the tap.
To protect against the risk of electric
shock do not put the appliance in water or in any other liquid.
Always disconnect the tank from the
base unit when filling with water and emptying.
Always disconnect the steam generator
from the electrical supply when cleaning or when not in use.
Do not operate the steam generator with
a damaged cord or if the iron has been dropped or damaged. To avoid the risk of electric shock, do not disassemble the iron, but telephone Morphy Richards for advice. Incorrect reassembly can cause a risk of electric shock when the iron is used.
If the need arises to change the mains
cable on your steam generator or the iron, please return to Morphy Richards service department at the address on the back page.
Special instructions
If your steam generator does not work,
check the following points: Has the temperature control been set to the required temperature? Is the plug in its socket? Is the plug itself or the socket faulty? (Check by plugging in another appliance).
2
St gen rn42270M rev 1 10/12/02 11:37 am Page 3
Loading...
+ 5 hidden pages