Morphy Richards IB26004 User Manual

To trim side burns

1 Comb side burns following the

direction of your hair growth.

2 Trim side burns using a downward

motion. (figure 6)

Stubble look

1 Position trimmer guide to the 3mm setting and hold

the trimmer horizontally with the front of the
trimmer facing downwards or upwards.

2 Trim hairs using a downward or upward motion

following the direction of your hair growth.

Note : For an even closer stubble look, remove the
trimmer guide and repeat the same procedure.

Oil (use clipper oil)

1 To lubricate the blades use one or

two drops of oil and spread over
the cutters. (figure 7) Do not over

oil. Excess oil will cause
damage to your product.

Care and maintenance

• Never clean, remove or replace trimmer guide with

the motor on.

• Do not apply any pressure to cutters.

• Do not touch the cutters with hard objects as this

may damage the cutter.

• Do not use while bathing, showering or immersing

the unit in water or other liquids as damage to the
trimmer may occur.

• Never use harsh or corrosive cleaners such as

benzene or bleach.

Important safeguards

When using your appliance, basic safety precautions
should always be followed.

1 Read all instructions carefully.
2 Use the appliance for its intended use only.
3 To protect against the risk of electric shock, do not

immerse the appliance in water or other liquids.

4 Before use, make certain blades are aligned

properly.

5 Do not use this appliance with damaged or broken

combs or with teeth missing from the blades as
injury may occur.

6 Never use the trimmer on wet hair.
7 Switch off before placing down.
8 Switch off before fitting or removing attachments.

Two year guarantee

It is in your interest to retain the retailers receipt as proof
of purchase. Please quote the model number if the prod­uct develops a fault. This number can be found on the
handle of the product.

All Morphy Richards products are individually tested
before leaving the factory. In the unlikely event of any
appliance proving to be faulty within 28 days of purchase
it should be returned to the place of purchase for it to be
replaced.

If a fault develops after 28 days and within 24 months of
original purchase, you should contact the helpline number
quoting the model number of the product, or write to the
address below. You will be asked to return the product
(in secure packaging) to the address below along with a
copy of proof of purchase.

The After Sales Division

Morphy Richards Limited

Mexborough

South Yorkshire

England
S64 8AJ

Helpline (8:30-5:00 Mon-Thur/ 8:30-4:00 Fri)
UK (local rate) 08450 777700,
Republic of Ireland 1800 409119

Morphy Richards Website
www.morphyrichards.co.uk

Morphy Richards products are intended for household

use only. Morphy Richards has a policy of continuous

improvement in product quality and design. The

Company, therefore, reserves the right to change the

specification of its models at any time.

446/8001/19 Rev 1

Imported by : Morphy Richards Ltd, Talbot Road, Mexborough, S64 8AJ

Male grooming system

MODEL : 26004

Instructions & Style Guide

Thank you for buying your new Morphy Richards male
grooming system. Please read these instructions
carefully before use and keep in a safe place for future
reference.

Key features

J

I

H

G

F

A Cutting blades
B Standard comb
C On/off switch
D Charging adaptor
E LED charging indicator
F Recharging base
G Cleaning brush
H Lubricating oil
I 5 Moustache comb
J Styling comb

A

B

C

D

E

Ni-cad batteries

Push down the battery door to open and then take
out the Ni-cad batteries.
Your beard trimmer is operated
by 2 x AA rechargeable
batteries. Ensure the batteries
are correctly fitted. Refit
battery door.

USE ONLY NICAD RECHARGEABLE BATTERIES in
order to avoid damage.

Batteries are not covered by the 2 year guarantee.

In the interest of environmental safety, dispose
of batteries safely.

Operating your trimmer

1 Push the on/off switch upward to operate and down

to turn off the trimmer.
Before using the trimmer charge the unit overnight.
Make sure the LED indicator is on showing correct
charging.

To Recharge

1 Use only the adaptor (charger) provided.
2 Charge takes 8 hours.
3 Connect plug to trimmer and plug adaptor into the

electrical socket.

4 When charging, RED LED indicator will light up

showing correct recharging.

Attachment comb (trimming guide)

Your beard trimmer provides 2 attachment combs.

Styling Comb - provides 5 settings of cutting length
9, 11, 13, 15 and 17mm.

9 1.5
11 3
13 4.5
15 6
17 7.5

Standard comb - provides 5 settings of cutting length

1.5, 3, 4.5, 6 and 7.5mm.

Trim against the direction of the hair growth.
Start at a longer setting (15mm or 17mm) to prevent
accidentally trimming hair too short.

As you become familiar with the setting, adjust the
guide to the desired trimming length.

To trim beards

1 Comb hair outward so they are at a

maximum height and in the same
direction.

2 With the trimming guide in place,

set the guide to the desired
setting.

3 Slide the On/off switch to the on

position and begin trimming. (figure 1)

To trim outer edge of beard
and add definition

1 Remove trimming guide (figure 2)

and hold the trimmer diagonally
with the front of trimmer facing
away from you.

2 Start at the chin and move back

towards the ear. (figure 3) Follow
the jawbone to cut away longer
hairs on the outer edge of the
beard.

To define the beard line

1 Hold the trimmer vertically with the

front of the trimmer facing you.

2 Start with the trimmed edge of the beard and with

a downward motion trim the area directly under the
beard line.

To thin and taper beard

1 Use the moustache comb to hold hairs in place

while trimming.

2 Hold the trimmer with front facing away from you.

Trim hair ends using an upward motion.

To trim moustache (with trimming guide)

1 Ensure that the trimming guide is in place to avoid

over trimming the hair.

2 Comb hairs outward to the maximum height and in

the same direction.

3 Set the trimming guide to the desired setting.
4 Hold the trimmer vertically with the front facing

you and trim hairs using a downward motion
following the direction of your hair growth or you
may trim against your hair growth.

Without trimming guide

1 Place a finger on the upper lip only

to lift hair up, away from the skin.
Trim hairs using an upward motion.

2 After achieving desired length, use a

downward motion to blend
moustache hairs. (figure 4)

3 Hold trimmer perpendicular as

shown and move cutters sideways
to achieve the desired line above
the lip. (figure 5)