Morphy Richards IB40702, IB40712 User Manual

Comfigrip iron steam/spray/shot

Please read and keep these instructions

getting the best from your
new iron...

• Safety first

Caution must be used when handling this appliance as it does get
very hot. Always switch off the unit and allow to cool before
cleaning or storing.

• Jet cleaning

Your iron will give the best ironing results and will last longer if you
apply jet cleaning after each period of ironing.

UK

Helpline: 0870060 2615

Replacement parts: 0870 167 6646

Ireland 1800 409119

www.morphyrichards.com

For replacement parts, help with using your Morphy Richards

products and lots more, contact us by phone or through our website

40701 rev 1 3/1/06 2:50 PM Page 1

Important safety
instructions

The use of any electrical appliance
requires the following common sense safety
rules.

Primarily there is danger of injury or
death and secondly the danger of damage
to the appliance. These are indicated in the
text by the following two conventions:

WARNING: Danger to the person!

IMPORTANT: Damage to the appliance! In
addition we offer the following safety
advice.

Location

• Do not use outdoors.

Children

• Close supervision is necessary when any

appliance is used near children.

Personal safety

•WARNING: Burns can occur from

touching hot metal parts, hot water

or steam. Use caution when you

turn a steam iron upside down,

there may be hot water in the water

tank.

•WARNING: To protect against the

risk of electric shock do not put the

appliance in water or in any other

liquid.

• Do not use the vertical steam feature on

clothes that are being worn.

• Do not leave the iron unattended whilst

plugged in or on an ironing board. Never

allow the mains lead to over hang the

work surface.

• The socket should always be off before

plugging or unplugging from the socket.

Never yank the cord to disconnect from

the socket, instead, grasp plug and pull

to disconnect.

• Do not allow the cord to touch hot

surfaces. Let the iron cool completely

before putting away. Loop cord loosely

around the iron before storing.

Other safety considerations

• Use the iron only for its intended use.

• Always disconnect the iron from the
electrical socket when filling with water
or emptying, and when not in use.

• Do not operate the iron with a damaged
cord or if the iron has been dropped or
damaged. To avoid the risk of electric
shock, do not disassemble the iron, but
telephone Morphy Richards for advice.
Incorrect reassembly can cause a risk of
electric shock when the iron is used.

Special instructions

• If your iron does not work, check the
following points:

Has the temperature control been set to

the required temperature? Is the plug in
its socket? Is the plug itself or the
socket faulty? (Check by plugging in
another appliance).

•WARNING: When not in use, your
iron should never be placed flat and
left on an ironing board.

•To prevent damage to the textile being
ironed, follow the temperature guide
carefully. (Test the inside of the hem of
the garment).

• When ironing is complete, remove the
plug from the socket, empty any
remaining water from the tank, and allow
to cool before storage.

• If you drop or severely knock your iron
this could cause internal damage even if
the outside appears alright. Have it
checked by a qualified electrician.

• It is recommended that you use up one
beaker of water by operating your iron’s
steam and shot of steam functions
before ironing any clothes as some
dripping may occur while your irons
steam system is activated.

2

40701 rev 1 3/1/06 2:50 PM Page 2

3

Electrical
requirements

Check that the voltage on the rating
plate of your appliance corresponds with
your house electricity supply which must be
A.C. (Alternating current).

If the socket outlets in your home are
not suitable for the plug supplied with this
appliance the plug should be removed and
the appropriate one fitted.

WARNING : The plug removed from
the mains lead, if severed, must be
destroyed as a plug with a bared
flexible cord is hazardous if engaged
into a live socket outlet.

Should the fuse in the 13 amp plug
require changing a 13 amp BS1362 fuse
must be fitted.

WARNING: This appliance must be
earthed.

Instructions for use

Temperature guide

Heat setting markings on the adjustable control dial of all Morphy Richards irons match

those of the International Textile Care Labelling Code.

Symbol

(120˚C Max) Cool

(160˚C Max) Warm

(210˚C Max) Hot

Control knob
positions

Do not
iron at all

Fabric

Nylon, Acetates
e.g. Acrilan
Courtelle, Orlon
Triacetates, e.g.
Tricel/Polyester

Wool, Polyester
mixtures e.g.
Polyester/Cotton

Cotton, Linen
Rayon, Rayon
mixtures,
e.g. Rayon/Linen

Ironing

Iron on wrong side
if moisture required
use damp cloth
(Not Acetate)

Fabrics requiring this
setting usually require
steam pressing for heavy
cotton, denim etc.

With water in tank

Dry and spray

Steam/spray/shot of steam

Jet clean

Without water in tank

Dry ironing

40701 rev 1 3/1/06 2:50 PM Page 3