Illustration
Stereo cd alarm
clock radio
29005 OPERA TING INSTRUCTIONS
Electrical requirements
Check the voltage on the rating plate of your clock radio corresponds with
your house electricity supply which must be A.C. (Alternating current).
If the socket outlets in your home are not suitable for the plug supplied with
this appliance the plug should be removed and the appropriate one fitted.
IMP0RTANT : THE PLUG REMOVED FROM THE MAINS LEAD, IF SEVERED,
MUST BE DESTROYED AS A PLUG WITH A BARED FLEXIBLE CORD IS
HAZARDOUS IF ENGAGED INTO A LIVE SOCKET OUTLET.
Should the fuse in the 13 amp plug require changing a 3 amp BS1362 fuse
must be fitted.
Battery back-up facility (unit will work without a battery being fitted)
Your cd alarm clock radio is equipped with a battery back-up facility.
1 Remove the battery compartment cover (underneath the unit) by
sliding the cover off.
2 Insert a battery size 9 volts PP3/6LR61 (Ensure battery is inserted correctly)
3 Replace the battery compartment cover.
Should a power interruption occur the clock will continue to run, however, time
keeping will not be accurate. The display will be extinguished to conserve battery
life but the memory will retain details of the clock time and alarm settings.
If the optional battery is not installed in case of the AC power failure the clock will
reset to 12:00 when the power is restored. You will need to reset the clock
and alarm.
Battery back-up is designed to operate for a short period only.
If the unit is not to be used for a prolonged period, remove the battery to
avoid battery leakage.
In the interests of environmental safety : dispose of batteries safely.
Speakers (speakers are detachable)
Open the speaker wire compartment located underneath the unit and unravel the
speaker wire. Detach the speakers and position where required. Wind up excess
wire around pegs on the underneath of the unit. Close the speaker wire
compartment door.
P.2
P.3 P.4
Setting the clock time
1 While holding down the TIME button, press the or to set the
desired time.
2 Release the button to save time setting.
Radio operation
FM wire aerial
To obtain the maximum FM reception fully extend the wire FM aerial (which is
located at the rear of the unit) and alter the direction of the wire for best results.
The aerial for the MW waveband is located inside the unit. To obtain the
maximum MW reception rotate the clock radio.
1 Slide the FUNCTION SELECTOR switch to select MW or FM.
2 Press the POWER on/off button.
3 Adjust the VOLUME control to a suitable level.
4 Slowly adjust the TUNING control to select your desired station. The
FM LED indicator will light up when an FM stereo signal is received.
5 To switch off the radio, press the POWER on/off button.
To play compact disc
1 Press the power on/off button.
2 Open the cd door using cd open tab, load a disc in the cd compartment. Push
down gently on the door to close.
3 Select the cd mode by switching the function selector to cd.
4 Press the play/pause button. The display will show the track number when
you begin to play a cd. After a few seconds, the display reverts to the
current time.
Note : The same button can be used to momentarily interrupt playback. The
track number will flash until the button is pressed again.
5 Adjust the volume control until the desired level is reached.
6 Press the stop button to stop playback.
7 To switch off the cd, press the power on/off button.
1
2
2
3
4
5
6
7
8
9
10
11
12
13
16
17
14
15
20
21
18
19
24
25
22
23
26
○○
27
Location of controls
1 Cd open tab
2 Speakers (detachable)
3 Pm indicator
4 Program indicator
5 Random indicator
6 Repeat indicator
7 Power indicator
8 Alarm 1 indicator
9 Dial scale with pointer
10 Tuning control
11 Alarm function selector switch
12 Alarm 1 and 2 selector switch
13 Snooze button
14 Play/pause button button: to switch unit on and
start playback. To momentarily stop playback
15 Play mode/program button
16 PTS button: to select your favourite cd track for waking
up to music
17 Alarm 1 button: to set alarm 1
18 button: to stop cd playback
19 MIN Skip/fast search/selection ( backward):
-to skip cd tracks and for minute setting of alarm clock
functions and time.
(quick selection: press and hold
normal selection: press repeatedly)
20 Repeat button: for continuous
playback
21 Alarm 2 button: to set alarm 2.
22 Power on/off button: to turn radio,cd
and alarm on/off
23 HOUR Skip/fast search/selection
( forward): -to skip cd tracks
and for fast search within a track
-for setting of hour, for time and
alarm clock functions
quick selection: press and hold
normal selection: press repeatedly
24 Sleep button
25 Time button
26 FM wire aerial
27 Function selector switch
28 Volume control
29 Earphone jack
30 Battery compartment
31 Alarm 2 indicator
32 FM stereo indicator
28
29
30
31
32
Maintenance
Do not expose your cd clock radio to extremes of temperature. The product should
be kept in a warm environment free from dust and damp. For external cleaning
use only a soft, clean, damp cloth. Use of detergents may damage the finish.
Technical specification
AC Power supply : 230v 50Hz
Battery back-up : 9V DC type 6LR61/PP3 (not included)
CD player : Frequency response (3dB) 100Hz to 18kHz
Laser : = 780nm Max power = 5mW
Radio : FM 88Mhz - 108Mhz
: MW 540Khz - 1600Khz
Earphone socket : 3.5mm
WARNING : This unit uses a laser beam. To prevent an accident occuring the
unit should only be opened by a qualified engineer. If the door interlocks become
defective the laser may cause invisible radiation. Avoid exposure to the beam.
