Morphy Richards 40743 User Manual

‘Advanced Finish’ iron steam/spray/shot/press

Please read and keep these instructions

TURBO TIP

CONSTANT
STEAM

PRESS
AND SET

Getting the best from your new iron....

Safety first

Caution must be used when handling this appliance as it does get
very hot. Always switch off the unit and allow to cool before cleaning
or storing.

Self-clean

Your iron will give the best ironing results and will last longer if you
clean the soleplate once a month, see ‘Maintenance’ on pages 6 & 7.

RN40743 MUK Rev 6

If you have a problem or complaint, please call our dedicated UK based helpline
before returning your product to the retailer from where it was purchased.

UK Helpline: 0844 871 0953
Replacement Parts: 0844 873 0719
Ireland Helpline: 1800 409 119

!

To improve the life of your new product and to ensure the cleanliness of your
clothes, we strongly recommend the use of distilled or demineralised water.

RN40743 MUK Rev6:40715 rev3 27/03/2009 14:18 Page 1

2

IMPORTANT
SAFETY
INSTRUCTIONS

The use of any electrical
appliance requires the
following common sense
safety rules:

Primarily there is danger of
injury or death and
secondly the danger of
damage to the appliance.
These are indicated in the
text by the following two
conventions:

WARNING: Danger to
the person!

IMPORTANT: Damage to
the appliance!

In addition, we offer the
following safety advice.

Location

• Do not use outdoors or
near water.

• The iron must be used and
rested on a stable surface.

Children

• Close supervision is
necessary when any
appliance is used near
children.

• Children do not understand
the dangers associated
with operating electrical
appliances.

• Children should be
supervised to ensure that
they do not play with this
appliance.

Personal Safety

• WARNING: Burns can
occur from touching hot
metal parts, hot water or
steam. Use caution when
you turn a steam iron
upside down, there may
be hot water in the water
tank.

• WARNING: To protect
against the risk of
electric shock, do not
put the appliance in
water or in any other
liquid.

• Do not use the vertical
steam feature on clothes
that are being worn.

• Never allow the mains lead
to over hang the work
surface.

• The socket should always
be off before plugging or
unplugging from the
socket. Never yank the
cord to disconnect from
the socket, instead, grasp
the plug and pull to
disconnect.

• Do not allow the cord to
touch hot surfaces.

• Let the iron cool
completely before putting
away. Loop the cord
loosely around the iron
before storing.

• The iron must not be left
unattended while it is
connected to the supply
mains.

• When placing the iron on
its heel, ensure that the
surface on which the heel
is placed is stable.

• This appliance is not
intended for use by
persons (including children)
with reduced physical,
sensory or mental
capabilities, or lack of
experience or knowledge,
unless they have been
given supervision or
instruction concerning use
of the appliance by a
person responsible for their
safety.

Other safety
considerations

• Use the iron only for its
intended use.

• Always disconnect the iron
from the electrical socket
when filling with water or
emptying, and when not in
use.

• If the supply cord is
damaged, it must be
replaced by the
manufacturer, its service
agent or similarly qualified
person(s) in order to avoid a
hazard.

• Do not operate the iron
with a damaged cord, or if
the iron has been dropped
or damaged and if there
are visible signs of
damage, or if it is leaking.
To avoid the risk of electric
shock, do not disassemble
the iron, but telephone
Morphy Richards for
advice. Incorrect
reassembly can cause a
risk of electric shock when
the iron is used.

Special
instructions

If your iron does not work,
check the following points:

• Has the temperature
control been set to the
required temperature? Is
the plug in its socket? Is
the plug itself or the socket
faulty? (Check by plugging
in another appliance).

• WARNING: When not in

use, your iron should
never be placed flat and
left on an ironing board.

• To prevent damage to the
textile being ironed, follow
the temperature guide
carefully. (Test the inside of
the hem of the garment).

UK Helpline 0844 871 0953 Replacement Parts 0844 873 0719 Ireland Helpline 1800 409 119

RN40743 MUK Rev6:40715 rev3 27/03/2009 14:18 Page 2

• When ironing is complete,
remove the plug from the
socket, empty any remaining
water from the tank, and allow
to cool before storage.

• If you drop or severely knock
your iron, this could cause
internal damage even if the
outside appears alright. Have it
checked by a qualified
electrician.

• It is recommended that you use
up one beaker of water by
operating your iron’s steam and
shot of steam functions before
ironing any clothes, as some
dripping may occur while your
iron’s steam system is activated.

ELECTRICAL
REQUIREMENTS

Check that the voltage on the
rating plate of your appliance
corresponds with your house
electricity supply which must be
A.C. (Alternating Current).

If the socket outlets in your
home are not suitable for the
plug supplied with this
appliance, the plug should be
removed and the appropriate
one fitted.

WARNING: A damaged or
severed mains cable fitted
with a plug should never be
connected to the mains
supply. It must be destroyed,
as a damaged cable becomes
hazardous if connected to a
power socket.

Should the fuse in the 13 amp
plug require changing, a 13 amp
BS1362 fuse must be fitted.

WARNING: This appliance
must be earthed.

Heat setting markings on the adjustable control dial of all Morphy Richards irons match those of
the International Textile Care Labelling Code.

Symbol

(120°C Max) Cool

(160°C Max) Warm

(210°C Max) Hot

Control knob
positions

Do not iron
at all

Fabric

Nylon, Acetates
e.g. Acrilan
Courtelle, Orlon
Triacetates, e.g.
Tricel/Polyester

Wool, Polyester
mixtures e.g.
Polyester/Cotton

Cotton, Linen
Rayon, Rayon
mixtures,
e.g. Rayon/Linen

Ironing

Iron on wrong side,
if moisture required
use damp cloth
(Not Acetate)

Fabrics requiring this
setting usually require
steam pressing for heavy
cotton, denim etc.

With water in tank

Dry and spray

Steam/spray/shot of steam

Without water in tank

Dry ironing

INSTRUCTIONS FOR USE

3

Temperature guide

Self clean

‘Max’ Setting

For details of other Morphy Richards products, please see our website:

RN40743 MUK Rev6:40715 rev3 27/03/2009 14:18 Page 3