Morphy Richards 401012 Instruction manual

FP401012 MUK Rev3

www.facebook.com/morphyrichardsuk

@loveyourmorphy

www.morphyrichards.co.uk/blog

For competitions, product hints and tips and more join us at

Food Processor

Please read and keep these instructions for future use

FP401012 MUK Rev3.qxp_Layout 1 31/08/2018 11:43 Page 1

In addition, we offer the following safety advice.

Location

• Do not use outdoors or in a bathroom.

• Always locate your appliance away from the edge of the

worktop.

Mains cable

• Do not let the mains cable hang over the edge of the

worktop where a child could reach it.

• Do not let the lead run across an open space e.g.

between a low socket and a table.

• Do not let the cable run across a cooker or other hot area

which might damage the cable.

• The mains cable should reach from the socket to the

base unit without straining the connections.

• The power cord cannot be replaced. Contact Morphy

Richards for advice.

Other safety considerations

• Do not use the appliance for anything other than its

intended purpose.

• The use of attachments or tools not recommended or

sold by Morphy Richards may cause fire, electric shock or injury.

Product specific safety

• Do not operate any appliance with a damaged cord or

plug or after the appliance malfunctions or has been damaged in any manner.

Electrical requirements

Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A.C. (Alternating Current). Should the fuse in the mains plug require changing, a 3 amp BS1362 fuse must be fitted.

The use of any electrical appliance requires the following common sense safety rules.

Please read these instructions carefully before using the product.

• WARNING: Misuse of appliance could cause personal injury.

• Do not use continuously for longer than times stated on page 10.

After using for this length of time, allow to cool for 60 minutes.

• This appliance can be used by persons with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge, if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.

• Children shall not play with the appliance.

• This appliance shall not be used by children.

• Keep appliance and cord out of the reach of children.

• Avoid touching moving parts. Keep hands, hair and clothing, and

utensils away from the Prepstar attachments during operation, to prevent personal injury and/or damage to the appliance.

• Switch off the appliance and disconnect from the supply before

changing accessories or approaching parts that move in use.

• If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

• Unplug from the outlet when not in use, or when left unattended,

and before assembling, disassembling or cleaning.

• For care and cleaning refer to page 10.

Health And Safety

FP401012 MUK Rev3.qxp_Layout 1 31/08/2018 11:43 Page 2

Health And Safety .........................................................................

Introduction ...................................................................................

Product Overview .........................................................................

Accessories Overview .................................................................

Compact For Storage ...................................................................

In Use .............................................................................................

Speed Dial Function .....................................................................

Pulse Function ..............................................................................

Before First Use ............................................................................

Unpacking From Storage .............................................................

Reassembling For Storage ..........................................................

Assembly For Use .........................................................................

Usage .............................................................................................

Quick Cleaning .............................................................................

Recipes ..........................................................................................

Chopping Blade Recipes .............................................................

Beater Recipes .............................................................................

Whisk Recipes ..............................................................................

Grater Disc Recipes .....................................................................

Notes ..............................................................................................

Guarantee ......................................................................................

Contents

hank you for purchasing your new Morphy Richards Prepstar Food Processor.

Prepstar will help you take care of all your daily food preparation tasks, slicing, s

hredding, chopping, beating, whisking and grating food in seconds, making

meal preparation quick and easy.

repstar will not only save you time in the kitchen, but save space in your

kitchen cupboards due to its space-saving design.

The unique design allows all the accessories to be stored inside the appliance f

or compact, easy storage.

Please read the instructions thoroughly before use.

Remember to visit morphyrichards.co.uk to register your products two-year guarantee.

Introduction

12 - 21

24 - 25

26 - 27

FP401012 MUK Rev3.qxp_Layout 1 31/08/2018 11:43 Page 3

Features

(1) Start/Stop Button (2) Cord Clip (3) Speed Dial (4) Motor Unit (5) Motor Unit Locator (6) Bowl Lid (7) Food Pusher (8) Food Chute

(9) Drive Shaft (10) Storage Bowl (11) Mixing Bowl (12) Mixing Bowl Spindle (13) Grater Disc (14) Grater / Slicing Blade Holder (15) Grater Disc Adaptor (16) Grater Blade

(17) Slicing Blade (18) Fine Grater Blade (19) Beater (20) Chopping Blade (21) Whisk (22) Instruction Cards

Product Overview

16 17 18

19 21 2220

151413

FP401012 MUK Rev3.qxp_Layout 1 31/08/2018 11:43 Page 4

Accessories

(9) Drive Shaft (10) Storage Bowl (13) Grater Disc (14) Grater / Slicing Blade Holder (15) Grater Disc Adaptor (16) Grater Blade (17) Slicing Blade (18) Fine Grater Blade

(19) Beater (20) Chopping Blade (21) Whisk (22) Instruction Cards

Accessories Overview

Whisk stores on the underside of the Storage Bowl

FP401012 MUK Rev3.qxp_Layout 1 31/08/2018 11:43 Page 5

Compact For Storage

In Use

With the Power Cable facing away from the Food Chute

(8)

, align the lower grooves on the Motor

Unit

(4)

with the matching indents on the Motor

Unit Locator

(5)

and gently lower into the Mixing

Bowl

(11)

. Twist clockwise once in place to lock.