If there is a scratch, dirt or finger prints on the cd, it may cause tracking errors.
Before playing, clean the cd with a clean cloth. Wipe the cd from the centre
outwards. After playing, store the disc in its cd case.
For indoor use only.
Warning labels
WARNING: to reduce the risk of electric shock, do not expose this appliance
to rain or moisture.
Guarantee
Morphy Richards products are manufactured to internationally accepted quality
standards. In addition to your statutory rights, Morphy Richards guarantee your
product to be free from manufacturing and component defects for a period of TWO
YEARS from date of purchase.
If your product proves to be defective within 28 days of purchase, your Morphy
Richards dealer from whom the product was purchased will be pleased to replace it
free of charge.
Should your product develop a defect within the guarantee period but after the
replacement period, please return the product to the following address, together with
the proof of purchase, brief details of the symptoms and your own name and
address.
After Sales Division
Morphy Richards Limited
T albot Road
Mexborough
South Yorkshire
S64 8AJ
Your post office will provide a certificate of posting. The product will be repaired
and returned to you promptly.
Helpline (8:30-5:00 Mon-Thur/ 8:30-4:00 Fri) UK 0870 060 2614
Republic of Ireland 1800 409119
Replacement parts 0870 167 6645
Morphy Richards Website: www.morphyrichards.co.uk
446/8001/95 Rev 1
Morphy Richards Ltd, T albot Road, Mexborough, S64 8AJ
P.5 P.6
P.7
Other cd functions
SKIP/FAST REVERSE SEARCH
1 Press once to skip to the next track or as many times as required to
reach desired track. Press the to return to the beginning of the current
track or as many times as required to go back to desired track. Press or
and hold for fast search within the current track.
REPEA T button
1 Press once to repeat the track. The repeat indicator will flash.
2 Press again for the whole cd to be repeated, the repeat indicator will light up.
3 Press again to cancel the repeat function. Repeat LED indicator will go
out.
RANDOM
1 Press P. mode button once for random playback of all cd tracks. If a
program has been set press twice. The random LED indicator will light up.
2 Press again to cancel the function.
Repeat and random modes can be used simultaneously.
When the cd compartment is empty or a cd is incorrectly loaded or damaged the
‘no’ (no disc) symbol will be displayed.
Setting alarm
The unit allows you to select two different wake-up times that can be used
separately or simultaneously (ALARM 1 OR 2 OR ALARM 1 and 2).
Before setting the alarm, switch the alarm selector switch to either alarm 1 or
alarm 2 or alarm 1 and 2.
ALARM 1: Press and hold the alarm 1 button, and then or to set the
desired wake-up time. Release alarm button to save the setting.
ALARM 2: Press and hold the alarm 2 button and proceed as above.
Set the function selector switch to AUTO, (then set function selector switch to
either MW or FM for radio or cd for cd music) BUZZ (for buzzer) or OFF to
cancel alarm.
Waking up to the radio
1 Follow the instructions given under ‘Radio operation’ to select the desired
radio station.
2 Set ALARM function switch to AUTO alarm indicators will light
up. Then set function selector switch to either MW or FM.
Waking up to cd music
1 Follow steps 1 to 3 of the ‘playing cd’ procedure.
2 To wake up to your favourite cd track, press and release the PTS button and
then press or until desired track number is saved. Press the PTS
button to store. Repeat for up to 20 tracks. Wait until the clock reverts back
to the time or press the time button. Press PLAY mode button twice and the
program indicator will light up. The PTS button can be pressed at any time to
check track selection.
3 Press the POWER on/off button the power indicator will go out.
4 Set the ALARM selector switch to AUTO; the alarm indicators will
light up. At the wake time, the unit will playback the whole cd unless the
REPEAT mode is selected. The player will remain in operation for about 1
hour. To stop playback, press the POWER on/off button.
Note: PTS button can be used to program 20 different tracks.
Waking up to buzzer
Set alarm selector switch to BUZZER; the alarm indicators will light.
How to cancel the alarm
The alarm is programmed to sound for 1 hour.
1 SNOOZE; press this button to temporarily stop the alarm . The alarm will
sound again 6 minutes later.
2 POWER on/off; Press to stop the alarm, the alarm will sound again 24
hours later.
3 Switch alarm selector switch to the off position to cancel alarm permanently,
indicators will disappear.
Sleep to music
1 Select the function selector switch to the desired mode CD/MW/FM.
2 Press the sleep button and the display will indicate --, press again for 90, 60,
30 minutes to set the sleep time.
3 Note: for the cd to start playing, press the play button.
4 Press the POWER on/off button to cancel the music before the end of the
programmed duration.
Note; If cd contents are shorter than the selected sleep time, playback will stop
at the end of the cd unless the REPEAT mode has been activated.
ATTENTION: To reduce the risk of electric shock, do not
remove the cover. There are no user serviceable parts inside
the unit. Refer any servicing to qualified personnel.
The lightning flash with arrowhead symbol within the triangle is a warning
sign alerting the user of ‘dangerous voltage’ inside the unit.
The exclamation point within the triangle is a warning sign alerting the user of
important instructions accompanying the product.
To prevent fire or shock hazard do not expose this apparatus to dripping or
splashing.
Morphy Richards products are intended for household use only.
Morphy Richards has a policy of continuous improvement in product quality and design.
The company, therefore reserves the right to change the specification of its models at any time.
Loading...