Morphy Richards IB25018 User Manual

Medical precautions

• This should not be used in the following cases: tuberculosis, benign and malignant tumors, hemmorages, inflammations of the skin, phlebitis and thrombosis, open and fresh wounds, bruises, broken skin or varicose veins or undetermined calf pain.

• Consult your physician if you have any questions regarding the use of the bath spa.

• Do not use on any part of the body that is anesthetized.

• Do not use on any part of the body where surgery has been performed.

• Do not use on any unexplained pain before consulting a doctor.

• If you have any concerns regarding your health, consult your doctor before using this product.

Wiring

Check that the voltage on the rating plate of the adaptor plug corresponds with your house electricity supply which must be A.C. (Alternating Current). If the socket outlets in your home are not suitable for this adaptor, then do not use at all.

Always use the adaptor plug supplied.

Maintenance

Keep the bathspa clean and clear of obstructions. Check the outflow control frequently for potential obstructions, including lint and hair, that could block air or water flow. We recommend cleaning the bathspa after each use with mild detergent or soap.

1 Unplug the unit and allow it to cool before cleaning.

Clean only with a soft, slightly damp sponge. Note: Do not use abrasive cleaners, brushes, gasoline, kerosene, glass/furniture polish or paint thinner to clean.

2 Bathspa should also be disinfected regularly to

keep it bacteria free.

Do not attempt to repair the bathspa. There are no user serviceable parts inside.

Two Year Guarantee

It is in your interest to retain the retailers receipt as proof of purchase. Please quote the model number if the product develops a fault. This number can be found on the base of the product.

All Morphy Richards products are individually tested before leaving the factory. In the unlikely event of any appliance proving to be faulty within 28 days of purchase it should be returned to the place of purchase for it to be replaced.

If a fault develops after 28 days and within 24 months of original purchase, you should contact the helpline number quoting the model number of the product, or write to the address below. You will be asked to return the product (in secure packaging) to the address below along with a copy of proof of purchase.

The After Sales Division

Morphy Richards Ltd

Mexborough

South Yorkshire

England S64 8AJ

Helpline (8:30-5:00 Mon-Thur/ 8:30-4:00 Fri) UK (local rate) 08450 777700, Republic of Ireland 1800 409119

Morphy Richards Website www.morphyrichards.co.uk

Morphy Richards products are intended for household

use only. Morphy Richards has a policy of continuous

improvement in product quality and design. The

Company, therefore, reserves the right to change the

specification of its models at any time.

Bath spa

MODEL : 25018

Imported by : Morphy Richards Ltd, Talbot Road, Mexborough, S64 8AJ

446/8001/48 Rev 1

Instructions

Thank you for buying your new Essentials bath spa from Morphy Richards. Please read these instructions carefully before use and keep in a safe place for future reference.

Key features

1 On/off button

To turn on the bathspa press the power button

2 Suction cups

Keeps bathspa securely mounted

3 Fill line

Fill the bathtub with water to this line

4 Dual jets

Jets adjust in several directions

5 Variable control

From power jet stream to gentle bubbles No bubbles

Bubble relief

This bathspa turns your bathtub into a whirlpool by adding bubbles or a stream action, helping you to relax and renew.

Installation instructions 1 Ensure that the bathspa is off and the tub is empty . 2 Place the unit over the edge of the tub so the unit is

inside the tub and the arm is resting on the edge. (see figure 1).

3 Dampen suction to improve the grip. 4 Secure suction cups. 5 Adjust the suction cups so that it sticks directly onto

the bath tub as water may spray if the bath spa is not level when turned on.

Instructions for use 1 Place the bathspa in the tub by using the

installation instructions.

2 Insert the bathspa plug into the adaptor

(see figure 2).

3 Plug the adaptor into the mains outlet which must

be outside the bathroom. (see figure 3).

4 Fill the bathtub with water to the line indicated on

the unit.

5 Press the on button and set the control to the

desired setting (jet stream or bubbles).

CAUTION

If the bathspa falls into the tub during use do not panic. Bathspa has been designed to withstand submersion for short periods of time without danger. Remove the unit from the tub immediately and press the off button. Unplug the adaptor plug and hold the unit over the tub, rotating gently to remove excess water from the housing. When the water is completely emptied from the unit, reinstall the bathspa and follow the operating instructions.

Adaptor cord

Suction cups

Figure 1

Bath spa adaptor plug

Figure 2

Do not reach for the power supply while in the bath. Do not disconnect the power until the unit is turned off. If the unit has been immersed for more than 5 minutes, remove the unit from the bath, press the off button, disconnect the power cord from the adaptor plug, drain the water from the unit and store in a dry place for at least 24 hours before next use.

Adaptor plug

Figure 3

Jet stream/bubbles

Figure 4

Important safeguards

When using your bathspa, basic safety precautions should always be followed.

Read all instructions carefully.

• Use the appliance for its intended use only.

• To protect against the risk of electric shock, always unplug this appliance from the electrical outlet immediately after using and before cleaning.

• Be sure that your household voltage corresponds to the voltage marked on the appliance.

• Always unplug your appliance when it is not in use.

• It is recommended that this appliance should not be used by children.

• Do not leave the appliance switched on whilst unattended.

• Do not place or store the power pack where it can fall or be pulled into a bath tub or sink. Do not place in or drop into the water or other liquid. Store in a dry place.

• Do not attempt to plug or unplug the unit while the body is in water.

• Do not use attachments not recommended.

• Do not operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been damaged in any way return it to Morphy Richards.

• Do not block the air openings of the appliance or power pack or place on soft surface such as a bed or couch, where the air openings may be blocked. Keep air openings free of lint, hair, dust etc.

• Do not drop or insert any object into any opening.

• Do not use outdoors.

• To disconnect, turn all controls to the ‘off’ position then remove the plug from the outlet.

• Ensure that your hands are dry when operating

the switch or removing the plug.

Cautions

• Do not cover the bath spa or power pack with any material while it is in operation.

• Do not use if you have sensitive skin areas or poor circulation.

• Do not use while sleeping or drowsy.

• Do not use bath spa for more than 20 minutes.

• Indoor use only, do not use on the walls of inflatable

tubs or pools.