With the Power Cable facing away from the Food Chute

(8)

as shown above, align the lower

grooves on the Motor Unit

(4)

with the matching

indents on the Motor Unit Locator

(5)

and gently

lower into the Mixing Bowl

(11)

. Twist clockwise

once in place to lock.

FP401012 MUK Rev3.qxp_Layout 1 31/08/2018 11:43 Page 6

Speed Dial Function

Pulse Mode

• Set the Speed Dial (3) to the ‘P’ position, then, press and hold the Start/Stop Button (1).

• The unit will pulse at the max speed setting until the Start/Stop Button (1) is released.

• Use the Pulse Mode when sudden bursts of speed are required.

• Good for chopping sparsely to maintain a chunky consistency, eg. for Salsas etc.

• Ideal for use with the Chopping Blade (20).

• Not recommended for use with the Grater Disc (13).

Speed Settings

• Set the Speed Dial (3) to the desired speed setting (1-6) and press the Start/Stop Button (1) once to

turn on.

• Once in use, you can cycle through the speed settings by turning the Speed Dial (3) without having to

press the Start/Stop Button (1) again.

• To turn off the unit, press the Start/Stop Button (1).

NOTE: Turning the Speed Dial (3) to the ‘P’ position whilst in use stops the unit. The Start/Stop Button (1) must be held down to use the Pulse Mode.

FP401012 MUK Rev3.qxp_Layout 1 31/08/2018 11:43 Page 7

Before first use, carefully unpack your Prepstar F

ood Processor and its attachments and remove

ny package material, labels or stickers.

ARNING: Sharp blades.

Clean all the parts except the Motor Unit

(4),

ollowing the instructions on page 10.

AUTION: Handle the blades with extreme

are as they are sharp.

Before First Use

Place the Bowl Lid (6) onto the Mixing Bowl (11), aligning the grooves and twist clockwise to lock. Insert the Motor Unit (4) so that the power cable is facing away from the Food Chute (8) and twist clockwise to lock.

Then lift out the Motor Unit (4).

Unpacking From Storage

3 4

1 2

Reassembling For Storage

Twist the Bowl Lid (6) anti-clockwise to unlock, then lift.

Lift off the Grater Disc (13) from the Storage Bowl (10), and pull the Storage Bowl (10) out from the Mixing Bowl (11). The Whisk (21) is located underneath the Storage Bowl (10).

When reassembling, make sure to align the grooves of the Mixing Bowl (11) and Storage Bowl (10), then slide the Storage Bowl (10) into the Mixing Bowl (11).

Twist the Motor Unit (4) anti-clockwise into the unlock position ( ).

FP401012 MUK Rev3.qxp_Layout 1 31/08/2018 11:43 Page 8

Place the Drive Shaft (9) with Grater Disc (13) onto the Mixing Bowl Spindle (12). Add the Bowl Lid (6) and Motor Unit (4) as described in the ‘In Use’ section on page 6.

Lock the Drive Shaft (9) in place when in the accessory by twisting it clockwise to attach to the accessory.

Unlock and remove the Drive Shaft (9) by twisting it anti-clockwise and pulling it away from the base of the accessory.

Assembly For Use

Push the Drive Shaft (9) up through the base of the relevant accessory: Beater (19); Chopping Blade (20); Whisk (21).

WARNING: The Chopping Blade (20) is very sharp.

Place the Drive Shaft (9) with locked accessory onto the Mixing Bowl Spindle (12). Add the Bowl Lid (6) and Motor Unit (4) as described in the ‘In Use’ section on page 6.

Alternatively, if using the Grater Disc (13), clip the relevant Grater Blade (16/17/18) into the Grater Disc (13). To remove, press down on the latch and push the back of the Grater Blade

(16/17/18).

WARNING: The Slicing Blade is very sharp.

The Grater Disc Adaptor (15) locks into place with the Grater Disc (13) in the same way that the other accessories lock onto the Drive Shaft

(9) in step 2. Once locked into place, place on

top of the Drive Shaft (9).

FP401012 MUK Rev3.qxp_Layout 1 31/08/2018 11:43 Page 9

+ 19 hidden pages